Panasonic ES-4001 User manual

Panasonic
Wet/Dry Rechargeable Shaver
Operating Instructions
|
Model
No.
ES4001
(i
|
ee
le E
Before operating this unit, please read these instructions completely.
Thank you for purchasing the Panasonic Wet/Dry Rechargeable Shaver Model No,ES4001

IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appli- including the following:
ance, basic precautions Read all instructions before
should always be followed, using this appliance.
DANG ER To reduce the risk of electric shock:
. Do not install unit where it the shaver and charging
can fall into a tub or sink. adaptor. Always handle with
2. Do not reach for the appli- dry hands.
ance that has fallen into 5. Always charge the shaver
water. Unplug immediately. in a cool, dry place.
3. Do not place or store charg- 6. Except when charging,
ing adaptor where it can fall always unplug the charging
into a tub or sink. Do not adaptor from the electrical
place in or drop into water outlet.
or other liquid. 7. Unplug this appliance
4. Before charging the shaver, before cleaning.
wipe off any moisture from
W ARNIN To reduce the risk of burns, fire, electric
shock, or injury to persons:
. Do not use this shaver with working properly, if it has
a shaving blades been dropped or damaged
and/or foil, as facial injury or dropped into water.
may Occur. Return the appliance to a
2. Close supervision is neces- service center for examina-
sary when this shaver is tion and repair.
used by, on or near children 5. Never drop or insert any
or invalids. object into any opening.
3. Use this appliance only for 6. Keep the cord away from
its intended use as heated surfaces.
described in this manual. 7. Do not use outdoors or
Do not use attachments not operate where aerosol
recommended by the man- (spray) products are being
ufacturer. used or where oxygen is
4, Never operate this appli- being administered.
ance if it has a damaged 8. Periodically inspect the wall
cord or plug, if it is not unit for secure mounting.
SAVE THESE INSTRUCTIONS

Index
ENGLISH Page 6
ESPANOL Pagina 10

Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
itin water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet / Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Charge the shaver for at least 12
hours before using it for the first time
or when it has not been in use for
more than six months.
Parts identification
(see fig. 1)
Protective cap
Outer foil
Outer foil release buttons
Foil frame
inner blades
Foil frame release button
On/Off switch
Switch lock button
Charge indicator lamp
Trimmer
Trimmer switch
Charging adaptor with auto-
matic voltage adjustment
Wall mount
Wood screws
Travel pouch
ose 9800089000908
How to use the wall mount
DANGER - To reduce risk of death
by electric shock, do not install where
the unit can fall into a tub or sink.
The charging adaptor can be hung
on the wall using wood screws (in-
cluded).
1. Select an appropriate location on
the wall where the screws can go
in.
2. Attach the wall mount to the wall,
as shown, with the wood screws,
making sure that the arrow points
up.
3. Slide the charging adaptor
grooves into the wall mount until
it clicks in.
To remove the charging adaptor from
the wall mount, slide the adaptor up-
ward.
Charging
(see fig. 2)
Place the charging adaptor upright
on a flat surface or mount it on a wall.
Piug the adaptor into an AC outlet.
It will adjust automatically to voltages
between 100-120 and 220-240V AC.
In some areas, a special plug adap-
tor may be required.
Switch the shaver to the “0 «charge
position” and place it upright into the
charging adaptor with the switch fac-
ing toward the front.
The charge indicator lamp will glow
red and it will stay on until the shaver
is removed from the adaptor.
You can fully charge the shaver in 8
hours if it seems to be losing speed.
A full charge will supply enough
power for about 7 shaves (three min-

utes per shave for a normal beard).
You can always store your shaver in
the charging adaptor to maintain full
power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for 8
hours if you will not be taking the
charging adaptor with you.
For a better shave
Put a thin layer of shaving foam on
your face which works as a lubricant.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, cream, etc.). Do not put a thick
layer of shaving foam as it may af-
fect the shaver's performance. If the
shaving head is clogged with foam,
simply rinse it under running water.
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (See fig.
3). Start out shaving by applying gen-
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
Using the trimmer
Shaving longer, curly hairs under
the chin (see fig. 4)
Slide the trimmer switch up to the 1st
position. This position makes the
trimmer an intercept cutter, cutting
long hairs while the outer foil shaves
shorter hairs. Make sure that the trirr -
mer is facing outward away from th:
neck.
Trimming sideburns (see fig. 5)
Slide the trimmer switch up to the 2n-
position.
Place the trimmer at a right angle t-
your skin and move it downward tc
trim sideburns.
Cleaning your shaver
(see fig. 6)
For cleanliness and convenience, w-
recommend that you clean you’
shaver with water and a liquid hanc
soap. Regular cleaning will keep you `
shaver in good condition while pre-
venting odors or bacteria from devel-
oping, and maintain the cutting per-
formance.
With the outer foil in place, appl'
some hand soap onto the outer foil
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the outer foil and clean i.
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the oute `
foil to dry completely.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year anc
the inner blade at least every tw
years to maintain your shaver's cut
ting performance.

