Osprey IPX User manual

Osprey Measurement Systems ospreymeasurement.systems
Connect the IPX to the LS-G6-DIG-2 as follows: Brown: 12V;
Black: G; A: Blue; B: White. Ensure SW A is set to “BATT” and
SW B is set to “HALF”.
Connect your mobile device to the data logger and open the
Worldsensing app. Open the Setup Wizard.
Enter the Modbus Alias for each sensor. If you have
purchased a pre-built string from Osprey, these will be
set as 1, 2, 3…etc. with 1 being the boom sensor.
If your string was not pre-built, or modicaons have
been made, you will need to set the Modbus Alias on
each IPX. Instrucons on how to do this can be found
in the User Guide.
In the Sensor manufacturer tab, select “Osprey”.
In-Place Extensometer (IPX)
Quick Guide – Worldsensing Digital Node
1
2
4
3

Osprey Measurement Systems ospreymeasurement.systems
In-Place Extensometer (IPX)
Quick Guide – Worldsensing Digital Node
See below table for help troubleshoong any other status.
5
Status Byte Osprey error code Descripon Probable Cause Soluon
0N/A Measurement OK Measurement OK Measurement OK
1 -99 No magnet detected within
measurement range
IPX not
posioned correctly
Adjust IPX posion
2 -98 Standard deviaon exceeds threshold TBD TBD
3 -97 Sensor reports an internal error Vibraon Remove sources of vibraon
from sensors
4 -96 Incomplete response from the sensor Insucient power Ensure the logger is equipped
with new baeries
Your device is now congured.
Congure the node radio sengs and measurement frequency.
7
6