Panasonic KX-THA19C User manual

Thank you for purchasing a Panasonic cordless telephone.
Please read this Installation Manual before using the unit and save for
future reference.
For assistance, please call 1-800-561-5505 or visit us at
www.panasonic.ca
This handset is an accessory handset for use with Panasonic base units
KX-TH111C. You must register this handset with your base unit before it
can be used.
This installation manual describes only the steps needed to register and
begin using the handset. Please read the base unit’s operating
instructions for further details.
Charge the battery for 6 hours before initial use.
Expandable Digital Cordless Handset
Model No. KX-THA19C
Installation Manual
PQQX15711ZA DM0806FY0
THA19C(e).fm Page 1 Friday, August 4, 2006 10:49 AM

2
Accessory information
Included accessories
*1 The handset cover comes attached to the handset.
Additional/replacement accessories
Accessory item Quantity
Charger 1
AC adaptor for charger 1
Battery 1
Handset cover*1 1
Accessory item Order number
Rechargeable nickel metal
hydride (Ni-MH) battery
HHR-P104
Corded headset RP-TCA86, RP-TCA91, RP-TCA92, RP-TCA94,
or RP-TCA95
Belt clip PQKE10404Z1
THA19C(e).fm Page 2 Friday, August 4, 2006 10:49 AM

3
Setting up the handset
Connecting the charger
LUse only the included Panasonic AC
adaptor PQLV206.
Note:
LThe AC adaptor must remain connected
at all times. (It is normal for the adaptor
to feel warm during use.)
LThe AC adaptor should be connected to
a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to
a ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to
become disconnected.
Battery installation
1Press the notch of the handset cover
firmly, and slide it in the direction of the
arrow.
2Insert the battery (A), and press it
down until it snaps into position (B).
Then close the handset cover (C, D).
Attention:
A nickel metal hydride battery that is
recyclable powers the product you have
purchased.
Please call 1-800-8-BATTERY (1-800-
822-8837) for information on how to
recycle this battery.
Fasten the AC adaptor cord to prevent
it from being disconnected.
(120 V AC, 60 Hz)
Bottom of
the charger
Hooks
A
BC
D
THA19C(e).fm Page 3 Friday, August 4, 2006 10:49 AM

4
Battery charge
Place the handset on the charger for 6
hours before initial use.
While charging, the charge indicator on the
handset lights in amber. When the battery
is fully charged, the indicator lights in
green.
Note:
LIf you want to use the handset
immediately, charge the battery for at
least 15 minutes.
LTo ensure that the battery charges
properly, clean the charge contacts of
the handset and charger with a soft, dry
cloth once a month. Clean more often if
the unit is subject to the exposure of
grease, dust, or high humidity.
Panasonic battery performance
Note:
LThe handset can be left on the charger
without any ill effect on the battery.
LThe battery level may not be displayed
correctly after you replace the battery. In
this case, place the handset on the
charger and let it charge for 6 hours.
Charge
indicator
Operation Operating time
While in use
(talking)
Up to 4.5 hours
While not in use
(standby)
Up to 7 days
While using the
clarity booster
feature
Up to 3.5 hours
THA19C(e).fm Page 4 Friday, August 4, 2006 10:49 AM

5
Registration
Register the handset to a KX-TH111C
base unit.
1Base unit:
Press and hold {INTERCOM}until the
IN USE indicator flashes.
LAfter the IN USE indicator starts
flashing, the rest of the procedure
must be completed within 2 minutes.
2Handset:
Press {OK}, then wait until a beep
sounds.
Changing the display language
You can select either “English” or
“Français” as the display language.
1{MENU}(centre of joystick) i
{#}{1}{1}{0}
2Select the desired setting. (Default:
“English”)
3Press the centre of joystick to save. i
{OFF}
THA19C(e).fm Page 5 Friday, August 4, 2006 10:49 AM

6
Headset (optional)
Connecting the corded headset
Connecting a headset to the handset
allows hands-free phone conversations.
We recommend using the Panasonic
headset noted on page 2.
LHeadset shown is RP-TCA86.
Switching a call between the headset
and handset speakerphone
To switch to the handset speakerphone,
press {s}.
To return to the headset, press {C}.
Wall mounting
1Drive the screws (not included) into the
wall using the wall mount template as a
guide.
2Mount the charger (A), then slide it
down (B) and to the right (C) until it is
secure.
(120 V AC,
60 Hz)
Screws
25.2 mm
(1 inch)
A
B
C
Wall mount template for the charger
25.2 mm
(1 inch)
THA19C(e).fm Page 6 Friday, August 4, 2006 10:49 AM

