Outwater Fulterer OI-777 User manual

1.800.631.8375 | www.outwater.com
MOUNTING INSTRUCTIONS
OI-777: Progressive-Action Pantry Pull-Out, Bottom Mount
450 lbs. Capacity with Matching Top Guide
#127 04/26/11 H.S.

Outwater Industries, Inc. assumes no liability for improper installation. Page 2
+OI-777 Progressive-Action Pantry Pull-out Drawer Slide mounts in
cabinet as per drawing 1, 1a and according to the hole locations 1b.
IMPORTANT: It is essential, due to the high weight capacity of 450 lb,
that on the back mounting points M6 thru bolts (DIN 931 or 7985A)
and tee nuts are used (or 1/4”-20).
MOUNTING
HOLE LOCATIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 3
+The Top Guide mounts as per drawing 2, 2a
+The U-Prole of the Top Guide mounts on the pull-out as
per drawing 3, 2a and the hole locations 3b.
MOUNTING
MOUNTING
HOLE LOCATIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 4
+The Adapter mounts on the pull-out as per drawing 4,
1a and according to the hole locations 4b.
+The following adjustments should already be pre-adjusted:
Please check before inserting pull-out unit that the safety clip on
the U-Prole of the Top Guide is open (Illustration A) and the
height-adjustment is all the way down (Illustration B).
Also check that the adapter set screws are backed out far enough
(Illustration B).
+Insert the slide-out unit all the way to the end stop.
+Close safety-clip on the U-Prole of the Top Guide (Illustration A).
Tighten the adapter set screws at the same time adjusting the side
to side position (Illustration B).
+Adjust the height position on the OI-777 as per (Illustration B).
MOUNTING
MOUNTING
HOLE LOCATIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 5
+Do not lubricate any part of the slide at any time!
+Easy-close damping-system. Part# OI-777-EZ
IMPORTANT:
OPTIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 6
Clip springs on the right side clip into place with
piston in closed position only, to avoid piston rod.
Assemble parts as illustrated
1, 2, 3, 4, 5.
Please note that depending on
the load the follower X has to be
adjusted.
CAUTION:
EASY-CLOSE FOR OI-777 MOUNTING INSTRUCTIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 7
adjustment range up/down 1.5mm
length 400 - 650 nach / to +
length 700 - 1100 nach / to -
load cap. nach / to +
EASY-CLOSE FOR OI-777 MOUNTING INSTRUCTIONS