PANA FM.22 Product guide

PANA
1
MANUAL BOOK
STAINLESS STEEL
FOOD TROLLEY
PANA FM.22

PANA
2
User Manual
DEALER: This manual MUST be given to the user of the product.
USER: BEFORE using this product, read this manual and save for future reference.
STAINLESS STEEL
FOOD TROLLEY
PANA FM.22
1. General
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe practices which
could result in
personal injury or property damage. See the information below for definitions of the
signal words.
WARNING
Warning indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
!IMPORTANT
Indicates a hazardous situation that could result in damage to property if it is not
avoided.
Gives useful tips, recommendations and information for efficient, trouble-
free use.

PANA
3
2. Safety Information
Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use.
Contact carrier/dealer for further instruction.
2.1 Weight Limitation
The weight limitation of the Pana FM.22
2.2 General Warnings
WARNING
DO NOT USE THIS PRODUCT OR ANY AVAILABLE OPTIONAL
EQUIPMENT WITHOUT
FIRST COMPLETELY READING AND UNDERSTANDING THESE
INSTRUCTIONS AND
ANY ADDITIONAL INSTRUCTIONAL MATERIAL SUCH AS OWNER’S
MANUALS,
SERVICE MANUALS OR INSTRUCTION SHEETS SUPPLIED WITH THIS
PRODUCT OR
OPTIONAL EQUIPMENT. IF YOU ARE UNABLE TO UNDERSTAND THE
WARNINGS,
CAUTIONS OR INSTRUCTIONS, CONTACT A HEALTHCARE
PROFESSIONAL, DEALER
OR TECHNICAL PERSONNEL BEFORE ATTEMPTING TO USE THIS
EQUIPMENT –

PANA
4
3. Assembling the SS Food Trolley
For this procedure, refer to FIGURE 1.
ACCESSORIES WARNING :
Pana products are specifically designed and manufactured for
use in conjunction with Pana accessories. Accessories designed
by other manufacturers have not been tested by Invacare and
are not recommended for use with Pana products.
WARNING :
ALWAYS wear safety glasses and use extreme caution when
removing the packing pin from the
column assembly of the overbed table. The column assembly is
spring loaded and will extend
suddenly when the packing pin is removed. Serious injury or
damage can occur.
After any adjustments, repair or service and before use, make
sure that all attaching component
parts are secure.

PANA
5
INDEX Using the SS Food Trolley
INDEX
1. Introduction
2. About this Product ; Trolley Features:
3. Product Description
4. Specifications
5. Safety
6. Installation
7. Operation
8. Maintenance & Cleaning
9. Warranty & Service
1. INTRODUCTION
About this User Manual
This user manual contains instructions for the proper and safe use of the trolleys, and
for patient & user safety and comfort, which has to be strictly followed.
This User Manual has to be read and followed by every person using or handling these
trolleys. In case of any query, kindly contact Midmark India Pvt. Ltd.
2. ABOUT THIS PRODUCT
•The Food Trolley is used to carry patient tableware and other disposable items
needed for hospital patient use to help supply food.
• Stainless Steel Shelf in the Food Trolley is used to store fast food, or warm water
needed for patients.
• This trolley is a non-invasive medical device used for hospital equipment utilities to
assist and support them in supplying food.
• These trolleys are manufactured and supplied under non-sterile conditions for use
in a typical hospital environment.
• All types of trolleys are used to provide assistance and support to hospital staff or
nurses

PANA
6
Trolley Features:
• Anti-corrosion and easy to clean Durable,
• Silent and stable casters Bright and smooth surface• Be an essay to assemble
yourself
3. PRODUCT DESCRIPTION :
Application Neutral trolley for meal distribution.
Exterior
Top cover:
Push handles: ergonomic and in an impact-proof
position.
Case: Stainless steel with impact resistant and easy to
clean .
Doors: standard 2-
door version with a 270° opening
angle. Perimeter bumpers made of high-density
polyethylene.
Upper Box: Stainless steel and high thickness impact
resistant and easy to clean..

PANA
7
Interior
Stainless steel tray holders.
Stainless steel chamber separation wall.
Completely washable including in a washing tunnel.
Doors
Made of a stainless steel profile treated with high
thickness anodic oxidation.
270° opening angle with magnetic door clamping
system in the opened position.
Door closure with key and optional loops for security
seal.
Box (optional)
Made of stainless steel treated with high thickness
anodic oxidation.
stainless steel door with gas spring easy opening.
Integrated lock closure.
Materials
Stainless steel
Shell, door profiles, upper
box (optional).
PE (Polietilene)
Lower and upper bumpers,
centring pins for thermal
container arrangement.
Stainless steel
Trays and drip tray holders
for cup packaging
(optional).
Stainless steel
door with
gas spring easy opening.
Integrated lock closure.
4. SPECIFICATIONS :
• Construction:
Made of stainlees steel pipe
• Finished:
Stainlees steel
• Step:
There are 16 shelves
One side-opening doors, with a key
Four 5” wheels with locks
• Dimension:
H 1279 mm x L. 499mm x W. 499 mm

