Peak Infinity 1051 User manual

Fountain Crescent
Inchinnan Business Park
Inchinnan, PA4 9RE
Scotland, UK
T: [phone]
F: [phone]
W: www.peakscientific.com
E: [e-mail]
Part No. IG-Infinity1051
Rev. 1
Page Page 1 of 5
Installation Guide –Infinity 1051 Generator
FITTINGS KIT

Fountain Crescent
Inchinnan Business Park
Inchinnan, PA4 9RE
Scotland, UK
T: [phone]
F: [phone]
W: www.peakscientific.com
E: [e-mail]
Part No. IG-Infinity1051
Rev. 1
Page Page 2 of 5
INSTALLATION
1.
2.
3.
Unpack the generator from
the shipping crate and place
on a flat surface.
The generator can be wall
mounted, shown above
are the distances required
between fittings.
Using the wall plugs and
screws provided, mount the
generator to the wall in the
desired location.
4.
5.
Select the ¼” compression fittings and attach
to the ‘NITROGEN’ and ‘AIR’ ports. It is
recommended that PTFE tape is applied to the
threads to ensure a leak-tight fit.
Select the ¼” Teflon Tube and connect to
the ‘NITROGEN’ and ‘AIR’ ports. If using
the compression fitting ensure the internal
olive is crimped securely.
¼”
Teflon

Fountain Crescent
Inchinnan Business Park
Inchinnan, PA4 9RE
Scotland, UK
T: [phone]
F: [phone]
W: www.peakscientific.com
E: [e-mail]
Part No. IG-Infinity1051
Rev. 1
Page Page 3 of 5
6.
7.
Connect the other end of the Teflon Tube
to the instrument gas inputs; again ensure
the fittings are securely fastened.
Attach house air supply to BA filter at left side
of generator. Ensure valve on filter is at the
open position.
8.
CONGRATULATIONS
Your PEAK SCIENTIFIC gas generator is now fully installed, operational and ready to
supply gas on demand to your instrument.

Fountain Crescent
Inchinnan Business Park
Inchinnan, PA4 9RE
Scotland, UK
T: [phone]
F: [phone]
W: www.peakscientific.com
E: [e-mail]
Part No. IG-Infinity1051
Rev. 1
Page Page 4 of 5
General Notes
* The 8m length of Teflon tube supplied in the fittings kit is to allow the
generator to be installed adjacent to the instrument it is supplying. If the generator is
to be installed further away from the instrument then attention needs to be paid to
pressure drops that could occur. The maximum distance away from the instrument
the generator can be placed still using 6mm (4mm internal diameter) or ¼” (3/16”
internal diameter) tubing is 10m. For further information relating to tubing lengths
please refer to the user manual.
For all other technical specifications, operating instructions, service
requirements, contact details and trouble shooting, please refer to
the user manual contained on the CD supplied in the fittings kit.
Please keep this for future reference.
9.
It is very important to register your generator with PEAK SCIENTIFIC. This will initiate your
warranty entitlement. Please use the form on the next page to register your generator. You
will need the generators serial number which can be found on the serial label on the rear of
the generator.

Fountain Crescent
Inchinnan Business Park
Inchinnan, PA4 9RE
Scotland, UK
T: [phone]
F: [phone]
W: www.peakscientific.com
E: [e-mail]
Part No. IG-Infinity1051
Rev. 1
Page Page 5 of 5
Warranty Entitlement