Orno OR-SH-1704 User manual

Instruction Manual for
OR-SH-1704, OR-SH-1705
Item No.
Remote receiver
OR-SH-1704
2300W, 230~ 50Hz
433.92MHZ
OR-SH-1705
300W, 230V~ 50Hz
Dimmer (For incandescent lamp)
433.92MHZ
Features
No wiring, easy operation, just plug and use.
Receiver has 5 memory settings, no memory loss forever.
Green LED indicator for POWER ON and PROGRAMMING SETTINGS.
Connections
1. Make sure that the main power disconnect before installation.
2. To Connect the Base as shown in Fig.2 Before installing the into the mounting boxes, make sure there is no wire exposed at the
connection. (ATTENTION: the diameter of wire connect power is at least 0.75mm^2 not exceed 2.5mm^2）。
3. To connect the wires according mark L-OUT L-IN, N, fix the box and fix by the Screws.
Pls note: the base need purchased separately

How to link a code
To start program your transmitter with the receiver
Receiver plugged on power
Bring the transmitter near the receiver, push the self program button on receiver about 3-5 second.
Receiver LED will blink slowly, press transmitter selected ON button
Receiver connected lamp will on-off twice, code is confirmed and LED stops blinking. Learning done!
Press transmitter button ON again to Dimmer.(stop dimming by press ON)
To change or delete the channel
Push the learning code about 3 second, LED will sound slowly,
Press selected OFF button on transmitter, programmed memory is deleted.
Receiver connected lamp will on-off twice for confirmation.
Fault finding
No activation:
Check battery polarity or running out of battery of the remote control
Check code program successful
Warning!
DO NOT OVERLOAD. Do not use in damp places like patios and cellars or near flammable liquids such as solvents or paints.