Panasonic ER-2403 User manual

© 2007 Matsushita Electric Industrial Co., Ltd. All
rights reserved. Unauthorized copying and distribu-
tion is a violation of law.
Order Number SD0708M43CE
Body Hair/Beard Trimmer
Model No. ER2403
ER2405
Middle East
TABLE OF CONTENTS
PAGE PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 9
6 Schematic Diagram ---------------------------------------------10
7 Exploded View and Replacement Parts List -----------11

2
1Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100°F / 600°C).
2 Specifications
2.1. ER2403
2.2. ER2405

3
3 Troubleshooting Guide
3.1. ER2403
3.2. ER2405

4
4 Disassembly and Assembly Instructions
4.1. Disassembly Instructions for ER2403
1. Remove the attachment and the blade.
2. Loosen two housing screws.
3. Remove the housing C.
4. Insert the flat-head screwdriver into the hole of switch
handle and raise it up.
5. Take out the switch cam and the O-ring.
NOTE:
Make sure not to lose them.

5
6. Remove the battery cover.
7. Loosen two screws on top.
8. Take out the housing B.
NOTE:
Make sure not to lose the O-ring.
9. Remove the housing A.
NOTE:
Make sure not to lose two screw O-rings.

6
4.2. Disassembly Instructions for ER2405
1. Remove the attachment and the blade.
2. Loosen two housing screws.
3. Remove the housing C.
4. Insert the flat-head screwdriver into the hole of switch
handle and raise it up.
5. Take out the switch cam and the O-ring.
NOTE:
Make sure not to lose them.

7
6. Loosen two screws on top.
7. Take out the housing B.
NOTE:
Make sure not to lose the O-ring.
8. Remove the housing A.
NOTE:
Make sure not to lose two screw O-rings.
9. Loosen two screws.

8
10. Take out the chassis assembly.
11. Take out the O-ring from the bottom of battery cover.
12. Unhook the terminal base to remove from the chassis.

9
5 Wiring Connection Diagram
5.1. ER2405

10
6 Schematic Diagram
6.1. ER2403
6.2. ER2405