Performance Furnishings PLTECAB6078MEDWF User manual

TROUBLESHOOT PLTECAB6078MEDWF WITH PLTMEDPRGREMOTE
Before using for the 1st time, please make sure to reset properly by following instructions below
E04 Error Code
If you happen to run into a situation where E04 Error Code is shown on the display, please follow steps below:
1) Do a proper reset by following instructions below
During the reset, you must hold the "Up" & "Down" Arrow until the height adjustable table reaches the lowest point
and bounces back up 1". If you do not follow the instructions, E04 error code will continue to show.

2) If the reset does not work, please unplug all cables and connections attached to the height adjustable table.
Please wait for 1 minute as this would allow hardware to go through a "Cool Down" process.
After 1 minute, please reconnect all cables and plug back into power source.
Once that is complete, please do a proper reset by following instructions below.
3) If none of the above instructions resolve the E04 issue, please replace the black motor box.
During the reset, you must hold the "Up" & "Down" Arrow until the height adjustable table reaches the lowest point
and bounces back up 1".
Once a replacement black motor box has been installed, please replug all the cables and do a proper reset by following
above instructions.

4) If none of the above works, please reach out to Windsor/Dave for further assistance.
Height Adjustable Table Won't Go Past Certain Height
Height Adjustable Table Won't Go Past Below Certain Height
E01 Error Code
If you happen to run into a situation where E01 Error Code is shown on the display, please follow steps below:
During the reset, you must hold the "Up" & "Down" Arrow until the height adjustable table reaches the lowest point
and bounces back up 1".
1) If you happen to run into a situation where the height adjustable table won't go above a certain height limit,
please follow the steps below:
1) If you happen to run into a situation where the height adjustable table won't go below a certain height limit,
please follow the steps below:

1) Remove AC Cable from Power Unit and from wall outlet
Please have cables unplugged and wait for 1 minute
Then reconnect all cables after 1 minute
Do a proper reset by following instructions below
If you do not follow the instructions, E04 error code will continue to show.
E03 Error Code
If you happen to run into a situation where E03 Error Code is shown on the display, please follow steps below:
1) Table has excessive weight, please remove everthing on top of the table
2) Do a proper reset by following instructions below:
Check and see if the legs are operating properly. If not, this indicates that inner parts of the legs are defective
and require replacement
During the reset, you must hold the "Up" & "Down" Arrow until the height adjustable table reaches the lowest point
and bounces back up 1".

If you do not follow the instructions, E04 error code will continue to show.
E05 Error Code
If you happen to run into a situation where E05 Error Code is shown on the display, please follow steps below:
1) Button of switch stuck, check status of the button. If stuck then toggle the button to restore
2) If Step 1 does not resolve the issue, please replace the switch
E06 Error Code
If you happen to run into a situation where E06 Error Code is shown on the display, please follow steps below:
1) Remove AC Cable from Power Unit and from wall outlet
Please have cables unplugged and wait for 1 minute
Then reconnect all cables after 1 minute
Do a proper reset by following instructions below
During the reset, you must hold the "Up" & "Down" Arrow until the height adjustable table reaches the lowest point
and bounces back up 1".