Parweld TRCK02 User manual

TRCK02 Adaptor Frame Kit Assembly Instructions Sheet 1 of 3
1
2
6
5
4
3
7 8
Adaptor Kit
Parts List
1) Front Support Frame x 1
2) Rear Support Frame x 1
3) Right Hand Angle Runner
Support x 1
4) Left Hand Angle Runner
Support x 1
5) Right Hand Support
Bracket x 1
6) Left Hand Support
Bracket x 1
7) Water Cooler Mounting
Sleeve x 2
8) Countersunk Socket Head
Screw, M6x25 long x 8
NOTE:
THIS ADAPTOR KIT IS
DESIGNED FOR USE WITH
THE FOLLOWING PARWELD
INVERTER PACKAGES
XTT503AC/DC-P1W
XTT503AC/DC-P1W2

TRCK02 Adaptor Frame Kit Assembly Instructions Sheet 2 of 3
Use 8 off M6 x 25 screws
supplied to secure angle
runner supports
Utilise existing trolley
fixings to secure front
& rear support frames
STEP 1
Inverter support frame assembly
Lower inverter into
position so that the
front of the machine
sits flush with the
outside of the support
frame
Affix water cooler
mounting brackets
using the existing
screws and lifting
eyes on the inverter
cover (note the
slots should be
biased towards the
back of the machine)
STEP 2
Inverter mounting
TR003 trolley
(not supplied
with this kit)
XTT 503 AC/
DC inverter (not
supplied with
this kit)
Assembled inverter
support frame

TRCK02 Adaptor Frame Kit Assembly Instructions Sheet 3 of 3
2 off water cooler
mounting screws
and washers (not
supplied with this
kit)
STEP 3
Water cooler mounting
XTS 905 water cooler
(not supplied with this
kit)
Use the 2 off sleeves
supplied with this kit
They act as support
when the water cooler
mounting screws are
tightened
The complete assembly
should look like this
Assembled water
cooler support
brackets