
7ovente.com
Empty the kettle after each use.
Your kettle is fitted with a scale filter to hold back the limescale particles.If
limescale does start to build up please refer to the descaling instructions
on Page 9.
BOIL-DRY PROTECTION
A safety shut-off device will automatically activate should the kettle be
accidentally switched on without any water,or without sufficient water to
cover the element,or if it boils dry.Should the shut-off device be activated,
allow your kettle to cool down for a few minutes before refilling,to permit
this device to reset.
CAUTION
When using your kettle,note that it will get hot when the water is boiled.
Please use the handle to hold the kettle.After the kettle has switched off
automatically (or has been switched off manually)it may need time to cool
down.After 30 seconds,the kettle can be switched on again.
It the kettle ever boils dry,allow 15 minutes to cool before refilling with cold
water.
USING YOUR ELECTRIC KETTLE
Before first use,please follow these instructions:
Remove all packaging materials.
Open the lid of the kettle by sliding down the button on the handle.You
will hear a click.
Fill your kettle to the “MAX”level.Boil.Discard the water.Repeat this
process twice.Since tap water can cause mineral deposits,we
recommend filling your kettle with filtered water.
TO USE YOUR KETTLE
Fill your kettle to the "MAX”level.
Push the lid closed firmly until it locks into position.
Note:The kettle will not switch on if the on/off switch is obstructed or the
lid is open.
Plug in the power base and place the kettle onto it.Then switch the kettle
on by pushing down the on/off switch to the “I”position (the indicator
light will illuminate when the kettle is working).
Once your kettle reaches boiling point,it will switch off automatically.To
re-boil,simply wait a few seconds then reset the on/off switch.
To avoid the risk of scalding,pour slowly and do not over-tilt the kettle.
1
2
3
1
2
3
4
5
6
7
1
2