Opticon H-32 User manual

H-32 User Guide

WINDOWS EMBEDDED COMPACT 7

Version 1.00

Opticon Sensors Europe B.V.

USER GUIDE

H32 User Guide

All the information in this document is subject to change without notice.

This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any

electronic or machine readable form without prior written consent of Opticon.

Limited Warranty and Disclaimers

PLEASE READ this manual CAREFULLY before installing or using the product.

Serial Number

A serial number appears on all Opticon products. This official registration number is directly related to the device

purchased. Do not remove the serial number from your Opticon device. Removing the serial number voids the

warranty.

Warranty

Unless otherwise agreed in a written contract, all Opticon products are warranted against defects in materials and

workmanship for two years after purchase excluding batteries. Opticon will repair or, at its option, replace

products that are defective in materials or workmanship with proper use during the warranty period. Opticon is

not liable for damages caused by modifications made by a customer. In such cases, standard repair charges will

apply. If a product is returned under warranty and no defect is found, standard repair charges will apply. Opticon

assumes no liability for any direct, indirect, consequential or incidental damages arising out of use or inability to

use both the hardware and software, even if Opticon has been informed about the possibility of such damages.

Packaging

The packing materials are recyclable. We recommend that you save all packing material to use should you need

to transport your scanner or send it for service. Damage caused by improper packaging during shipment is not

covered by the warranty.

Trademarks

Trademarks used are the property of their respective owners.

Opticon, Inc. and Opticon Sensors Europe B.V. are wholly owned subsidiaries of

OPTOELECTRONICS Co., Ltd., 12-17, Tsukagoshi 4-chome, Warabi-shi, Saitama, Japan

335-0002. TEL +81-(0) 48-446-1183; FAX +81-(0) 48-446-1184

USER GUIDE

H32 User Guide

iii

Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC rules.

Rule 15.21: You are cautioned that changes or modifications not expressly approved by the part responsible for

compliance could void the user’s authority to operate the equipment.

These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference and

2. This device must accept any interference received, including interference that may cause undesired

operation of the device.

FCC RF Radiation Exposure Statement:

For body worn operation, this phone has been tested and meets FCC RF exposure guidelines when used with an

accessory that contains no metal and that positions the handset a minimum of 0.5 cm (0.20 in.) from the body.

Use of other accessories may not ensure compliance with FCC RF exposure guidelines.

USER GUIDE

H32 User Guide

Declaration of Conformity (DOC) with Regards to Essential

Requirements of EU Directives

Brandname: Opticon

Product: PDA H-32

The above mentioned product complies with the essential requirement specified in directives:

2004/108/EC Electromagnetic Compatibility (EMC)

1999/5/EC Radio- and Telecommunications Terminal Equipment (R&TTE)

2006/95/EC Low Voltage Directive (LVD)

2002/95/EC Restriction of Hazardous Substances (RoHS)

2002/96/EC, 2003/108/EC Waste Electrical and Electronical Equipment (WEEE)

Radio products which contains radio transmitters are labeled with, CE 0678, and comply with the R&TTE

Directive (1999/5/EC) issued by the Commission of the European Community.

Compliance with this directive implies conformity to the following European norms (in brackets are the equivalent

international standards).

USER GUIDE

H32 User Guide

Safety Information

General

Please read the following information carefully before you start using this device to avoid any damages caused

by improper usage:

The device is not charged when you take it out of the box. Charge the battery for at least eight hours

before first use. Do not remove the battery while charging.

Do not use batteries which have not been specified by the manufacturer and not qualified with the

system per the standard of IEEE-Std-1725 -2006, as this may present a risk of fire, explosion, leakage

or other hazard.

Do not charge the battery with an unspecified AC Adapter, as this may cause damage to both the device

and the battery.

When discarding the batteries, dispose of them in a proper manner, according to your local laws.

Do not open the device housing or tamper with the device, as it will void your warranty.

