Perfect Choice Bistro Counter Height or Bar Height Table User manual

Parts Included:
2- Assembled Leg Sets
1- Table Top
1- Hole Plug
4- Leg Braces
ASSEMBLY INSTRUCTIONS
Bistro Counter Height or Bar HeightTable
Tools Not Included but Required: 7/16" wrench, either a power tool, hand driver or ratchet
wrench that will accept a 1/4" hex drive bit.
Tools Included: 4mm Allen Wrench
Stainless Steel
Hardware Included:
8 - 3" Lag Screws
8- 1-1/2" Screws
8 - Washers
1. Position the leg sets upside down with the feet in the air and the leg notches facing inward. Place a leg
brace into one of the lower notches of both leg sets. Screw in a 3" lag screw only part way, into both let sets.
Repeat this step and insert the other leg brace into the other lower set of notches. Screw in a 3" lag screw
only part way into both let sets.
Step 1a
Table Top
Leg Braces
Assembled Leg Sets
Hole
Plug
Hardware
2. Repeat step 1and insert the upper braces. After inserting all 4 braces, tighten all screws.
Step 1b

477 Vogt Lane • Chilton, WI 53014 • 800-817-8833
www.perfectchoicefurniture.com • www.birdschoice.com
Your outdoor furniture is guaranteed
for 20 years to never crack, split or
fade.To clean, wash with soap and
water. For tough stains, use a
solution with water and soft scrub or
try our furniture cleaner.
3. Lay the tabletop upside down on the oor.
Place your assembled leg section (with the feet still in the air)
on the tabletop.
Step 3
Step 4
4. Line up the 4 holes on both sides of the
table. Place a washer and a 1-1/2" pan head
screw into each hole and then tighten all
8 screws.
5. Flip the table upright. Place the hole plug in
the center of the table top or insert an
umbrella through the center hole.
6. Enjoy your bistro table!