
Copyright Palomar Engineers®, Inc., 1965-2023
Palomar-Engineers.com
Typical Configuration
Installation
For best results raise the Bullet matching unit as high as possible (use a tree or vertical
support) and then extend the antenna wire horizontally or as an “L” (horizontal with vertical
end drop). The antenna may also be deployed as a sloper with the Bullet matching unit at the
top (best) with the wire sloping toward the ground (with the end high enough to avoid contact
by humans or animals), or at the bottom of the sloper with the antenna wire rising to a higher
point.
Any length of 50 ohm feed line ok (over 25 feet minimum recommended) but longer feed lines
over 50 feet may show reduced SWR on some bands due to soil conductivity, nearby objects,
etc. Due to local ground conditions, antenna height and feed line length, SWR may vary and
an antenna tuner may be required or some bands to bring SWR at end of feed line to
acceptable levels. Position a feed line choke (part# SOFLC) 12 feet from the matching unit.
Use a good quality 50 ohm cable adequate for the power level of your station.The Bullet
matching unit is rated for 500 or 1500 watts PEP (depending on model) for SSB and 50% for
CW or digital modes. If the matching unit becomes warm to the touch after transmitting at
high power, reduce the power output or the internal matching unit may become damaged.