Paradox DB7 Original operating instructions

DB7 Quick Installation with BlueEye application
Locating the DB7
Mount the DB7 near the door to be monitored. Use the angle bracket (purchased separately) if needed
to better supervise the area.
Powering the DB7
*ALLOW 8 hours of charging before full function may be available*
Connect the two power wires (recommend 24/0.20 up to 30 meters) to the 2 screws on the mounting
base of the DB7. These are not polarity conscious so, 12-24 volts AC or DC can be used, minimum
10W power supply.
The DB7 requires 1A and 12 volts at the DB7 connection terminals over the supplied wires. Make
sure the wires support this power. Connecting to the AUX terminals of the alarm panel will not receive
enough current needed for correct operation.
Power Supply
When connecting the DB7 to power for the first time, the battery must be charged at least 60%,
otherwise, not all functions may be available and the DB7 might shut down. Battery indication will be
available in the BlueEye App after about 10 minutes.
Using Existing Doorbell Wires
Existing doorbell wires can be used, but DO NOT connect the DB7 in series with previously installed
bell(s). The DB7 may NOT function after the battery will be drained out due to weak power supply.
- 1 -

Adding the DB7 using Installer Section in BlueEye
Connect to Site 01 Site 01
Press to access Doorbell
configuration screens
Note: For IOS devices, the SSID
needs to be manually entered
-2 -
Important Note
The installer requires a Paradox login so they can access the Installer Menu of BlueEye in order
to generate the QR code of the Wi-Fi, so the DB7 so it can be added to the panel.
While the Doorbell LED is
slowly flashing blue, present
the QR code to the camera.
"Connecting to Wi-Fi, please
wait. When the Doorbell has
connected to the Wi-Fi, the
next screen will be appear:

Picture 1
Picture 2
Picture 3
Doorbell Configuration
Wi-Fi Connection:
It is highly recommended to check that your Wi-Fi access point network is installed properly and
that it does not have overlaps that may seriously affect the quality of connections. Please
download the Wi-Fi Analyzer app, or similar toPicture 1, to scan the Wi-Fi networks (GPS
location should be activated in most apps). Make sure that the Wi-Fi network the DB7 is
connected to is not sharing the same frequency with another network, as per Picture 2. If there
are at the same frequency with another network, as per Picture 3, you must change the channel
frequency in the router as the video performance of the network will be affected.
-3 -

Doorbell LED Indication (May vary from version to version)
Thank you for choosing Paradox Products
-4 -
Marking Site per Regulations
In many countries/counties it is required by law to indicate that the area is video supervised by a
clear notice, by sign, or sticker. If it is required where the DB7 is installed, make sure you comply
with the local regulations.
Green solid Connected to Wi-Fi and Paradox server (MQTT), normal operation
Green flashing Speakerphone call in progress
Red flashing for 1
minute then solid Lost Wi-Fi connectivity
Blue solid Connected to Wi-Fi, No MQTT. Please confirm that the Wi-Fi
network has unrestricted internet access
Blue flashing Indicates QR code scanning mode
Purple solid Firmware upgrading in process
1 year subscription 3 year subscription