Oypla Kids 3494 User manual

USER MANUAL Model No: 3494
3
User Manual

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•Put the scales on a clean, flat table.
•To ensure long life, do not expose the scales to water or extreme heat and cold.
•This product is a high precision electronic weighing device, do not press hard or drop
the scales as this may cause damage.
•If the scales surface is dirty, clean the scales with a soft cloth; do not use any chemical
cleaning agents and do not allow water to penetrate inside the scales.
•If the display value is incorrect, make sure that the batteries are adequately charge and
make good contact with the terminals.
•Replace the batteries if they have been in use for a lengthy period of time and try again.
•Before using the scales, make sure all fastenings are tightly in place and that
everything is in order, and checked periodically by an adult.
•This product is not a toy, and is only to be used for its designated purpose.
•Never leave baby unattended when using the scales.
•Do not carry out alterations or modifications to this product.
•If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 3494
3
Please retain a copy of all instructions for future consultation.

Specifications
These scales are equipped with a high precision ‘strain gauge’ sensor and a high-performance CPU (Central
Processing Unit) to ensure weighing accuracy.
-Maximum Capacity: 20kg
-Minimum Capacity: 10g
-Resolution: 10g
-Tare Function
-Auto Power Off
-Low Voltage Indicator
-Power Source: 2x AA Batteries
-Operating Temperature Range: 10°C –40°C
-Display: LCD
-Environmental Humidity: <80% R.H.
Key Functions
-ON/OFF/TARE key: Power off, Tare
-UNIT key: Select the units of measurement; kg, lb or st
Operation
Remove the scales from the packaging, open the battery cover and install the batteries. Put the scale on a
flat table, making sure that it is stable.
Weighing your Baby
1. Press the ‘ON’ key to turn on the power. “HI” appears in the display to greet you, followed by “0.00”.
2. Press the ‘UNIT’ key to select between kg, lb and st.
3. Put your baby on the scales; the LCD display will show the baby’s weight.
4. Press the ‘OFF’ key for 3 seconds to switch off the scale.
WARNING: Ensure that the scales stand stable on a flat surface before weighing. Make sure that the baby
lies still on the scales.
Using and Installing the Batteries
Use two AA batteries.
Open the battery cover on the back and put the two AAA batteries into the battery holder, making sure the
poles are aligned correctly before closing the battery cover firmly again.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
Environmental Protection
Products bearing the symbol shown above means that used electrical and electronic equipment (WEEE) should not be mixed with general
household waste. For proper treatment, recovery and recycling, please take this product(s) to designated collection points where it will be
accepted free of charge. Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on
human health and the environment, which could otherwise arise from inappropriate waste handling. Please contact your local authority for
further details of your nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with
your national legislation.
USER MANUAL Model No: 3494
3