Paragon MAKER INVENT User manual

Wood Screw
Qty 2
5/32" HEX HEAD WRENCH
Wood Screw
Cross Bar
1/4" HEX BOLT
below in order to ensure your product is constructed properly.
3/8" HEX BOLT 3"
Qty 4
7/32" HEX HEAD WRENCH
#2 PHILLIP'S DRIVER/CORDLESS DRILL
1 1/2"
Qty 4
If you have any questions throughout this process or with your product after set-
ASSEMBLY INSTRUCTIONS
PARTS LIST
Leg Frames Work Surface Qty 1
Upper Shelf
Paragon Furniture Customer Service at [phone]
Qty 1
Lower Shelf
up,please contact
® TM
MAKER INVENT TABLE
Qty 2
Qty 28
PAGE 1
Phillips Pan 5/8" Phillips Pan 1 3/4"
Qty 12
Qty 4
Qty 1
Thank you for purchasing a MAKER INVENT TABLE from Paragon Furniture.
Enclosed in the box are the various hardware and components you will need to
assemble the product. Review the PARTS LIST below to ensure all the hardware
and components are included before you start assembly.Please follow the steps
TOOLS REQUIRED
Top Connecting
Bracket
2018 REV4

Top Connecting
Bracket
Leg Frame
ASSEMBLY INSTRUCTIONS
EXPLODED VIEW
Work Surface
Cross Bars
Upper Shelf
Lower Shelf
Leg Frame
PAGE 2

TOP CONNECTING BRACKETS
PAGE 3
ASSEMBLY INSTRUCTIONS
STEP 1
using 1/4" hex bolts hand tighten
UNTIL AFTER ATTACHING WORKSURFACE.
DO NOT FULLY TIGHTEN HARDWARE
Top Connecting Brackets with the 1 3/4 wood
screws and 3/8" hex bolts. Hand tighten the 3/8 bolts at this time.
Place Work Surface top face down on a clean scratch free surface.
Attach the 2 Leg Frames using 5/8" screws
Attach the 2 Cross Bars and
Connect Upper Shelf
STEP 2

TOP CONNECTING BRACKETS
Install sixteen 5/8 wood screws into the four
using six 5/8"
STEP 4
PAGE 4
ASSEMBLY INSTRUCTIONS
UNTIL AFTER ATTACHING WORKSURFACE.
DO NOT FULLY TIGHTEN HARDWARE
Now go back and tighten all the bolts assembly is now complete turn table upright.
Leg Frames
Top Connecting Brackets
wood screws
STEP 3
Connect Lower shelf to the Leg Frame using eight 1/4" hex bolts hand tighten
Connect Lower shelf to the Panel Flange on both
2224 East Randol Mill Road, Arlington, Texas 76011
Toll Free Phone: [phone] - Phone [phone]
Toll Free Fax [phone] - Fax [phone]
PARAGON, Bolt design, MAKER and INVENT are trademarks or registered marks
of Paragon Furniture, Inc. Patents pending. All rights reserved.
2018 Paragon Furniture, Inc