Panasonic CWFE14CM User manual

Pre-
installation
Notes
This may cause injury
or product failure.
●Donotmodify,
disassemble or repair
this product.
Safety
Precautions
2.
About this
product
3.
Mounting bracket
Anti-drop metal bracket
Rod
Operation
cord
Rod
supporter
Rod
cap
Operation
ball
Rack
Cover
Arm
component
Anti-drop metal
bracket
Mounting bracket
Side view (closed)
Mounting bracket pitch 900~1000
27
137
40
139
about 2 metres
50mm
10mm
(to the floor)
Curtain
Rail etc
120mm
492
(Up to the rod support tip)
1115
878
956
1708 (Maximum length when both ends are fully extended)
139
(Up to the rod supporter tip)
316
700 (operation cord)
(in use: 900)
Front view (closed)
Plan view (in use) Side view (in use)
△Ceiling
For indoor use only.
Donotinstallin
an entranceway.
1pcs
2pcs
2pcs
Rack (including a rod)
[Where to install is important]
6pcs
●Checktheinstallationpositioncarefully.
Donotinstallnearheatersoranyotheritemtheproductmay
touch while in use. It may cause fire or injuries due to falling.
● Install the rack on an area that will support its weight.
Improper installation may cause injury due to falling.
A drop may cause injury or damage.
●Donotuseotherrodsexceptthedesignatedone.
Install so the operation cord does
not touch curtains.
If If it touches the
curtains,curtains,
the cord is difficult
to pull.
Check the installation position carefully.
trussφ4×30
To install above a curtain box...
Crosspieces for reinforcement are required as is
shownon"Howtoinstall:Ifacurtainrail/boxis,
more than 120mm deep"(contained on back side).
Incaseofinstallingatlowerheight,therodmay
jump out causing injury or the laundry may touch
the floor.
●Usesuppliedscrews.Usespecializedanchorsif
mounting on a concrete wall.
● Donotstandinfrontoftherackwhilepullingtheoperationcord.
The rod may pop out and cause injuries.
Mounting bracket
fixation
screw
Anti drop
metal fitting
fixation screw
Version 2 1410
JH - 55P
'RQRW
GLVDVVHPEOH
CAUTION
0DNHVXUH
WRREVHUYH
)RUELGGHQ
WARNING
0DNHVXUH
WRREVHUYH
Not using the supplied screws may cause injuries due
to falling.
4.
Installation Manual
Wall Mount Drying Rack
Consult with customers to decide where this product should be installed.
Donotinstallaboveaheateror
electric appliances.
Check the height of installation.
(Mount at easy to use height)
Downwardstrokeisabout300mm.About500mm
away from the wall. (refer to dimensions drawing).
Forexample,ifinstalledat2metresheightabove
thefloor(tothebacksideoftherack),therod
should be 1.7 metres above the floor.
Don’tmountthisproductoutdoors(includingbalcony)
or in the bathroom. It may cause functional loss or
damage.
Product number: CWFE14CM
■Dimensions
drawing
(Unit: mm)
trussφ4×40
* Product weight is
approximately 6kg.
Mounting
bracket
Anti drop
metal fitting
2pcs
You must do.
What you may not do.
Indicates a risk of death or serious injuries
Indicates a risk of minor injuries or property
damage.
■Each of these explains what harm and damage may be incurred by incorrect use.
■This following symbols explain what you may and may not do (The following are examples of these symbols)
The following instructions should be followed to prevent injury and damage.
Please follow
these instructions
WARNING
CAUTION
1.
■
Make sure you obtain and read the Owner's Manual carefully to ensure safe use of this product.
To construction companies
To Customers
Thank you for purchasing the WallMountDryingRack.
■ This product is intended for indoor use in residential households.
■ Please refrain from using this product outdoors or in areas such as the bathroom where the product may come
into contact with water.
■ Please read this Owner's manual carefully and make sure you use this indoor Wall Mount Drying Rack
in a proper and safe manner.
■ We shall not be liable for any accidents or damage incurred by installing the product in any manner other than
asprovidedintheseinstallationInstructions,orwithoutusingpartsspecified.Ourwarrantydoesnotapplyto
defects resulting from construction.
■ Make sure to give the Owner's Manual to the customer.
Please ventilate the room (e.g.: ventilation fan,
dehumidifier etc.), as laundry emits humidity.
Humiditymaycausecondensation,ordamagetosomeclothes.
Names of
each part
Packing contents