7
Specifications
General
Operating environment:
5 °C – 40 °C (41 °F – 104 °F)
Handset
Frequency:
2.402 GHz – 2.48 GHz
Bluetooth®compliance
Bluetooth wireless technology 1.2
Dimensions:
Approx. height 160 mm x width 49 mm x
depth 33 mm (65/16 inches x 115/16 inches
x 15/16 inches)
Mass (Weight):
Approx. 169 g(0.37 lb.)
Power output:
125 mW (max.)
Power supply:
Ni-MH battery (3.6 V, 830 mAh)
Charger
Dimensions:
Approx. height 71 mm x width 88 mm x
depth 99 mm (213/16 inches x 315/32 inches
x 329/32 inches)
Mass (Weight):
Approx. 103 g(0.23 lb.)
Power consumption:
Standby: Approx. 0.17 W
Maximum: Approx. 3.0 W
Power supply:
AC adaptor (120 V AC, 60 Hz)
Note:
LDesign and specifications are subject to
change without notice.
LThe illustrations in these instructions
may vary slightly from the actual
product.
Trademarks
LThe Bluetooth word mark and logos are
owned by the Bluetooth SIG, Inc. and
any use of such marks by Panasonic is
under license. Other trademarks and
trade names are those of their
respective owners.
THA19C(e).fm Page 7 Friday, August 4, 2006 10:49 AM

8
Important safety
instructions
CAUTION:
Installation
LOperating the product near electrical
appliances may cause interference.
Move away from the electrical
appliances.
LThe AC adaptor is used as the main
disconnect device. Ensure that the AC
outlet is installed near the product and is
easily accessible.
LTo prevent electric shock, use only the
audio cable with the transformer
included with your base unit when
connecting the unit to an audio device.
Battery
To reduce the risk of fire or injury to
persons, read and follow these
instructions.
LUse only the battery(ies) specified.
LDo not dispose of the battery(ies) in a
fire. They may explode. Check with local
waste management codes for special
disposal instructions.
LDo not open or mutilate the battery(ies).
Released electrolyte is corrosive and
may cause burns or injury to the eyes or
skin. The electrolyte may be toxic if
swallowed.
LExercise care when handling the
battery(ies). Do not allow conductive
materials such as rings, bracelets or
keys to touch the battery(ies), otherwise
a short circuit may cause the battery(ies)
and/or the conductive material to
overheat and cause burns.
LCharge the battery(ies) provided, or
identified for use with the product only, in
accordance with the instructions and
limitations specified in this manual.
WARNING:
LTo prevent the risk of fire or electrical
shock, do not expose the product to rain
or any type of moisture.
LUnplug the product from power outlets if
it emits smoke, an abnormal smell, or
makes an unusual noise. These
conditions can cause fire or electric
shock. Confirm that smoke has stopped
emitting and contact an authorized
service centre.
NOTICE:
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
Privacy of communications may not be
ensured when using this telephone.
The term “IC:” before the radio certification
number only signifies that Industry Canada
radio technical specifications were met.
RF Exposure Warning:
The product complies with IC radiation
exposure limits set forth for an
uncontrolled environment. The handset
may be carried and operated with only the
optional specific belt-clip. Other non-
tested belt-clips or similar body-worn
accessories may not comply and must be
avoided. The product must not be
collocated or operated in conjunction with
any other antenna or transmitter.
THA19C(e).fm Page 8 Friday, August 4, 2006 10:49 AM

9
Copyright:
This material is copyrighted by Panasonic
Communications Co., Ltd., and may be
reproduced for internal use only. All other
reproduction, in whole or in part, is
prohibited without the written consent of
Panasonic Communications Co., Ltd.
© 2006 Panasonic Communications Co.,
Ltd. All Rights Reserved.
THA19C(e).fm Page 9 Friday, August 4, 2006 10:49 AM

10
Warranty
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3
PANASONIC PRODUCT - LIMITED WARRANTY
Panasonic Canada Inc. warrants this product to be free from defects in material and workmanship and
agrees to remedy any such defect for a period as stated below from the date of original purchase.
Telephone Accessory / Product - One (1) year, parts and labour
LIMITATIONS AND EXCLUSIONS
This warranty does not apply to products purchased outside Canada or to any product which has been
improperly installed, subjected to usage for which the product was not designed, misused or abused,
damaged during shipping, or which has been altered or repaired in any way that affects the reliability or
detracts from the performance, nor does it cover any product which is used commercially. Dry cell
batteries are also excluded from coverage under this warranty. Rechargeable batteries are warranted
for ninety (90) days from date of original purchase.
This warranty is extended to the original end user purchaser only. A purchase receipt or other proof of
date of original purchase is required before warranty service is performed.
THIS EXPRESS, LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
IN NO EVENT WILL PANASONIC CANADA INC. BE LIABLE FOR ANY SPECIAL, INDIRECT OR
CONSEQUENTIAL DAMAGES.
In certain instances, some jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages, or the exclusion of implied warranties, so the above limitations and exclusions
may not be applicable.
WARRANTY SERVICE
FOR PRODUCT OPERATION ASSISTANCE, please contact:
Our Customer Care Centre: Telephone #: [phone]
1-800 #: 1-800-561-5505
Fax #: [phone]
Email link: “Contact Us” on www.panasonic.ca
FOR PRODUCT REPAIRS, please locate your nearest Authorized Servicentre at www.panasonic.ca :
Link : “ServicentresTM locator” under “Customer support”
IF YOU SHIP THE PRODUCT TO A SERVICENTRE
Carefully pack and send prepaid, adequately insured and preferably in the original carton. Include
details of the defect claimed, and proof of date of original purchase.
THA19C(e).fm Page 10 Friday, August 4, 2006 10:49 AM