PANA
8
Usage, Storage and Transport
Temperature : -1O° C to 50°C
Relative Humidity : 0% to 95% non-condensing
Atmospheric Pressure : 800 to 1060 hPa
Altitude : < 200Qm
•Patient
A patient is a person who is ill, infirm, disabled, or in need of medical assistance
5. SAFETY :
In this User Manual, the following safety symbols are used
Danger: This symbol will appear wherever safety instructions are designed
to protect people from
physical harm. The symbol stands for imminent danger of death or serious
injury
Caution: This symbol will appear where situations are described, which
might be dangerous,
and which might inflict slight injuries.
Advice: This symbol will appear in front of additional helpful pieces of advice
•dot in front of the text implies the action that is required to be taken.
Safety Instructions
•Always use original accessories that have been designed and approved for use with
the trolleys
•Ensure that the trolleys is assembled and installed following the instructions given
in this user manual (wherever required)
•Restrict child visitors without proper attendants. Supervision is necessary to avoid
any mishap due to unintended movement of the trolleys
•Ensure that this trolleys is moved on a smooth steeples floor without any
obstructions in its path, to prevent any inconvenience to user and damage to the
ward care accessories and peripherals
•The trolleys is not intended for storing and transportation of bulk material and
patients
•Accessories or any devices used along with the trolleys should be as per its
intended use specified and approved by Midmark India Pvt. Ltd.
•Keep some gap between walls and the trolleys while in a stationary position and
also while moving from one place to another

PANA
9
•Keep the user manual handy with the operator/user for ready reference
The patient should be advised not to sit on edge of any section when it is in extended
fulllength position
6. INSTALATION :
1. Unpack all the components carefully.
2. lf the packing is drenched by rain, water, or other liquids, inform this matter to
the operator
3. Each Trolley is supplied with the following components as per the packing list:
•Stainless steel tubular frame with castors
•Stainless steel shelves
•Stainless steel support tube
•Stainless steel railing rod
•Stainless steel tray holder with SS tray
4. Place both the tubular frame on a flat surface
5. Insert the support tube in the sleeves, and insert the railing rods in the holes
provided in the tubular frames
6. Upright the trolley on its castors and screw both the shelves to the support
tubes, using the screw provided
7. Fix the bowl/bucket/ tray holders (product specific) in the sleeves provided in
the tubular Frame. Lock the holder with a cotter pin provided. Place the bowl/
bucket! tray (product specific) in the respective holders
Notify if any damage has occurred during transportation either to the authorized
agent
Disposal of the packing material waste following the local waste disposal regulations
prevailing
Definition
Operator
Operator is the person appointed by the owner (i.e. clinic, hospital management, etc.)
who will be responsible for the safe operation of this trolley
User
The user is the person who is able to assess the clinical condition of the patient, e.g.
medical specialists, doctors, nursing staff, assistants, etc. Based on their training
experience or through instructions, they have the right to operate the trolley on their

PANA
10
responsibility or to perform work on it and can identify and control possible risks to
the patient and the trolley.
LOAD BEARING CAPACITY
Do not exceed the safe working load mentioned above
7. OPERATIONAL :
•Before putting the trolleys into use for the first time ensure that all the transport
securing devices and packing film are removed
•Clean and disinfect the trolleys before the first time use
•The trolleys should be used on a flat floor
•The force required to move the trolleys from one place to another with/without
patient may vary depending on the flooring conditions
Do not use the trolleys for purposes other than the intended use as it may cause
damage to the patient/equipment
With due consideration to environmental limitation, materials used to make the
device are not affected by contact with any biochemicals or biowaste when used as
per its intended purpose, all materials used in the product and accessories do not
facilitate breeding or growth of bio-contaminants on their own.
8. MAINTENANCE & CLEANING
Maintenance
Each time before putting the trolleys into service the user must check that –
•Lubrication of all the mechanical joints/pins / moving parts / tightening of the bolts
should be carried out at least once in three months, to avoid unnecessary sound
and wear & tear of the Trolleys
•At regular intervals carry out a visual inspection and check for any mechanical
damage (e.g loose I missing rivets, screws, etc.)
•If any damage or malfunction is observed, immediately report this matter to the
operator