Do not apply excessive force on this product, as it may cause damage to the screen or the internal

component.

Do not use the device at gas or refueling stations, chemical plants, and places containing explosives or

flammable materials. Observe local guidelines.

Use only manufacturer specified stylus. Do not scratch the screen with sharp objects.

Do not clean the screen with chemical detergents. Only use cloths specifically designed for cleaning

liquid displays or a soft cloth moisturized with water drops, to wipe the device screen.

Do not expose the device to direct sunlight or leave the device in a humid environment for extended

periods of time as this may cause damage to the device and battery.

Do not immerse the device in water.

The device may interfere with the navigation and/or communication systems on aircraft. The laws of

most countries prohibit using this device while on an aircraft. Observe local guidelines.

This product may cause medical equipment to malfunction. The use of this device is forbidden in most

hospitals and medical clinics. Observe local guidelines.

USER GUIDE

H32 User Guide

Additional Battery Information

Please read the following information carefully to understand battery safety.

Do not disassemble or open, crush, bend or deform, puncture, or shred the battery.

Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to

water or other liquids, or expose to fire, explosion, or other hazard.

Only use the battery for the system for which it was specified.

Only use the battery with charging system that has been qualified with the system per this standard. Use

of an unqualified battery or charger may present a risk of fire, explosion, leakage, or other hazard.

Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.

Battery usage by children should be supervised.

Avoid dropping the H-32 or battery. If the H-32 or battery is dropped, especially on hard surface, and the

user suspect damage, take it to service center for inspection.

Improper battery use may result in a fire, explosion, or other hazard.

Seek medical advice immediately if a battery has been swallowed.

Do not leave the battery where the temperature is 60°C (140°F) or more.

Do not solder lead directly to the battery body.

Do not heat nor solder the terminals of the battery.

Do not charge beyond the condition which described on the delivery specification.

Do not inverse charge the battery.

In the event the Battery Pack leaks and the fluid gets into one's eye, do not rub the eye. Rinse well with

water and immediately seek medical care. If left untreated, the battery fluid could cause damage to the

eye.

Charge the battery at least every six months. An excessive over-discharge may cause an abnormal

chemical reaction, which may result in acid leakage or fire of the battery.

Despite being rechargeable, the battery has a limited life span. Replace it when usage time becomes

short.

Safety of Laser Products: International Standards Laser Class 2

This product complies with JIS C6802: 2005 Class 2, IEC60825 -1+A2: 2001 Class 2 and 21CFR 1040.10 and

1040.11 except for deviations pursuant to Laser Notice No.50, dated June 24, 2007.

Class 2 Laser devices are not considered to be hazardous when used for their intended purpose.

Use of controls, adjustment of procedures other than those specified herein may result in hazardous laser light

exposure. Do not look directly into the light beam with optical instruments; it may pose an eye hazard.

USER GUIDE

H32 User Guide

vii

Document Revisions

Date

Version

Number

Document Changes

24-4-2015

1.00

Initial Draft

USER GUIDE

H32 User Guide

viii

Table of Contents

1 Introduction.............................................................................................................................................................11

1.1 ....Scope and Purpose.......................................................................................................................................................... 11

1.1.1Configuration .............................................................................................................................................................................11

1.1.2Software version ......................................................................................................................................................................11

1.1.3Service Information ................................................................................................................................................................11

2 Getting Started........................................................................................................................................................12

2.1 ....Overview.............................................................................................................................................................................. 12

2.2 ....Unpacking........................................................................................................................................................................... 12

2.3 ....H-32 Detailed View......................................................................................................................................................... 13

2.4 ....Initial setup........................................................................................................................................................................ 14

2.4.1Enable backup battery ...........................................................................................................................................................14

2.4.2Installing main battery ..........................................................................................................................................................14

2.4.3Charging the battery ...............................................................................................................................................................14

2.4.4Charging temperature............................................................................................................................................................15

2.4.5Power on the H-32...................................................................................................................................................................15

