Panasonic KX-TG2200B User manual

2.4GHz FHSS Cordless Answering System
Model No. KX-TG2200B
Pulse-or-tone-dialing capability
Operating Instructions
Charge the battery for about 8 hours before initial use.
PLEASE READ BEFORE USE AND SAVE.
Contents:
Location of controls 2
Installation 5
Handset battery charge 10
Making/Answering calls with the base unit 11
Making/Answering calls with
the cordless handset 12
Caller ID Service 13
Voice Mail System 13
Automated Attendant System 14
Answering System 15
Listening to messages 16
Important Safety Instructions 17
FCC and other information 19

–2–
Please read IMPORTANT SAFETY
INSTRUCTIONS on page 17 before use.
Read and understand all instructions.
Location of controls
■Base Unit
LINE1 Button and Indicator
LINE2 Button and Indicator
LINE3 Button and Indicator
LINE4 Button and Indicator
CONF (Conference)
Button
HOLD Button
STOP Button
VOICE MAIL Button
INTERCOM/
TRANSFER Buttons
DIGITAL SP-PHONE
(Speakerphone)/HEADSET
Button and Indicator
MIC (microphone)
ANSWER ON Buttons

–3–
■Base Unit
REDIAL Button
BATTERY Indicator
PAUSE/EDIT Button
CALL WAIT/FLASH
Button
FUNCTION Button
EXIT Button
Navigator Key ( , , , )
ENTER Button
CLEAR Button
TONE Button
Antenna
Display
Headset Jack

–4–
■Cordless Handset
Antenna
Display
Headset Jack
CLEAR Button
ENTER/ (Voice Mail)
Button
CONF (Conference)
Button
INTERCOM/HOLD/
TRANSFER Button
Charge Contacts
LINE Buttons
TALK Button
FUNC (Function)/
EXIT Button
TONE Button
REDIAL/PAUSE/
EDIT Button
CALL WAIT/FLASH
Button
Navigator Key
( , , , )

–5–
Installation
■Installing the backup battery in the base unit
A rechargeable Ni-Cd battery works as emergency power during a power
failure. The fully charged backup battery provides the base unit with 20
minutes operation. The battery is charged in the base unit while the AC
adaptor is connected. It takes 10 hours to charge fully.
Install the backup battery in the battery compartment, and close the cradle
cover.
•The battery cannot be overcharged.
■Charger
Attention:
The product you have purchased is powered by a nickel
cadmium battery which is recyclable.
At the end of its useful life, under various state and local laws, it
is illegal to dispose of this battery into your municipal waste
stream. Please call 1-800-8-BATTERY for information on how to
recycle this battery.
CHARGE
Charge Contacts
CHARGE Indicator

–6–
■Connect the handset to the base unit
Handset
■Connect the AC adaptor to the base unit
Raise the antenna.
Power Outlet
(AC 120 V, 60 Hz)
•USE ONLY WITH Panasonic AC ADAPTOR PQLV12.
•The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)
Handset Cord
AC Adaptor
•Use only a Panasonic Handset for the KX-TG2200B.

–7–
■Connecting the telephone line cord to 2 two-line telephone jack
LINE 1
LINE 2
Two-Line Telephone
Jacks (RJ14C)
4-Wired Telephone
Line Cords
LINE 3
LINE 4

–8–
■Connecting the telephone line cords to four single-line telephone
jacks
For this connection, please purchase two Panasonic T-adaptors and two
2-wired telephone line cords.
LINE 1
Single-Line
Telephone
Jacks (RJ11C)
4-Wired Telephone
Line Cords
LINE 2
LINE 3
LINE 4
2-Wired Telephone
Line Cords
2-Wired Telephone
Line Cords
T-Adaptor
T-Adaptor

–9–
■Connecting the AC Adaptor to the charger
•USE ONLY WITH Panasonic AC ADAPTOR TCA1.
•The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
CHARGE

–10–
Handset battery charge
■Recharge
Recharge the battery when:
–" " flashes on the display, or
–the handset beeps every minute while it is in use.
•Clean the charge contacts of the handset and charger with a soft dry
cloth once a month. Clean more often if the unit is subject to grease,
dust or high humidity. If not, the battery may not charge properly.
•If the battery is fully charged, you do not have to place the handset on the
charger until " " flashes. This will maximize the battery life.
•The battery cannot be overcharged.
To power the cordless handset, charge the battery.
Place the handset on the charger for about 8 hours before initial use.
•The CHARGE indicator lights.