OpenVox UC501 User manual

OpenVox Communication Co Ltd
UC501 IPPBX Quick Start

Information
Access to data
Please visit www.openvox.cn, and select the product model, get the
latest support information, including datasheet and user manual.
Technical Support
For help, contact OpenVox Communication Co., Ltd. Technical Support:
Email: [e-mail]
Tel: [phone]
Fax: [phone]

UC501 Quick Start
Packing Details
After unpacking, check if the contents are complete. If there are any
omissions, please contact your dealer.
⚫UC501 x 1
⚫Network Connection x 1
⚫Power Adapter x 1
⚫Rubber Mat x 1
⚫Certification x 1
⚫Quick Start x 1
Hardware Specification
A. Front
①Power Indicator ②System Indicator ③Reset Button ④
Microphone ⑤Speaker ⑥TF Card Slot ⑦USB Interface ⑧WAN
Port ⑨LAN Port ⑩FXO/FXS Interface

LED Indicator
Color
Status
①Power Indicator
Always Green
Supply Power
②System Indicator
Green and Flash(1s)
Work Normally
⑩Module Indicators
(FXO)
Red and Flash(1s)
Normal
Always Red
Connected
Red and Flash(0.1s)
Communicating
⑩Module Indicators
(FXS)
Always Green
Normal
Green and Flash(0.1s)
Communicating
During initialization, all LED indicators will flash successively
B. Back
①Power Input: DC 12V

Install Module
After confirming the components are complete, start installing modules.
1. Unscrew the screws on both sides of the device.
2. Remove the upper casing in the direction shown in picture.

3. Below is the top view of the inside of the chassis, and the right side is
the module installation area. The upper area is for the FXO-100/FXS-100
module and the lower area is for the FXO-400/FXS-400 module. It should
be noted that the module cannot be installed on the left or right side at
the same time, only supports ①+②, ③+④, ①+④, ②+③.
3. Remove the screw and install the module(③+④mode).

Remove the screw and install the module(②+③mode).
4. After installing the module, insert the chassis vertically as the picture
shows, fasten it to the upper case, and then tighten the screws.

Cable Connection
Please use the dedicated power adapter. Otherwise, the failure or damage
caused by other power adapters is not covered by the warranty.
①Connect the LAN port to the LAN switch using a network cable.
②Use the dedicated power cable and turn on the power, the UC501
system starts, and the power indicator is green.
③Connect the FXS connector to the analog phone using a telephone line.
④Use a telephone line to connect the FXO interface to the PSTN line or
the internal line of legacy PBX.
Note: Please connect the PSTN line or analog phone to the corresponding
interface according to the color of the interface indicator.

Login administrator interface
1. Connect the computer to the same network with the UC501 device;
2. Open a web browser and enter the default IP address of UC501:
172.16.101.1;
3. Use the default username(admin) and password(admin) to log in to the
administrator interface.