OVIS 33531U21QU User manual

1
33531U21QU Bed

2
LB
Estimated Time for Assembly
Weight Limitation
Tools Needed
25:00 - 35:00
All necessary tools are included in the package.
450 lbs
( Phillips Screwdriver Not Included)

CAUTION:
PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
3

PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
Bed Parts are shipped inside a compartment
in the back of the headboard.
4

Remove parts from headboard
compartment
PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
5

( L )
( R )
Hardware
Components
1 pc
1 set
1 pc
2 pcs
2 sets
2 pcs
4 pcs
2 pcs
8 pcs
M8X20
J
8 pcs
M6X35
K
6 pcs
M6X50
L
4 pcs
M6X60
M
24 pcs
M4X32
N
8 pcs
M6
O
6 pcs
M6
P
1 pc
M4
Q
1 pc
M5
R
QUEEN BED
2 rolls
DO NOT SLIDE BED AFTER
ASSEMBLY. LIFT THE BED FRAME
INTO ITS FINAL POSITION.
CAUTION:
( L )
( R )
4 pcs
T
PACKAGE CONTENT
6

1.
6 pcsM6X50
A ach “P” washers to “L” bolt.
Connect the leg “B” to back of headboard “A”.
Use the bolts to a ach.
+P
L
( L )
( R )
7
P
L
Q

2.
8

J
R
8 pcs
M8X20
Thread “J” bolts into the holes
in the headboard and footboard.
Do not ghten. These will be
ghtened in later steps.
J
( L )
( R )
3.
9

K
O
Q
8 pcs
M6X35
+
A ach “O” washers to “K” bolt.
Connect the top and bo om of
each side rail with a “D” side leg.
Use the bolts to a ach.
KO
D
E
E
Same assembly steps to the second set of side rail.
10
4.

R
J( L )
( R )
Hang the hooks at the ends of the side rails
onto the “J” bolts in the headboard leg and the
footboard. Do not fully ghten the “J” bolts.
The bolts will be ghtened in a later step.
11
5.

4 pcs
M6X60
M
M
Aer the slat system is assembled, place the slats
into the frame of the bed as shown next page.
Same assembly steps
to the second roll slat
A ach adjustable leveling feet to the bo om of leg
“ H”. Then assemble the slat system by a aching
the slats to the “I” supports and “H” legs. First,
extend the slats. Then, line up the holes in the
slats with the holes in the “I” supports and the
holes in the tops of the “H” legs. Use an “M” bolt
through the holes to a ach them together.
T
12
6.

24 pcs
M4X32
N
Then, use screwdriver to
install“N” screws into
side rail cleat
N
Floor line
Leveling
feet
FINISH !
Finally, ghten all “J” bolts.
R
J
Then, adjust slat leveling feet on the bo om of
leg “H” to a distance 1/2" above the floor.
13
7.

FOR ADDITIONAL HELP:
Email our support team: [email protected]o
THANK YOU FOR PURCHASING !
14