PAUL ANTHONY Eco Dry H1316 User manual

OPERATING INSTRUCTIONS
MODEL: H1316
Eco Dry
Hairdryer
1600w
NOT FOR USE IN HOTELS, GUEST HOUSES ETC.
FOR HOUSEHOLD USE ONLY

2www.lloytronhelpdesk.com
• 3 Heat / 2 Speed Settings
• Power: 1600w Max.
• Narrow Concentrator Nozzle
• Safety Cut-Off
• Hang-Up Loop
• Quiet DC Motor
thank you
Thank you for the purchase of this quality PAUL ANTHONY product. Used carefully and in accordance with
the instructions enclosed, it should give you trouble free service over a long period of time. Please keep
these instructions for future reference.
FEATURES
SPECIFICATIONS
• Operating Voltage: 220/240v AC 50/60Hz
• Power Consumption: 1600w max
• Ambient Operating Temperature: 5°C to 23°C
Note: Do not operate if ambient temperature is outside this range as this may damage the product.
SAVE THESE INSTRUCTIONS
• Read all instructions carefully
• For Household Use only.
• Not intended for commercial use.
• Only for use indoors.
IMPORTANT SAFEGUARDS AND PRECAUTIONS
DO NOT
Do not use outside or in damp conditions.
DO NOT
Do not use for any purposes other than the appliances intended use.
DO NOT
Do not use if any part of this appliance is damaged in any way.
• Before plugging into mains socket, check whether supply line voltage and current rating are in compliance
with the rated electrical parameters shown on the rating label.
• Keep away from hot surfaces, such as gas or electric hobs and ovens etc

3
www.lloytronhelpdesk.com
• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision
or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
• Children shall not play with this appliance.
• Cleaning and user maintenance shall not be made
by children unless they are older than 8 and
supervised.
• Always unplug when not in use.
• To prevent against the risk of electric shock, do not submerge any part of this appliance in water, unless
advised in this manual.
• This product is not intended to be operated by means of an external timer or separate remote control
system.
• To prevent damage to the power cord, do not let it pass over sharp corners, edges or hot surfaces.
• If the power cord is damaged, do not use. Check before each use!
The supply cord cannot be replaced. If the cord is
damaged the appliance should be scrapped.
WARNING! Do not use this appliance near
bathtubs, showers or other vessels containing
water.
• When the appliance is used in a bathroom, unplug
it after use since the proximity of water presents a
hazard even when the appliance is switched off.
• For additional protection, the installation of a
residual current device (RCD) having a rated residual
operating current of 30mA is advisable in the electric
circuit supplying the bathroom. Ask your installer for
advice.

4www.lloytronhelpdesk.com
DO NOT
Do not touch the scalp when using.
DO NOT
Do not allow the supply cord to come in contact with the heating element during use.
DO NOT
Do not direct aerosols or water sprays into the appliance.
DO NOT
Do not use the hair dryer with wet hands or wet hair.
• Whendryingyourhairinrollers,donotallowanyclips,hairpinsetc.toprojectmorethan10mm(nger
width) so as to ensure that they do not come in contact with the live parts inside the appliance.
• When using clips and hairpins, these may become hot with prolonged drying. It is advised that these are
removed.
WARNING
• Keep the appliance and its cord out of reach of children less than 8 years.
• Should this appliance fall into water, pull the plug out of the wall immediately. Do not place your hand in
thewater.Theapplianceshouldthenbecheckedbyaqualiedelectricianbeforeuseagain!
• The air inlet and outlet openings should never be obstructed.
• Keep your hair away from the immediate vicinity of the air inlet opening.
• Thesafetygrillttedintheairinletopeningisdesignedtopreventhairbeingdrawnin.Ifthegrill
becomesclogged,itshouldbecleaned(e.g.withvacuumcleanerorbrush),asotherwisetheairow
will be obstructed to such an extent that the thermal cut-out will operate.
WARNING – SPECIAL SAFETY CUT OUT DEVICE
Thishairdryeristtedwithaspecialthermalcut-outsafetydevice.
If the product overheats due to a fault then the power will be removed from
the device and the unit will stop working.
Firstyoushouldchecktheunittondthecauseofthefault,ortaketoan
engineer.
Check the fan is operating at full speed and the air inlet is not blocked.
Do not use the hairdryer if fault cannot be resolved.
The safety device is designed so that it will only reset if unplugged for
more than 2 minutes.

5
www.lloytronhelpdesk.com
LOCATION OF CONTROLS
A – Speed Switch
This switch is used to operate the unit. Switch
between off, low and high speeds to operate the fan
motor at different speeds dependant upon the hair
style requirements.
B – 2 Heat Switch
During operation, switch between low, medium and
high heat settings to change the temperature of the
air being output via the fan motor.
C – Concentrator Nozzle Attachment
The removable concentrator nozzle attachment
helps to focus the hot air to a more concentrated
target of hair.
D – Cool Shot Button
During use, press and hold the cool shot button
to change the output air temperature from hot to
cold. Once the cool shot is released, the output air
temperature will revert back to the temperature set
by the heat switch.
E – Hanging Loop
The hanging loop allows for easier storage.
D
E
C
A
B

