OYPLA DIY 4642 User manual

User Manual
Garage Stool
USER MANUAL Model No: 4642

This product is not a toy, and is only to be used for its designated purpose.
Never carry out any alterations or modifications to this product.
Only use this product on stable, level and dry ground.
Always keep your hands and feet away from the immediate working area.
Before using the product, make sure all fastenings are tightly in place and that
everything is in order, and checked periodically.
Leaving this product outside exposed to weather, especially direct sun, rain and
salt air, will speed with the weathering process. This can be slowed by removing
the product from these conditions, or covering it with a suitable cover.
When not in use the lift must be stored in the lowest position n in a dry location.
This product is not intended for use by persons (including children) with reduced
physical, sensory and mental capacities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
product by persons responsible for their safety.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product. Do this regularly to keep the
product clean of any oil or grease.
If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 4642
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

Item No.
Description
Quantity
1
Seat
1
2
Steel Frame
2
3
Screw for Seat
2
4
Nut for Saddle
4
5
Nut for Wheel
4
6
Washer
4
7
Plastic Saddle
1
8
Steel Unit
1
9
Screw for Saddle
4
10
Rear Caster Wheel
4
11
Trasome
2
Assembly Instructions
Parts List:
If you are missing any of the below parts please contact [e-mail]
Please be aware that you will be referring to this parts list throughout the assembly
process.
USER MANUAL Model No: 4642

1) Firstly, as seen on the diagram on the previous
page, push the plastic saddle (7) onto the steel
unit (8) ensuring the holes align. Now take 1 steel
frame (2) and secure it to the plastic saddle and
steel unit, using 2 large screws (9), nuts (4) and
washers (6). Please ensure screws are fully
tightened and see pictures below for help. Repeat
on the other side with the remaining steel frame.
2) Next, attach the seat (1) to the top of the steel
frames (2). Secure in place with the 2 remaining
screws (3), located on the underside of the seat.
You should require allen key for this step. Please
see pictures to help. Red arrows show where the
screws should go.
USER MANUAL Model No: 4642

3) Lastly, take 1 nut for the wheel (5) and 1
wheel (10). As seen on the image, the nut
is at the top and the wheel is at the
bottom. Feed the wheel through the pre-
drilled hole and secure in place using the
nut. Ensure tightly fixed, then repeat with
the remaining 3 wheels and nuts until the
stool is fully assembled. An allen key again
may be required.