OPPLE LEDSmart-BLE2-Rc-MW-Sensor User manual

250054061001
04-08-2022
LEDSmart-BLE2-Rc-MW-Sensor
37 9
For safe connection make sure to use a 2-way terminal block
outlet box that conform to EN60998-2-1 or EN60998-2-2
(450V, 5A, 0.75-2.5mm ).
2
0.75
821006001800
96 6464 15
H1
H1
0.185kg
RY-IOT-SSR-MW-BLE

H
R
LED Indicator
8h
Reset method
Method 1:
Remark
Microwave frequency:5.8GHz+/-75MHz, Microwave power＜1mW
Radio Frequency Interface Requirements – Related to European installation
Note: This equipment has been tested and found to comply with the limits for a EN 300 440 v2.1.1 receiver Category 3.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment is sensitive to other equipment that intentionally generates, radio frequency energy in the 5725~5875MHz that
may conduce to the instability to the product. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment suffered from the harmful interference from another radio device to radio this can be determined by
turning the respective equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Turn off the disturbance equipment
- Increase the separation between the disturbance equipment
- Consult the dealer or an experienced radio / TV technician for help
Detection Range
5
400ms.
Opple Lighting BV
Meerenakkerweg 1-07
5652 AR Eindhoven
The Netherlands
+10dBm