6www.lloytronhelpdesk.com
OPERATION
GENTLY towel dry hair to REMOVE any excess water. AVOID rubbing hair too vigorously as this could
cause split ends to form. USE a wide toothed comb to detangle hair.
1
BASIC DRYING
CONCENTRATOR NOZZLE ATTACHMENT
The removable concentrator nozzle attachment helps to focus the hot air to a more concentrated target of
hair.
Recommended Settings
Hair Type Airow/Heat
Short & Curly 1
Short & Sculptured 1
Medium & Curly 1
Medium & Sleek 3
Medium & Sculptured 2
Long & Curly 1
Long & Sleek 2
Long & Sculptured 3
PLUG the power cord into a suitable mains supply, ensuring that the speed & heat setting switches
are set TO ‘0’.
2
BEGIN drying hair by SETTING the speed / heat switch to 1increase depending on hair type. USE your
ngersto‘COMB’ through and DIVIDE hair to help dry more effectively.
3
When hair is almost dry all over, SET both the speed and heat switches to the LOWEST setting based
on desired styling.
4
DIVIDE hair into manageable sections and BEGIN brushing from the nape of the neck towards the
scalp, followed very closely by the dryer as you work your way through the hair. CONTINUE this
process in SMALL sections at a time.
5

7
www.lloytronhelpdesk.com
STRAIGHT, SMOOTH HAIR STYLING
CURLY HAIR
BEFORE operating the hairdryer, ATTACH the concentrator nozzle attachment to the hairdryer,
ENSURING that it clips into place SECURELY.
1
USING a large, round brush, BRUSH the hair from underneath.
2
PULL the hair down until the hair is fully extended and taut.
3
SET the speed switch and heat switch to the HIGHEST settings and RUN the hairdryer SLOWLY up
and down the length of the hair SEVERAL TIMES until it is dry.
4
REPEAT this process with all sections of hair until it is completely dry all over.
5
SET the heat switch and speed switch to the LOWEST setting and MOVE the hairdryer quickly around
your head.
1
As the hair is drying, SCRUNCH it using your preferred styling product or TWIRL strands of hair around
yourngerstoadddenition.
2
COOL SHOT
A touch of the cool shot button instantly produces cold air for setting hair and also for professional styling.
Usethecoolshotasanishingtouchtoholdandsetyournewstyle.

8www.lloytronhelpdesk.com
CLEANING AND CARE
MAINTENANCE
The Hair Dryer is virtually maintenance-free. Keep all vents and openings clear of dirt and dust. If cleaning
becomes necessary, disconnect the unit from the power source, ensure it has cooled completely and wipe
the exterior with a damp cloth, then wipe dry.
If any abnormal condition occurs, unplug the unit, allow it to cool and return it for repair to an authorized
service representative only. Repairs should not be attempted by the user.
• Always disconnect the hair dryer before cleaning.
• Never immerse the hair dryer in water.
•Itissufcienttowipetheexterioroverwithadampclothandthenwipedry.
•Asoftdrybrushmaybeusedtoremovedustandhairsfromtheairinletgrille,toensureproperairowat
all times.
WARNING
To avoid the risk of electrocution – KEEP AWAY FROM WATER HAZARDS
• DO NOT IMMERSE THE UNIT IN WATER OR ANY OTHER LIQUID
• DO NOT TAKE OR USE THIS APPLIANCE IN THE BATHROOM
• DO NOT USE A HAIR DRYER WITH WET HANDS
• NEVER USE THE HAIR DRYER IN THE BATH, UNDER A SHOWER OR OVER A WASH
BASIN FULL OF WATER
• DO NOT REACH FOR THE HAIR DRYER IF IT HAS FALLEN INTO WATER OR ANY
OTHER LIQUID. UNPLUG IT IMMEDIATELY.
STORAGE
When not in use, store the Hair Dryer out of reach of children in a safe, dry location. Do not jerk or strain cord
at plug connections. Do not wrap the line cord around the appliance. Allow the cord to hang or lie loose and
straight at the point of entry into the appliance.
Only store the product in environments ranging from 5°C to 23°C ambient temperature. Failure to comply
could result in damage to the product.

9
www.lloytronhelpdesk.com
WEEE/ENVIRONMENTAL PROTECTION
DISPOSAL OF ELECTRICAL AND ELECTRONIC EQUIPMENT
Do not dispose of this product with household waste. For the proper treatment, recovery and
recycling please take this product to the appropriate waste collection point. If you are unsure
where this may be, please contact your local authority. Improper disposal may be harmful to
the environment.

10 www.lloytronhelpdesk.com
This appliance must be protected by a 7 Amp fuse in a 13 Amp type (BS1363) plug.
Should you need to replace the fuse, use only an ASTA approved BS1362 fuse.
UK PLUG REWIRING
7A FUSE
(L) LIVE
(N) NEUTRAL
Yourapplianceoperateson220-240V~50HzACMainsandcomesttedwitha3-pinBSIApprovedplug,so
thatitisreadyforusebysimplypluggingintoACMains.Shouldyouneedtochangeorretaplug,proceed
as follows: -
IMPORTANT:
The wires in the mains lead are coloured in accordance with the following code:
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.
The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured RED.
DO NOT CONNECT EITHER WIRE ‘L’ OR ‘N’ TO THE EARTH TERMINAL OF A 3-PIN PLUG
Always ensure that the Mains Cord is located into the Plug through the Cord Guard or Cable Clamp, and that
the Cord Guard screws are tightened to clamp the Cord (outer sheath and inner coloured wires) in position
inthePlug.MakesurethePlugtopisalsottedsecurely.
The supply cord cannot be replaced. If the supply cord is damaged, the appliance should be scrapped.

11
www.lloytronhelpdesk.com

If you have any queries about this product then please contact Lloytron Customer Services online at:
TondoutmoreaboutPaulAnthonyproducts,visitwww.lloytron.com
www.lloytronhelpdesk.com
Distributed by Lloytron Plc, Laltex House, Leigh, England WN7 3XH
CUSTOMER SERVICES