Parmco T7-6S-4 User manual

Installation
and Operating
Instructions
Model:
T7-6S-4
T7-9S-4
727623112020

Liability under this warranty will not be accepted for:
Subject to updates without prior notice, please visit www.parmco.co.nz for
the latest version. E & O.E. 727626062017

Dear Valued Customer,
Thank you and congratulations on purchasing your new Parmco appliance.
All Parmco products are made to the highest quality and design standards. We are
sure you will enjoy your new appliance.
As a note, please read through these instructions carefully. These will assist you
appliance. Please take special note of all detailed technical information and installation
instructions. It is essential that you follow these instructions to ensure the safety
and reliability of this appliance.
future warranty claims lodged, so please check with Parmco Appliances before any
installation is carried out.
this product or any other products in Parmco’s extensive range, visit us online at
www.parmco.co.nz.
Regards,
The Parmco Team

1
Thank you for purchasing this rangehood. Please read the instructions manual
carefully before you use the rangehood and retain the manual in a safe place for
future reference.
Any installation work must be carried out by a qualified electrician. Before you use
the rangehood, make sure that the voltage (V) and the frequency (Hz) indicated on
the rangehood are exactly the same as the voltage (V) and the frequency (Hz) in your
home.
Functions and Features
The rangehood is made of high quality materials with a modern design, that will
complement your kitchen design.
The rangehood is equipped with a powerful low noise electric motor.
The grease filter is easy to remove and clean.
Schematic diagram

2
Installation
1. The rangehood should be placed at a distance of 65cm above an electric cooktop
or 75cm above a gas cooktop.
2. Cut a hole in the cupboard of 490 × 265mm for model T7-6S-4 and 715 × 265mm
for model T7-9S-4. Make sure there is a minimum 35mm gap between the cutout
edge and the cupboard edge.
3. Take down the filter and remove the four screws on the side panels of the
rangehood.
4. Fix the hood into the cabinet using the screws.
5. Fix the face panel into the body using the screws and reinsert the filter.
6. Ducting no smaller than 150mm is appropriate for these units.
Cut out size for T7-6S-4
Cut out size for T7-9S-4

3
Changing the Light bulb
1. Switch the unit off and pull out the plug first.
2. Wait until the light bulb is cooled down before replacement.
3. Take out the filter and use the screw driver to take out the frame.
4. Replace with same type of bulb (LED 1.5W Max)
Note: Light replacement should be carried out by qualified service personnel only.
•ILCOS D code for this lamp is:DSR-1.5/65-S-64
–LED modules –round lamp
–Max wattage: 2 x 1.5 W
–Voltage range: DC 12V
–Dimensions:

4
How to use the Control Panel
There are five buttons: (Low), (Mid), (High), (Light),
(Power).
1. After connecting to power, indicator light will lit on, all the output close and the
hood will enter standby mode. The indicator light will be off automatically after
reminding if no operation.
2. Power on: Press power button once, its indicator light will lit on, the hood
works at low speed. Indicator light of low speed will be bright. Press power
button again to close it, and its indicator light will be off. All the function
operation of the hood will be closed, the hood enters into standby mode, and run
by circle.
The speed buttons and lamp button can work separately and not controlled by
the power button. When a certain function button is pressed, the hood operates
at that function status. Press power button under any status, the cooker
hood will be switched off without any functions.
3. Press lamp button once; lights will be turn on. Indicator light of lamp button
and power button will lit on. Press lamp button again to turn off
the lights. Indicator light of lamp button and power button will be off.
And recycle like this.
4. Press the (High) button once, motor runs on high speed, the indicator light
of high button and power button will beam. Press high button
again and the motor will stop. Indicator light of high button and power button
will be off,and run by circle.
5. Press the (Mid) button once, motor runs on middle speed, the indicator

5
light of middle button and power button will beam. Press middle button
again and the motor will stop. Indicator light of middle button and power
button will be off,and run by circle.
6. Press the (low) button once, motor runs on low speed, the indicator light
of low button and power button will beam. Press low button again
and the motor will stop. Indicator light of low button and power button will be
off,and run by circle.
7. Low speed, mid speed and high speed cannot work at the same time. When
hood is on high speed, press low speed, it will turn to low speed at once; when it
is in low speed, press middle speed, it will turn to middle speed immediately, and
so on

6
Maintenance
1. The rangehood and its filter mesh should be cleaned regularly in order to keep it
in good working condition. As the grease filters are made of metal, do not clean
the filters with detergents that will corrode metal products.
2. Clean the filters as below:
Method one:
Put the filter in 40⁰C~50⁰C hot water. Pour in some grease-loosening detergent,
soak it for about 2-3 minutes and then clean it with a soft brush. Do not brush
too hard to avoid damaging the filter.
Method two:
Put the filter into a dishwasher with detergent for cleaning. Set the temperature
at around 60⁰C. Be careful not to use detergents that are corrosive to metal
products, that is, most dishwasher powders.
3. To protect the main body from corrosion over time, the rangehood should be
cleaned with soapy hot water or non corrosive detergent once a week. Do not
use grinding detergent as it will damage the body.
4. Keep the motor and other spare parts free from water, as this will cause damage
to the appliance.
5. To remove and insert the filter press on the handle as illustrated below.
Attention
The rangehood uses 220-240V, 50Hz power.
Cut off the power when you clean.
Do not expose the filter to fire or flames.
Do not leave the filter lying around to avoid damage to the filter.
If there is damage to the plug or plug wire, contact a qualified electrician or
professional to replace with the specific flexible wire.

7
Technical Reference
Model
T7-6S-4; T7-9S-4
Rated voltage
220~240V 50Hz
Lighting power
1.5W x 2
Motor power
380W
Duct diameter
150mm
Air flow
1000 m3/h
Warning
Keep your children away from using the rangehood.
Your rangehood is intended for domestic use only. It is not suitable for barbecue,
roast shop or other commercial use.
Any installation work must be carried out by a qualified electrician or professional
person.
The rangehood and its filter mesh should be cleaned regularly in order to keep it
in good working condition.
Before cleaning, always ensure that you have switched your rangehood off.
Clean the rangehood according to the instructions manual and keep the
rangehood from any danger of burning.
Do not dry your rangehood using fire.
If there are any faults with your rangehood, please call the Parmco service
department at 09 573 5678.
Do not exhaust the air from the rangehood through the same flue as the cooktop
or other kitchen appliances.

8
Troubleshooting Tips
If any problem occurs, please remove the plug from the socket and contact Parmco
service department at 09 573 5678.
Problem
Solution
Lights work, but motor does not work
Restart the motor
Call Parmco service department
Lights don't work, motor doesn't work
Call Parmco service department
The body of the rangehood shakes
Remove obstructions in the ducting
Make sure the installation is secure
Call Parmco service department
Insufficient suction
Readjust the distance between the
rangehood and the cooktop
Reduce cross-ventilation or open the
window
Adjust the length of the exhaust pipe
Check the outlet valve is open
Call Parmco service department