Pearl BC-100S User manual

BC-100S
Instruction Manual
Congratulations on your purchase!
To get optimum performance of your Cymbal Boom Stand,
please read this Instruction Manual before playing.
PEARL CYMBAL BOOM STAND / CYMBAL STAND
Wing Bolt
Wing Bolt
Base Pipe
Key Bolt
Trident Bracket
Flat Base
*The stand is pre-packed in a Flat Base
Tripod Base
Gear Tilter
Boom Arm
Base
Assembly
The BC-100S Cymbal-Boom stand can be used
in either a Tripod Base, or a Flat Base

Fig. 1
Fig. 2
Fig. 3
Fig. 5
Fig. 4
Fig. 6
Assemblying the Base
(from Flat Base to Tripod Base)
Loosen the Wing Bolt and the Key bolt of the base, then,
slide the legs off from the Base Pipe (Fig.1).
Wing Bolt
Base Pipe
Trident Bracket
Tuning Key
Key Bolt
Wing Bolt
Wing Bolt
Base Pipe Base Pipe
Trident Bracket Trident Bracket
Tuning Key Tuning Key
Key Bolt Key Bolt
Wing Bolt
Base Pipe
Trident Bracket
Tuning Key
Key Bolt
Assemblying the Base
(from Tripod Base to Flat Base)
Loosen the Wing Bolt and the Key bolt of the base, then,
slide the legs off from the Base Pipe (Fig.4).
Turn the Base Assembly over from Flat Base to Tripod
Base, and change the Wing Bolt and the Key Bolt so that
the Key Bolt is always at the bottom (Fig.2).
Turn the Base Assembly over from Tripod Base to Flat
Base, and change the Wing Bolt and the Key Bolt so that
the Key Bolt is always at the bottom (Fig.5).
Spread the legs and insert the Base Pipe. Make sure that
the bottom of the pipe and the Trident Bracket are set flush,
and tighten the Key Bolt and the Wing Bolt (Fig.3).
Spread the legs and insert the Base Pipe. Make sure that
the bottom of the pipe and the Trident Bracket are set flush,
and tighten the Key Bolt and the Wing Bolt (Fig.6).
Caution
Support the Base Pipe with one hand to prevent the stand from
falling.
Caution
Support the Base Pipe with one hand to prevent the stand from
falling.

Caution
When making any adjustment, use one hand to
support and make the adjustment while using your
other hand to control the tension of the wing nut or
wing bolt to prevent the stand from falling and pinching
fingers that may be in the way.
When folding the tripod legs, be careful not to pinch
your fingers between the legs and the stand.
When handling tubular hardware do not put your
fingers into the tubes to prevent injury to your fingers.
For optimal stability, orient one leg in the same
direction as the boom.
Do not tighten the bolts without the pipes inserted to
prevent damage to the stand.
Test the stability of the stand before using. If
necessary, readjust the length of the boom, the
direction of the boom, or weight of the load until the
stand is sufficiently stable.
http://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in Taiwan.
-0801-
Fig. 8
Fig. 7
Flat Base
Tripod Base
Make sure that the bottom of the pipe and the bottom of the
Trident Bracket are set flush, and that the Key Bolt is at the bottom,
with both the Flat Base and the Tripod Base (Fig.7,8).
Caution