Pearl H-72W User manual

Base
Instruction Manual
Congratulations on your purchase!
To get optimum performance of your H-72W Hi-Hat Stand,
please read this Instruction Manual before playing.
H-72W
PEARL HI-HAT STAND
Upper Tube
Pull Rod
Reversible
Footboard
Hi-Hat Clutch
Hi-Hat Cup
Radius Rod
Wing Bolt
Wing Bolt

Hi-Hat Stand Assembly
Open the legs of the hi-hat to form a stable tripod. Insert the ends of the radius rod into the holes near the bottom of the
hi-hat base (Fig. 1). Thread the upper pull rod into the connector as shown (Fig. 2).
Place the upper tube over the upper pull rod and into the tripod base and set the height to your preference.Rest the lower
hi-hat cymbal on the hi-hat cup. Attach the top hi-hat cymbal to the clutch in the order shown then slide the clutch with the
top cymbal attached onto the upper pull rod. Adjust the distance between the top and lower hi-hat cymbals to your
preference by stepping on the pedal and tightening the wing bolt on the clutch when the desired distance is achieved.
Fig.1 Fig.2
Hi-Hat Clutch
Hi-Hat Cup
Upper Tube
Upper Pull Rod
Wing Bolt
Radius Rod
Hole
Hi-Hat Cup
Attaching the Upper Pull Rod
Hi-Hat Clutch
Top Hi-Hat
Cymbal
Bottom Lock Nut
Lower Hi-Hat
Cymbal
Upper Tube
Die-Cast Joint
Caution
Periodically lightly lube external moving parts such as the Chain, Wing Nuts, Wing Bolts, Key Bolts, and Footboard Hinge
to achieve optimum performance from your hi-hat.
http://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in Taiwan.
-0701-