PANA
11
•If the trolleys is not in use, it should be stored in a dry and rodent free indoor
environment on a flat surface with a gradient not more than 5 degrees
•If the trolleys is not in use for a long term, it is necessary to conduct a test to check
for functioning and any mechanical damage that may have been caused
•Depending on the usage, certain moving parts may require replacement due to
wear & tear. We recommend timely replacement with original spares for safety and
trouble-free operation
Cleaning & Disinfecting
•The trolleys is not suitable for machine wash or steam cleaning
•Do not use water jet for cleaning
•The trolleys cannot tolerate the influence of strong solvent, basic or alkaline liquids
& caustic agents
•The cleaning agents must not contain any substances which bring about any change
in the structure or adhesive property of the plastic
•The trolleys should be properly cleaned and disinfected to avoid infection and stains
before allotment to a new patient.
•We recommend the use of approved disinfectant and cleaning agents to clean the
trolleys. Take extra care to clean areas that may trap dust or dirt. All detachable
accessories and its component can be cleaned separately
Disposal:
Product and its defective parts especially elements made of plastic, steel, rubber
material should be disposed of following the statutory rules and regulations prevailing
for such disposal

PANA
12
Routine Inspection Check List: Inspection by the User (Recommended Frequency:
Every new allotment but not later than three months)
Checks
Observation
Ok
Not
ok
Description
Of faults
Visual check of the mechanical components
-Main Frame
-
Screws and rivets
are tightened
Damage, Deformation
Missing/Loose
Performance check
of all mechanical
Components
Castors (Product
specific)
Locking, release remove
the cotton thread, hairs,
etc. from the axle
Sign
Result of inspection
Date
Troubleshooting Guide
Problem
Possible causes
Remedy
Castors (Product
specific)
No Braking, No
Movement,
broken
Repair / Replace Castors

PANA
13
9. Limited Warranty & Service
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH LAW
APPLICABLE
TO PRODUCTS MANUFACTURED AFTER JULY 4, 2020.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights
which vary from state to state.
PANA warrants its product to be free from defects in materials and workmanship for
one year for the original purchaser. If within such warranty period any such product
shall be proven to be defective, such product shall be repaired or replaced, at PANA
option with refurbished or new parts. This warranty does not include any labor or
shipping charges incurred in replacement part installation or repair of any such
product. Product repairs shall not extend this warranty coverage for repaired product
shall end when this limited warranty terminates. PANA sole obligation and your
exclusive remedy under this warranty shall be limited to such repair and/or
replacement. For warranty service, please contact the dealer from whom you
purchased your PANA product. In the event you do not receive The defective unit or
parts must be returned for warranty inspection using the serial number, when
applicable, as identification within thirty days of return authorization date.
DO NOT return products to our factory without our prior consent. shipments will be
refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS
ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED
INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO
SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR
DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER
OPERATION, MAINTENANCE OR STORAGE; OR PRODUCTS MODIFIED WITHOUT PANA
WRITTEN CONSENT INCLUDING, BUT NOT LIMITED TO: MODIFICATION THROUGH THE
USE OF UNAUTHORIZED PARTS OR ATTACHMENTS: PRODUCTS DAMAGED BY REASON
OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC CONSENT OF PANA;
PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND PANA CONTROL; PRODUCTS
REPAIRED BY ANYONE OTHER THAN AN PANA DEALER, SUCH EVALUATION SHALL BE
SOLELY DETERMINED BY PANA. THE FOREGOING WARRANTY IS EXCLUSIVE AND IN
LIEU OF ANY OTHER EXPRESS WARRANTIES, IF ANY, INCLUDING THE IMPLIED

PANA
14
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IT
SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESSED WARRANTY
PROVIDED HEREIN AND THE REMEDY FOR VIOLATIONS OF ANY IMPLIED WARRANTY
SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT
PURSUANT TO THE TERMS CONTAINED HEREIN.
PANA SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
WHATSOEVER. THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH
STATE/PROVINCIAL LAWS AND REQUIREMENTS.
Table of contents
Other PANA Commercial Food Equipment manuals
Popular Commercial Food Equipment manuals by other brands

Lotus
Lotus LIBR.ISTR.PC CF110E Installation and operating instructions

Omcan
Omcan RS-CN-0009-PSS instruction manual

BBQ PIT BOX
BBQ PIT BOX BFB-RF S user manual

Bonnet Neve
Bonnet Neve AVENUE User instructions

Frigomat
Frigomat T4S Series Installation, use and maintenance guide

SELMI
SELMI Macchia User and service manual

Schaerer
Schaerer Ambiente 2 quick start guide

Angelo Po
Angelo Po 191TPE Use and installation manual

lancer
lancer Multi-Valve Unit Tower Installation & operation manual

Bartscher
Bartscher Deli-Cool PRO quick start guide

Cres Cor
Cres Cor H138NPSCMQ Series Operating and maintenance instructions

Duke
Duke FWM3-51 100 Operator's and service manual