Parts identification
(See fig. 1)
AProtective cap
BOuter blade
COuter blade frame
DInner blade
EJoint
FPower switch [0/1]
Slide the switch upward to turn
the trimmer on.
GBody
HBattery cover
For your convenience...
Attach the protective cap
A
to the battery
cover
H
while you trim the nose and ear hairs
.
Caution
To avoid the risk of personal injury,
follow these instructions:
AKeep this device away from the
reach of children. This is not a toy.
A
Do not insert the trimmer futher into
your nostril or ear hole than the nar-
row tip of the outer blade. Do not
press the trimmer forcefully.
ABefore each use, check the blades
for damage. Do not use this device
if the outer blade frame or blades
are deformed or damaged.
A
The blades have been precision
manufactured. Do not subject them
to mechanical force, impact, drop,
etc. Place the protective cap over the
outer blade frame after each use.
AThis trimmer is designed only for
cutting nose hair, ear hair, eye-
brows, moustache, or beard. Do
not use it for any other purpose.
AEnsure that the switch is turned off
before cleaning the blades.
ADo not use solvents or thinners.
Clean with a soft cloth and soapy
water. Wipe dry.
ADo not disassemble,modify or
repair the trimmer yourself
.
This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the appliance.
Replacing battery
(See fig. 2)
Turn the battery cover counter clockwise and
match the line
a
with
b
Pull to remove.
Insert one AA(LR6) Alkaline battery. Mount the
battery with polarity as shown. To replace the
battery cover, reverse the above procedure.
Using your trimmer
Slide the power switch to the “1” posi-
tion to turn the appliance on.
<Nose hair and ear hair>
Carefully insert the tip of the outer blade into your
nostril or ear hole to trim the nose and ear hairs.
<Eyebrows, moustache, or beard>
Place the tip of the outer blade against
the hair (eyebrows, moustache, beard)
you would like to cut. (Press the outer
blade softly so as not to injure your skin.)
Maintenance
Be sure that the switch is turned off before
removing, replacing or cleaning the blades.
To remove the outer blade frame, turn it and match
the line
c
with
d
and pull upward. (See fig. 3)
Detach the inner blade from the outer blade.
Wipe the blades with a tissue gently to remove
any cut hairs, dust, etc. If the blades are wiped
strongly, they will be deformed or damaged.
THE WHOLE UNIT CAN BE
WASHED IN WATER.
DO NOT USE BOILED WATER.
Next, put the inner blade back into the
outer blade. To attach the outer blade
frame to the unit, match the mark
c
with
d
, and turn clockwise until it clicks in.
00-03ER415USA10.7.2211:14ページ3
