Osmond SPIRA User manual

SPIRA - INSTRUCTIONS
1.
SEAT HEIGHT
2. BACK ANGLE
3. SYNCRO LOCK
Lift the lever on the right-hand side
and take your weight off the seat to
raise the height. Remain seated to
lower the height. Release the lever
to lock the seat height.
Take your weight off of the back and
twist the rear knob on the right-hand
underside of the chair to adjust the
angle of the back rest. To angle it
forwards twist clockwise, to angle it
backwards twist Anti-clockwise.
To adjust the angle of the chair,
ensure the left-hand lever is lifted
and lean back to the required
position. To lock the chair, push the
lever down. To reset the angle of
the chair lower the lever lean back
slightly and then allow the backrest
to rise to its original upright angle.
4. BODY WEIGHT TENSION
5. BACK HEIGHT
6. LUMBAR SUPPORT
The resistance of the chair, when
unlocked, can be adjusted to suite
your body weight by turning the knob
on the right-hand side of the seat. To
increase the resistance turn
clockwise, to decrease the resistance
turn anti-clockwise.
To adjust the height of the backrest,
grasp the bottom of the backrest
and raise to the desired height. To
allow the backrest to be lowered
again, raise the backrest all the way
to the top and lower in to position.
As you are sitting on the chair
squeeze the left-hand bulb
repeatedly to inflate the lumbar
support. Press the button on the
bulb to deflate the lumbar support.

7. PELVIC SUPPORT
8. SEAT DEPTH
9. ARMREST HEIGHT
As you are sitting on the chair
squeeze the right-hand bulb
repeatedly to inflate the pelvic
support. Press the button on the
bulb to deflate the lumbar
support.
Push in the button on the
right-hand side and slide the
seat forward or backward.
Release the button to lock the
seat pan.
To adjust the height of the
armrest press the button on the
side of the armrest and lift or
lower to the desired position. The
armrest will lock in to a total of
six different heights.
10. ARMREST WIDTH
Loosen the screw on the
underside of the arm by
turning it anti-clockwise and
move the arm to the desired
width, tighten the screw in an
clockwise direction to lock in
to position.
11. ARMREST ROTATION
12. NECKREST(IF FITTED)
Rotate the arm pad until it
locks at the desired position.
Rotate the cushion up or down
for varying support.