3DQDVRQLF&DQDGD,QF

$PEOHU'ULYH0LVVLVVDXJD21/:7
3DQDVRQLF&RUSRUDWLRQ
Rack
Mounting
Bracket
Mounting
bracket
Stud (Column)
Stud (Column)
900~1000
Anti-drop metal bracket
Mounting bracket
50 or more
Distance between
the mounting
bracket and the
curtain rail
10
30
10
10
21191921
80
15
Top
Bottom
Fixing bracket
* Do not install the bracket
upside down.
Fix mounting brackets
Same hight between both brackets.
Same hight between both brackets.
Mounting bracket
fixing screw
How to
Install
5.
●Makesuretoinstallthemountingbracketsinlinewithverticalcenterlinesofinner
studs/columns.
●Twomountingbracketsshouldbepositionedatthesameheightagainstthefloor.
(or the rack cannot be installed properly.)
(Unit: mm)
● Fix2mountingbracketswith3screws(trussφ4x40)per
bracket into a stud.
Rack
Mounting
bracket
Rack
check
check
Mounting
Bracket
Operation
ball
①Pull out the rod by fully pulling the
operation cord with the operation ball.
②Tostoretherod,pulltheoperation
cord on the other side. Make sure the
rack closes.
* Donotstandinfrontoftherackwhile
handling the pull cord. The rod may
pop out and cause injuries.
About the rod
*Donotuseotherrodsotherthanthedesignatedone.
How to mount the rod
5RGVXSSRUW
$UP
URG
… Hold the arm component and place the rod on the rod support.
M
ORRVHQ
N
SUHVV
OWLJKWHQ
+RZWRVHW
Press the rack slightly against the
mounting brackets and lower the
rack keeping it level. Hook the
rack on the brackets.
Check that it is securely
attached to the brackets.
How to remove the rod …Holdthearm,thenpushtherodup.
φ5 Anchor
(Anchors not inlcuded)
About 55mm
3. Check the rod operation.
1. Make sure the rack is securely attached to
the mounting brackets (refer to the finished
drawing above).
2. Installing the Rack
Post-
installation
check
6.
●Presstherackslightlyagainstthemountingbracketsandlowertherackkeepingitlevel.Hooktherackonthebracketssecurely.
(mounting strength is important.)
(it is important to attach securely to mounting brackets)
Installation
D0414-1104
① Make a pilot hole using a 5mm drill.
②Hammerinaspecializedconcreteanchorandfixwithscrews.
If a curtain rail/box is more
than 120mm deep
900~1000
More than 10mm
Thickness=A-120mm
Effective digging length
to the base
More than 40mm
A dimension:
Crosspiece
rack
More than 170mm
Sectional
view
(If Ais more than 120mm)
Depth of curtain rail/box
Plaster board
Crosspiece, at least 1116/170 (not included)
Stud/column
Install a crosspiece to avoid the rail. Otherwise
the curtain rail/ box prevents the rod from
moving properly.
* Make preliminary holes with the screws (min 3 screws/crosspiece) which dig more
than40mmintothebasebeforefixing.Donotusedebrisofparticleboards.
Concrete anchor (8 pcs • CWFP099)
Ifinstallingaboveawindow,beforeinstalling,completetheinterior
finishing and installation of curtain rails.
2. Remove the tape from the lid/
operation cord.
(Move the rack back and forth)
Move rack back and forth to ensure it is
securely attached.
3. Installation of anti drop metal brackets
* Be careful not to damage the wall finish.
●Afterinstallingtherack,installtheantidropmetal
brackets on the top of the rack (left and right).
(*Afterinstallation,pleasemakesurethattherack
does not come off)
Stud (Column)
Rack
Anti drop
metal fitting
Fixing screw for
anti-drop metal
bracket(trussφ4×30)
Fix to
the stud
Make sure the
bracket is touching
the rack
*Useaspecializedconcreteanchor,notageneral-purposeone.
● Install the rack on an area that will
supportitsweight.(Donotattach
directly to the plasterboard/ALC)
Improper installation may cause injury
due to falling.
CAUTION
0DNHVXUH
WRREVHUYH
1. Attaching mounting brackets
Set both ends of the
rod before storing the
rack.
Always install the anti drop brackets to
prevent falling.
The rod may collide with the
rack and cause damage.
Always fix the mounting
brackets to inner columns
(studs). Otherwise these
should be reinforced with
alternatives,likecrosspieces.
For concrete walls
(Follow the same steps below for anti-drop metal brackets)
Caution
Caution
Caution
Caution
Caution
Caution
Caution
Rack
Completion drawing