Pearl MADISON Robe Hook Reference manual

Madison
Vanity Accessories
“Robe Hook”
Pearlsinks.com
Introduction Contents
Thank you for purchasing an authentic Pearl
Sinks® vanity accessory. The xture you have
purchased is crafted out of the highest
quality chrome-plated brass. Each and every
xture is carefully inspected by hand before
leaving the production line.
Please read the instructions carefully to
prevent any malfunction and damages.
This xture kit contains the following:
Mounting Plates
x2 x2 x2 x1
Hex Wrench
Plastic Anchors Wood/Anchor Screws
Tools
Philips Screwdriver
Hammer Masking Tape Level
Power Drill 1/4” Drill Bit

WALL WALL
TOP
BOTTOM
FACE THIS SIDE TOWARDS YOU
TemplateInstallation
1
Position the template where you would like to mount the xture.
2
Level the template, then attach it to the wall with masking tape.
3
Drill two 5/16” holes on each corresponding mounting plate location.
4
Remove the template from the wall.
5
Insert the plastic anchors into the hole until it is ush with the wall.
6
Install mounting plates onto the wall using the screws provided.
7
Install the the xture and tighten the hex screw.