www.outdoor-revolution.com
Should you have any concerns or issues regarding the
operation of this product, please contact:
Outdoor Revolution Customer Service helpline:
INSTRUCTIONS & PRODUCT CARE
PLEASE READ THE FOLLOWING INSTRUCTIONS
AND WARNINGS BEFORE USE
INFLATION PORT DEFLATION PORT
POWER ADAPTER PLUG
VALVE NOZZLES
ON/OFF POWER SWITCH
HOW TO INFLATE
HOW TO DEFLATE
IMPORTANT
WARNING!
Power supply must be a vehicle cigarette lighter 12 volt DC.
This pump is intended to inate/deate items such as air mattresses, inatable dinghies, pool
inatables, air furniture etc. It is not designed for continuous use or for high pressure
products such as air tents, air awnings, paddle boards etc.
When using the air pump, please rest for 5 minutes between every 5 minutes of ination and
every 10 minutes of deation to allow the motor to cool down.
Keep the air pump out of the reach of children. It is not intended as a toy.
Do not obstruct the ination/deation port and keep them ventilated all the time. For fast
ination and to shorten the motor’s working time, always use the most suitable adapter
according to the size of the air valve of the inatable item.
Connect the adaptor plug to your vehicles cigarette lighter 12 V DC output.
Join the most suitable adaptor nozzle to the ination port connector.
Connect the nozzle to the valve of your inatable item and switch
on (’-’) for ination and o (’o’) to stop.
The valve of the inatable item should not be obstructed as this
could cause the pump to overheat, causing damage to the pump.
Always ensure that the correct Ination/Deation port is used.
Connect the adaptor plug to your vehicles cigarette lighter 12 V DC output.
Open the valve of the item to deate.
Join the most suitable adaptor nozzle to the deation port connector.
Connect the nozzle to the valve of the item that you wish to deate and
switch on (’-’) for ination and o (’o’) to stop.
The valve of the item to deate should not be obstructed as this
could cause the pump to overheat, causing damage to the pump.
Always ensure that the correct Ination/Deation port is used.
Do not attempt to operate in the event that the electric cable becomes damaged or worn.
Carefully follow the operating instructions outlined in this manual during use.
Never exceed the recommended pressure of item being inated.
Never leave the electric pump unattended whilst the pump is in operation.
Do not use the pump in wet conditions or if the pump is damp.
Never allow sand, small stones or any other small particles to be sucked into the deation port
whilst in operation.
Never look inside or point the ination/deation port or point towards your eyes during use.
Never attempt to put your ngers or any other object into the ination/deation port at any time.