Replacing the outer foil
(see fig. 7)
Squeeze the outer foil release but-
tons and lift the outer foil upward to
remove it. To insert the new outer foil,
press down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
ATTENTION: The product you
have purchased is powered by a
nickel cadmium battery which is re-
cyclable. At the end of it’s useful
life, under various state and local
laws, it is illegal to dispose of this
battery into your municipal waste
stream. Please call 1-800-8-BAT-
TERY for information on how to
recycle this battery.
S
UB
How to remove the built-in re-
chargeable battery (see fig. 9)
The procedure described below is in-
tended only for removal of the re-
chargeable battery for the purpose
of proper disposal.
WARNING: Do not attempt to re-
place the built-in, rechargeable
battery yourself for the purpose of
reusing the shaver. This could re-
sult in the risk of fire or electric
shock. Please contact your near-
est authorized Panasonic service
center.
1. Remove two screws (a) and bot-
tom cover (b).
2. Pushthe chassis out of the hous-
ing.
3. Remove the battery from the
chassis.
Caution
e Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
e Use only the included shaver
charging adaptor RE3-82 to charge
the ES4001 shaver.
¢ The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
* Dry the shaver completely before
setting it in the charging adaptor.
e Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
» The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-

ing adaptor for a few minutes and
check again to make sure that it is
being charged.
Do not place any metal objects like
coins and paper clips on the charg-
ing adaptor as they will become
warm.
Grip the plug when disconnecting
the charging adaptor from a recep-
tacle; tugging on the cord may dam-
age it.
Store the charging adaptor and its
cord set in a dry area where it will
be protected from damage.
The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
Do not take the housing apart as
this can affect the watertight con-
struction.
Specifications
Power source: 100-120/220-240V
AC, 50-60 Hz (Automatic voltage
conversion)
Motor voltage: 1.2 V DC
Charging time: 8 Hours
This product is intended for house-
hold use only.
READ ALL INSTRUCTIONS BE-
FORE USE.
Service-Assistance-Accessories
800-338-0552
dadas dell id

IMPORTANTE PARA SU SEGURIDAD
Al usar un aparato eléctrico, do las siguientes:
siempre se debe tomar ciertas Lea todas las instrucciones antes
precausiones básicas, incluyen- de usar este aparato.
PELIG RO Para evitar descargas eléctricas:
. No intente la unidad donde 4. Antes de cargar la afeitadora,
ds caer en una bañera o
hundirse.
. No coja el aparato que haya
caído al agua. Desenchufe
inmediatamente.
. No coroque ni guarde el adap-
tador de carga donde pueda
caer en una bañera 0
hundirse. No lo coloque ni lo
arroje al agua ni en ningún
otro líquido.
ADVERTENCIA
. No use esta afeitadora con
B dañadas, ya que esto
podría causarte daños.
. El uso de esta afeitadora en
niños o inválidos, o cerca de
ellos, requiere de una acuciosa
supervisión.
. Use este aparato solamente
para el fin que ha sido
diseñado, como se describe en
este manual. No use acceso-
rios no recomendados por el
fabrecante.
. NNo use el aparato si el cable o
la clavija están dañados, si el
aparato no funciona correcta-
mente, o si éste se ha caído,
Para sl
descargas e electricas y lesiones personales:
seque bien la afeitadora y el
adaptador. manipúlelos siem-
pre con las manos secas.
. Cargue siempre la afeitadora
en un lugar fresco y seco.
. Excepto durante la operación
de carga, desconecte siempre
el adaptador de carga del
tomacorriente eléctrico.
. Desenchufe este aparato
antes de limpiarlo.
uemaduras, incendios,
está dañado o ha caído al
agua. Lleve el aparato a un
centro de servicio para que sea
revisado y reparado.
. Nunca introduzca ningún tipo
de objetos por las aberturas del
aparato.
. Mantenga el cable alejado de
las superficies calientes.
. No use la afeitadora al aire libre
ni en lugares donde se estén
usando productos tipo aerosol
(pulverizadores) o donde se
esté administrando oxígeno.
. Inspeccione periódicamente la
unidad de la pared para man-
tener un montaje seguro.
CONSERVE ESTAS INSTRUCCIONES