Outdoor Revolution Oxygen Speed Annexe User manual

Outdoor Revolution MODEL Oxygen Speed Annexe
Thank you for purchasing an Outdoor Revolution product, this product will give years
of satisfactory service if basic instructions are followed, our products are designed for
durability and for ease of erection.
Replacement tubes can be purchased to replace any items accidentally damaged.
** Annexes will not be swapped because of damaged tubes**
Please read the following instructions carefully
TIP: Refer to the photograph to help when pitching your Annexe.
Please do not leave for your vacation without fully erecting and checking the contents of your
annexe.
Ideally erect your annexe for some period allowing it to weather.
Please make sure that before erecting, that you site the annexe on clear Level ground with no
sharp objects underneath. (We recommend laying a groundsheet down to keep the annexe dry and
clean)
If you have any issues relating to pitching your annexe please contact your dealer for instructions
before going on holiday.
Please note this annexe is designed as a ‘touring’ annexe and not for ‘permanent pitch’
use
IMPORTANT PLEASE CHECK YOUR EQUIPMENT
(Make yourself familiar with the annexe and its parts before attempting to erect)
Contents
Flysheet (or outer)
Pegs in separate bag
ERECTION INSTRUCTIONS.

Outdoor revolution Awnings are all erected outer first
1. Lay the outer/flysheet spread out on the ground. Slacken adjusters off on the black tapes (near the ring
and pin assemblies) around the foot of the awning.
2. Now decide which side of the awning you want the annexe and zip out the relevant panel. Take the
annexe fly sheet and zip in.
3. Once the annexe is attached to the awning on the desired side locate the inflating valve on the outside of
the awning and attach the pump. Before starting to inflate check that the tube is not twisted or caught on
any sharp objects.
4. Now slowly inflate the annexe until a pressure of approx. 2 psi is reached so that there is room for the air
inside to expand.
5. Now guy out the back of the annexe flysheet (using the attached guy ropes) By now the annexe should
now be the correct shape. After this you are now ready to peg the annexe out
6. You are now ready to place the inner tent into position (suspending rear of inner first followed by the front)
from the eyelets on the inside of the flysheet outer
7. Any remaining guy lines can now be fully tensioned and pegged on the annexe, please ensure in heavy
weather that ALL guy lines are used. (Please note that failure to use all the lines may result in your
annexe being damaged)
8. Finally re-check the tube is fully inflated and add extra inflation if necessary (Recommended 2 PSI,
Maximum 4 PSI).
Please note these few points for trouble free camping.
a. After use please you always dry and air the tent before packing away.
b. Any dirt or stains can be removed by brushing or gently washing with warm
water. DO NOT use detergents as this will destroy the waterproofing on the
fabrics.
c. We advise that you DO NOT cook or smoke in this annexe; although the outer
fabric is fire retardant treated it will still melt.
d. Please make sure that you have a good time.
**We highly recommend that you insure your annexe against storm
damage or accidental damage, as the warranty does not cover such
eventualities. The manufacturer is not liable for any damage caused
to the caravan or vehicle because of misuse, incorrect pitching or
extreme weather**
Outdoor Revolution Awnings are distributed by:
Blue Diamond Products Ltd
WWW.Blue-diamond-products.co.uk