ISSUED FEB 2023
PAG Ltd.
Epsom Downs Metro Centre,
Units 9 & 10, Waterfield, Tadworth
Surrey KT20 5LR, UK
T+44 (0) 20 8543 3131
www.paguk.com
Overall Dimensions (L x W x D):
75mm x 45mm x 33mm
(2.9" x 1.8" x 1.3" approx.)
Weight: 50g (1.7oz.).
Operating Instructions
The MPL USB-C Adaptor is designed to be
connected to the rear D-Tap output of the PAG
MPL99 battery, and is a push fit. The captive
screw aligns with the rear left 1/4” bush, to
secure the adaptor in position.
NOTE: When powering the adaptor using a
single MPL50 V-Mount battery, the adaptor will
protrude from the front of the battery, and it will
not be possible to link another battery to the
battery’s front, without first removing the
adaptor.
Connect the device you wish to power to the
adaptor’s output, using the appropriate cable.
Switch-on the adaptor to deliver power. The
device you connect determines the voltage
delivered (see ‘Specification’). NOTE: When
the two grouped QC 3.0 outputs are used
simultaneously, 5V is the maximum that can be
drawn from each of them.
When not in use, switch-off the adaptor to
avoid drawing power from the battery.
Servicing and Repairs
IMPORTANT: Refer all servicing or repairs to
qualified servicing personnel. The PAG MPL
USB-C Adaptor contains electronics that do
not require periodic maintenance, and
consequently there are no user-serviceable
parts inside.
Unqualified personnel should not open the
MPL USB-C Adaptor since this will invalidate
the guarantee.
Seek advice from PAG Ltd. by contacting
