3
Parts identification
(See fig. 1)
AProtective cap with mirror
BOuter blade
COuter blade frame
DInner blade
EFilter
FJoint
GPower switch [0/1]
Slide the switch upward to turn
the trimmer on.
HVent
IBattery cover
Caution
To avoid the risk of personal injury,
follow these instructions:
AKeep this device away from the
reach of children. This is not a toy.
A
Do not insert the trimmer futher into your nostril
or ear hole than the narrow tip of the outer
blade. Do not press the trimmer forcefully.
A
Before each use, check the blades for damage.
Do not use this device if the outer blade frame
or blades are deformed or damaged.
A
The blades have been precision manufactured.
Do not subject them to mechanical force,
impact, drop, etc. Place the protective cap over
the outer blade frame after each use.
AThis trimmer is designed only for
cutting nose hair, ear hair,
eyebrows, moustache, or beard.
Do not use it for any other purpose.
AEnsure that the switch is turned off
before cleaning the blades.
ADo not use solvents or thinners.
Clean with a soft cloth and soapy
water. Wipe dry.
ADo not disassemble,modify or
repair the trimmer yourself.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
Replacing battery
(See fig. 2)
Turn the battery cover counterclockwise and
match the line
a
with
b
Pull to remove.
Insert one AA(LR6) Alkaline battery.
Mount the
battery with polarity as shown. To replace the
battery cover, reverse the above procedure
.
Using your trimmer
Slide the power switch to the “1”
position to turn the appliance on.
<Nose hair and ear hair>
Carefully insert the tip of the outer
blade into your nostril or ear hole to
trim the nose and ear hairs.
<Eyebrows, moustache, or beard>
Place the tip of the outer blade against
the hair (eyebrows, moustache, beard)
you would like to cut. (Press the outer
blade softly so as not to injure your skin.)
Maintenance
Be sure that the switch is turned off before
removing, replacing or cleaning the blades.
To remove the outer blade frame,
turn it and match the line cwith d
and pull upward. (See fig. 3)
Detach the inner blade from the outer blade.
Wipe the blades with a tissue gently to remove
any cut hairs, dust, etc. If the blades are wiped
strongly, they will be deformed or damaged.
Then to remove the filter, turn it and
match the line dwith e.
Shake off the hair clippings.
THE WHOLE UNIT CAN BE
WASHED IN WATER.
DO NOT USE BOILED WATER.
After cleaning, replace the filter, the
inner blade and the outer blade.
If used once a week for approx. 1 min. at a
time, the life of the blades is approx. 3 years.
00-03ER430USA10.7.2210:39ページ3
