Oscartek GIA User guide

retain all screws for later and pay attention to
the plastic pin on each screw, screw it until
the screw head
Unscrew the blocks supporting the front
You can now remove the
front
cut front power cable: it will be
reconnected to the new front
be careful not to cut the hot wire under the
flavour tags holder
attention! on each side there are 2 cables:
1 is the hot wire of the flavour tags holder and should
not be trimmed
remove the side panels
unscrew the fixing screws of the
side above)
unscrew the fixing screws of the
side below)
unscrew the fixing screws
of the front on both sides
unscrew the bumpers
remove the bumpers
Cut power cables on either side of the front glass

cut the LED power supply wires that exit under
the tank left side operator)
Pull down the tube and remove it from the
blocks
disconnect the glass side power cable under
the worktop and repeat for the other side
remove the top supporting screws on both sides
Caution: the screws have different lengths. then
each must be repositioned in the respective
position
Long screw
over
Short screw
under
You can now remove the glass top
remove the led cable from the tube
unscrew all the blocks and keep them aside for
later
unscrew the side
from the supports,
making sure to
support it
you can now remove the
sides

screw the new sides on and reconnect the
power supply
Cut the cables coming out from the glass side and apply
the Red female connectors provided with the material
supplied
Repeat on the other side
screw the front support
blocks on the glass sides
Apply the clear adhesive thickness supplied on the
outer rim and top of the glass side
cut the Strip just before the top block
Replace the glass top and screw it to the holes on
the sides, making sure to place the long screw
above and the short one below
Long screw
over
Short screw
under
do not go beyond this point with the
adhesive
on the new glass front supplied we have already
applied the adhesive, so it's ready to be mounted

reposition at venue
the new front
Screw it to the
blocks
reassembled on
the sides
reconnect the front
glass power wires to
the cables cut
before
use the supplied
connectors
Remount the panelling by following
backlinks the instructions to disassemble