3 Using the H-32.........................................................................................................................................................17

3.1 ....Tapping touch screen with the H-32 stylus......................................................................................................... 17

3.2 ....Calibrating the touch screen...................................................................................................................................... 17

3.3 ....Backlight ............................................................................................................................................................................. 17

3.3.1Adjust display backlight timer ...........................................................................................................................................17

3.3.2Adjust display backlight brightness.................................................................................................................................18

3.4 ....Date time............................................................................................................................................................................. 18

3.4.1Set Date and Time zone .........................................................................................................................................................18

3.4.2Change Time sync settings...................................................................................................................................................18

3.5 ....Power scheme ................................................................................................................................................................... 19

3.6 ....Input Panel / Virtual keyboard ................................................................................................................................ 19

3.7 ....Reboot / Reset................................................................................................................................................................... 20

3.7.1Reboot ...........................................................................................................................................................................................20

3.7.2Factory Reset .............................................................................................................................................................................20

4 Power modes and batteries...............................................................................................................................21

4.1 ....Power modes ..................................................................................................................................................................... 21

USER GUIDE

H32 User Guide

4.1.1On ....................................................................................................................................................................................................21

4.1.2User Idle .......................................................................................................................................................................................21

4.1.3System Idle..................................................................................................................................................................................21

4.1.4Suspend state.............................................................................................................................................................................21

4.1.5Off....................................................................................................................................................................................................21

4.2 ....Batteries .............................................................................................................................................................................. 22

4.2.1Checking battery status.........................................................................................................................................................22

4.2.2Main battery pack ....................................................................................................................................................................22

4.2.3Backup battery ..........................................................................................................................................................................22

4.2.4Battery hot swap ......................................................................................................................................................................22

4.2.5Charging the main battery ...................................................................................................................................................22

5 Barcode data capture ...........................................................................................................................................24

5.1 ....Introduction....................................................................................................................................................................... 24

5.1.11D laser scanner .......................................................................................................................................................................24

5.1.22D imager ....................................................................................................................................................................................24

5.2 ....Scanning consideration................................................................................................................................................ 24

5.2.1Range .............................................................................................................................................................................................24

5.2.2Angle ..............................................................................................................................................................................................24

5.3 ....Laser scanning.................................................................................................................................................................. 25

5.4 ....Imager scanning.............................................................................................................................................................. 25

5.5 ....Setup barcode module .................................................................................................................................................. 25

5.5.1Basic Settings .............................................................................................................................................................................25

5.5.2Code Options ..............................................................................................................................................................................27

5.5.3Read Options ..............................................................................................................................................................................28

5.5.4Additional Settings ..................................................................................................................................................................29

5.5.5Barcode Registry settings.....................................................................................................................................................29

5.6 ....Tray Icons ........................................................................................................................................................................... 29

5.7 ....Barcode Software SDK.................................................................................................................................................. 30

6 Wi-Fi and Bluetooth..............................................................................................................................................31

6.1 ....Accessing the Laird Connection Manager ........................................................................................................... 31

6.1.1Status tab .....................................................................................................................................................................................31

6.1.2Configuration tab .....................................................................................................................................................................33

6.1.3Configuration –Bluetooth....................................................................................................................................................35

6.1.4Diagnostic tab ............................................................................................................................................................................37

6.1.5Using the Laird system tray.................................................................................................................................................39

USER GUIDE

H32 User Guide

6.1.6LCM Bluetooth Tray Icon......................................................................................................................................................39

7 Keypad........................................................................................................................................................................41

8 Update OS image ....................................................................................................................................................42

8.1 ....Update by RESCUE DISK .............................................................................................................................................. 42

8.2 ....Update by NAND IMAGE .............................................................................................................................................. 42

8.3 ....Update by UPDATE OS IMAGE .................................................................................................................................. 42

8.3.1Command line options ...........................................................................................................................................................43

9 Troubleshooting the H-32..................................................................................................................................45