Paragon MAKER IDEA BOARD User manual

Thank you for purchasing a MAKER™Idea Board from Paragon Furniture. Enclosed in the box are the various hardware
and components you will need to assemble the product. Review the PARTS LIST below to ensure all the hardware and
components are included before you start assembly. Please follow the steps below in order to ensure your product is
constructed properly.
If you have any questions throughout this process or with your product after set-up, please contact Paragon Furniture
Customer Service at [phone].
MAKER™IDEA BOARD
ASSEMBLY INSTRUCTIONS
1
PARTS LIST
1/4-20 X 40M Joint
Connector Bolt
Qty:4
Upright Left
Qty: 1
Upright Right
Qty: 1
Board
Qty:1

EXPLODED VIEW
ASSEMBLY INSTRUCTIONS
Upright Left Upright Right
Board
2

Position one Upright on length of Board and ax with three Bolts using 5/32 Hex Wrench.
Lay Board horizontal on a at surface.
Pro tip: Elevating Board to waist high assists in the assembly process, but is not necessary.
Place Uprights (Left & Right) on length of Board as shown.
STEP 1
STEP 2
ASSEMBLY INSTRUCTIONS
3

PARAGON, Bolt design, and MAKER are trademarks or registered marks
of Paragon Furniture, Inc. Patents pending. All rights reserved.
©2017 Paragon Furniture, Inc.
L17ASSEMMAKEIDEA
2224 East Randol Mill Road, Arlington, Texas 76011
Toll Free Phone: [phone] • Phone: [phone]
Toll Free Fax: [phone] • Fax: [phone]
paragoninc.com
Ax assembly with three bolts on each side using 5/32" Hex Wrench.
STEP 3
ASSEMBLY INSTRUCTIONS
1/4"-20 x 40M Joint
Connector Bolt
You can now place the
MAKER™Idea Board in its
upright position and use
5/32" hex wrench to
tighten bolts rmly.
NOTE: Hand tighten
bolts rst.
Assembly is now complete.