Perfect Choice Swivel Rocking Dining Chair User manual

Parts Included:
1- Assembled Back
1- Assembled Seat
1- Set of Arms
1- Assembled Base
1- Backboard
2 - Arm Supports (left & right)
ASSEMBLY INSTRUCTIONS
Swivel Rocking Dining Chair
Tools Not Included but Required: 7/16" wrench, socket & ratchet and a power drill
Tools Included: #2 Square Drive Bit, 4mm Allen Wrench
Stainless Steel Hardware
Included:
Assembled Back
8 - 3-1/2" Bolts
4 - 3" Bolts
2 - 2-1/2" Bolts
4 - 1-5/8" Deck Screws
14 - Nuts
14 - Flat Washers
14 - Lock Washers
4 - Lock Nuts
2 - Rectangular
2 Holed Washers
Assembled Seat
Hardware
Arm Supports
Arms
Assembled Base
1. Placetheassembledbaseontoaatsurface.Thenplacetheseatonto
2. Determineyourleftandrightassembledarmsupports.Thescrews 
holding the assembled arm supports together should face in towards
each other. Place a 3-1/2" bolt through all 8 holes of the assembled arm
 supportsandintotheseat.Placeaatwasher,lockwasherandnut
onto each bolt and hand tighten only.
Step 1
Backboard
the base lining up the bolts coming out of the horizontal seat support with the
 holesintheberglasssprings.Makesuretheseatisfacingthecorrectdirection.
Step 2
 Thehorizontalseatsupportshouldalmostentirelyberestingontheberglasssprings.Then,one
bolt at a time, line up the 2 holed washer with those same bolts and place a lock nut onto each
 bolt.Placeall4nutsontoall4boltsrstandthentighten.

477VogtLane•Chilton,WI53014•800-817-8833
www.perfectchoicefurniture.com•www.birdschoice.com
Your outdoor furniture is guaranteed
for 20 years to never crack, split or
fade.To clean, wash with soap and
water. For tough stains, use a
solution with water and soft scrub or
try our furniture cleaner.
3. Attachthearmsusingfour3"bolts.Theboltsgofromthe
 insideofthearmsupportsoutthroughthearm.Placeaat
washer, lock washer and nut onto each bolt and hand
tighten only.
Step 3
Step 4
4. Attach the back of the chair to the seat of the chair using two 1-5/8" deck screws.
 Makesuretopushthechairbackuptighttotheseat.Then,placetwo2-1/2" bolts
 downthrougheacharmintotheupperbacksupportofthechairback.Placeat
washer, lock washer and nut onto each bolt and fully tighten. Next, attach back
board to the back of the seat using two 1-5/8"deckscrews.Theholesare
offset towards the top of the chair.
5. Go back and tighten all nuts.
6. Enjoy your swivel rocking dining chair!