Pearl Madison User manual

Madison
Vanity Accessories
“Hand Towel Holder”
Pearlsinks.com
Pearlsinks.com
Thank you for purchasing an authentic Pearl Sinks®
vanity accessory. The xture you have purchased is
crafted out of the highest quality chrome-plated
brass. Each and every xture is carefully inspected by
hand before leaving the production line.
Please read the instructions carefully to prevent any
malfunction and damages.

WALL WALL
TOP
BOTTOM
FACE THIS SIDE TOWARDS YOU
Introduction
Contents
Template
Thank you for purchasing an authentic Pearl Sinks®
vanity accessory. The xture you have purchased is
crafted out of the highest quality chrome-plated
brass. Each and every xture is carefully inspected by
hand before leaving the production line.
Please read the instructions carefully to prevent any
malfunction and damages.
This xture kit contains the following hardware:
Mounting Plates
x2 x2
x2 x1
1
Hex Wrench
Plastic Anchors
Wood/Anchor Screws
Tools
The tools below are required to complete the
installation. For additional information, check with
your local hardware store on the requirements for
your installation.
Philips Screwdriver
Hammer Masking Tape Level
Power Drill 1/4” Drill Bit
Installation
Position the template where you would like to mount the xture.
2
Level the template, then attach it to the wall with masking tape.
3
Drill two 5/16” holes on each corresponding mounting plate location.
4
Remove the template from the wall.
5
Insert the plastic anchors into the hole until it is ush with the wall.
6
Install mounting plates onto the wall using the screws provided.
7
Install the xture and tighten the hex screw.