Perma child safety 2738 User manual

Ultimate
Retractable
Gate
100cm Tall
(39.4’’)
#2738
IMPORTANT! READ AND
FOLLOW THESE INSTRUCTIONS
CAREFULLY AND KEEP FOR
FUTURE REFERENCE.
Up To 1.8m
(71’’) Wide
This product complies with safety standard ASTM F1004.

Read this instruction manual carefully and keep it in a
safe place for future reference. The correct use and
maintenance of this product is essential.
1

Clean using warm soapy water, or a damp cloth. Towel or air dry.
2

PART LIST
If any parts are missing do not attempt to use your Retractable Gate.
Please contact us at www.permachildsafety.com/contact to obtain replacements.
Only use parts supplied by the manufacturer with your Retractable Gate.
Wall Spacers
x6
Catch Mounts
x2
Upper Gate
Mount x1
Lower Gate
Mount x1
3
Wall Plugs
x8
and
25mm (1”)
Lower Mount
Screws x4
35mm (1 3/8”)
Upper Mount Screws
(use with spacers) x4

IMPORTANT
Gate must be installed in a structurally sound opening. Ensure mounting surface
(wall, door frame, stair posts, etc.) is strong, rigid and has an even surface.
Note: If using gate on stairs, it must be placed either on the top step or on
the lowest step at the bottom.
Select the appropriate fixing method from the following list. This barrier must only
be fixed to a solid and secure surface. To install you will need a Phillips screwdriver,
pencil and drill. If unsure, check with a qualified builder or tradesperson that the
installation you intend is suitable and safe within the chosen location.
Wood Mounting
Drill 2mm (5/64’’)pilot holes and use the wood screws provided
screwing directly into the wood.
Hard Wall Mounting (Concrete or Brick)
Drill 5mm (3/16’’)pilot holes, insert wall plugs
and secure with screws.
Dry Wall Mounting
Locate the wood stud and follow the wood mounting instructions.
Do not mount into dry wall without additional support.
4

2 WAYS INSTALLATION
Inside opening or doorway
Outside opening or doorway
5

INSTALLATION INSIDE OPENING OR DOORWAY
1. Hold guide vertically and completely outstretched against mounting
surface with the end marked “FLOOR” even with the floor. Mark screw hole positions.
Remove the template. Repeat process for other side.
2.
Align each mount in its correct position, use a Phillips screwdriver to tighten
screws until each mount is secure.
Note: leave at least 2cm (3/4’’)
between guide and the edge of
the opening to ensure gate won’t
overhang edge.
2cm (3/4’’)
1.
2.
6

Caution: Incorrect installation of catch mounts inside opening can be dangerous.
7

To remove gate from the mounts, push and hold the
lock release button while sliding the gate upwards.
Note: Lower gate mount
has a locking groove.
Lock Release
1.
2.
3.
To Remove.
3. Attach gate assembly to the gate
mounts by aligning the gate directly
above the mounts and sliding straight
down over mounts. Check that the
gate assembly is flush against the wall
and is locked firmly in place.
8

2. Align each mount in its correct position,
use a Phillips screwdriver to tighten
screws
un til each mount is secure.
Follow step 1 from
“Installation Inside Doorway or Opening”.
INSTALLATION OUTSIDE OPENING OR DOORWAY
1.
2.
9