perixx PERIDUO-703 User manual

Reconnecting PERIDUO-703
to new USB Receiver
User Guide

Step 1: Download and extract the file
Please connect another mouse with your PC to complete the reconnecting process.
•Download PERIDUO-703 Binding Software and open the .zip folder
•Double click to extract the file WUG1005 BindTool.exe
•Click “Extract all”

Step 2: Run the program
Double click to open the program WUG1005 BindTool.exe

Step 3: Open the program and plug in the USB Receiver
Before and after you plug in the USB receiver

Step 5: Connect the Keyboard
1. Press the button Start Binding Mode, the program shows BIND.
2. Press the Connect Button under the keyboard for 5 seconds.
3. Press Aand Btogether until the program shows KBPASS.
4. The keyboard is connected successfully.
K1 & K2 appear green,
while testing the keys A and B

Step 6: Connect the Mouse
1. Press the button Start Binding Mode
2. Press Connect Button under the mouse for 5 seconds, the Program shows BIND.
3. Press Left and Right button of the mouse together, the Program shows MouPASS.
4. Your keyboard and mouse set is ready to use now.
M1 & M2 appear green,
while testing Left and right click

NOTE:
If your keyboard and mouse do not function after following these steps, please see the instructions as below.
•Check whether the batteries are fully charged.
•Disconnect other keyboard and mouse.
•Repeat the process again.
•Have contact with our customer service. [e-mail]