Panasonic TX-P60ZT60E Service manual

Confidential
ABG CY EFL ILT MD NL STR 
AL BIH CZ EST GB IRL LV MK PSK UA 
AND BY DFGR IS MMN
E
PL SLO 
BCH DK FIN HLMC NRO SRB 
Date
Subject:
Make sure the back cover is properly assembled when handling the TV to avoid permanent damage to
Please see the following pages for examples of the the problem and how to align the back cover
the PDP panel.
SERVICE HINT
TX-P60ZT60E
Model(s) Affected:
PLASMA TV / PLASMA IDTV
Important: Applicable for all repairs on which the back cover has to be removed and re-assembled
USA
bubbles, and/or thin jagged lines appear near the edges of the panel.
The problem can be caused if the back cover is not correctly re-fitted.
Symptom /
Cause:
Micro cracks appearing near the edge of the panel after back cover removal and
Following removing and re-fitting the back cover of the unit, after a period of time micro cracks,
09/09/2013
Warning: DO NOT move, transport, carry or perform any type of handling of the TV without the back cover.
Product Category:
TX-P60ZT65B
re-fitting.
Country Reported
MQMSH0005DG090913REV2Ref No:For Authorised Service Agents Only
Continued …
Remedy /
Method:
Sympto
m
A
luminum Metal Bezel
Back cover fits inside bezel
Correct assembly: The back cover fits inside the cavity on
the metal bezel.
Note: This condition should be all around the back cover
edge.
Side view of section 1 - TOP
Side view of section 2 - BOTTOM
Side view of section 3 -
SIDE
Panasonic 1 of 2 Document No: MQM_SH
Rev: 2.00 DG140612

Confidential
3 - Make sure the back cover perimeter has no deformations, as this may result in bad assembly and possible
SERVICE HINTMQMSH0005DG090913REV2Ref No:For Authorised Service Agents Only
Notes:
• Not following these indications may cause permanent panel damage (glass micro crack). Critical items when
panel damage.
assembling back cover:
2 - DO NOT use material that is out of specification.
1 - DO NOT insert screws to back cover if it is not properly aligned (please refer to sections details).
Make sure back cover is correctly assembled /
aligned before inserting screws, please review
"section 1" for TOP and "section 2" for BOTTOM.
NOTE: DO NOT insert screws if the back cover is
not correctly assembled / aligned as this may
cause damage to panel.
FIT inside - good
FIT outside – NO good (visible bump, hump)
Panasonic 2 of 2 Document No: MQM_SH
Rev: 2.00 DG140612