Phil & Teds T2 User manual

TM
your T2
survival guide

light sound
from the
adaptability range

nitty gritty
a
&
bits bobs
Open your T2 carry bag and check that
the following bits and bobs are there
•1 x T2 travel cot
•4 x black leg poles (attached)
•2 x black side poles (attached)
•4 x black top poles (attached)
•4 x pegs
•1 x carry bag
•1 x inflatable mattress
1. Place the top of the cot (zipped mesh
part) face down on the ground.
2. Straighten the fabric and lay the
leg poles 'a' outwards on the ground.
You are now ready to assemble.
welcome to the delightful adaptable
world of
our boxes make a great
distraction for your kids while you
get into the nitty gritty.
Please read the WARNINGS in this book
carefully and help us continue improving
our adaptability range by returning your
warranty form.
aa
a
a

nitty gritty
a
&
1. Locate the two side poles and fit
together in the middle. The poles
should curve outwards and lie flat.
2. Fit the center joint on the leg
poles together in the same way.
3. Fit the ends of the side poles, end poles
and leg poles onto the corner fittings,
placing the slots in the poles onto the
keys of the plastic corners. Repeat for
the other 3 corners.
Note: keep the elastic cord clear when
inserting a corner piece.
'click'
'click'
'clip'
'click'
'snap' 'snap' 'snap'
&
4. Turn the cot onto its leg poles, fix
the end of the poles into the corner
webbing sockets and do up snap.
5. Connect the four buckles around
the top of the leg poles to the end
buckles. They should be tight.
6. Snap fasten the end covers over
the end poles.

a
7. Attach the straps on the side of the
T2 to the corresponding snap half
way up the leg pole.
8. Inflate the mattress by opening the
self inflating valve. Manually inflate
as desired. Close the valve securely
when finished.
9. Unzip the top mesh and place
the mattress inside, pressing it
into the fabric corners.
Important: When outdoors anchor the cot
to the ground by placing the supplied pegs
through the eyelets in the corner webbing.
down she goes
When dismantling, the cot goes in the bag first,
then the mattress. It does sound tricky, but once
you've done it it will seem very easy...trust us!
1. Remove the mattress from the cot, undo the
valve and zip up the mesh top.
2. Undo all the clips (if you wish) and the 'snaps'
on the leg poles.
3. Undo all poles from corner fittings one corner
at a time, and then pull apart the long side
poles and leg poles.
4. Each pole will now be approximately the
same length and the cot will essentially be flat
on the floor, in a rectanglular shape.
5. Fold the bottom left corner up to the middle
then fold the top right corner down to the middle.
&

cuts bruises
the once over
Check the T2for cuts &bruises.
If your T2is damaged in any way,
or you are not sure how to use it,
contact your retailer immediately.
The fabric on your T2is highly water
resistant, but zips and seams can leak.
caring for the T2
unlike children, your T2likes to stay clean.
Dry your T2thoroughly before storing.
Remove dry dirt with a soft brush.
Do not wash with soap, solvents, bleach.
or detergents. (These may harm the fabric).
Store in a well ventilated space, away from
moisture and direct sunlight (which can
harm and fade your T2's colourful coat).
6. Push the bunches of poles
'a' and 'b' together.
7. With both hands lift the bunch of poles
allowing the excess fabric to hang below.
8. Role the poles into the fabric.
9. Fold the mattress in half (short end to
short end), then twice more in the same
direction so the mattress is 6 layers thick,
squeeze the air out and close the valve.
The mattress will then fit in the bag on
top of the cot, or convert into an origami
swan if you’re in the mood.
ab
roll

smartbuggy tott metro
adapt survive!
e3 metoo snuggle & snooze
TM
TM
TM

rights remedies
Improper use (including but not limited to): abnormal
use; not following instructions; child left unattended;
safety harness not used; excessive load; transport
damage i.e. airline or cargo damage.
Customer costs within warranty. The customer is
responsible for any inwards freight charge to return
the product to the manufacturer, or its representative,
for warranty and or service.
Customer costs outside of warranty. Where proof
of purchase is not provided or the product is outside
of the one year period, the manufacturer (or agent)
reserves the right to charge a service fee and/or
charge for parts replaced/repaired. A return freight
charge may apply.
Exclusions. Any consequential loss or damage to
any person or property resulting directly or indirectly
from use of the product.
Who do I contact? Please discuss any warranty or
service queries with your store of purchase. You will be
required to show proof of purchase. They will inform
you of the next step.
* The consumer may have additional rights in some countries
our warranty and service policy
We want to give owners confidence in the
quality of our products. They are warranted against
defects in materials and workmanship for one year
from the date of purchase.
If the product has a manufacturing fault we will
repair it free of charge. If it's not practical to repair
it we will, at our discretion, replace the part in
question*. If the product fails due to wear and tear,
accident, neglect or negligence, or is outside the
one year warranty, we will happily repair it for
a reasonable charge.
details of warranty
Who is covered? The original purchaser
buying new product from an authorised dealer.
Proof of purchase is required.
What is covered? Workmanship or materials that
are deemed faulty, providing the T2has, at all times,
been used in normal conditions and been properly
maintained in accordance with the instructions.
What is not covered? Second hand product.
Modified product. Poorly maintained product.
Normal wear, fading and fabric cuts.

a
return relax warranty form
Name
Address
Phone
Email
Just a few extra details to help us
adapt survive!
Your age?
under 25 25-34 35-40 40+
Number of children
1 2 3 3+ soon!
Their ages
How did you hear about us?
Which most excellent product did you buy?
Date of purchase / /
Rate from 1-10 how likely you would be to
recommend this product to someone else?
1 2 3 4 5 6 7 8 9 10
Why?
Any general suggestions?
Can we inform you of new products
and specials? yes no
www.philandteds.com
e3 twin
smartbuggy
accessories
e3 double kit
e3
T2
tott
pepe
bebe
metro
metoo
escape

102-112 daniell street
newtown
wellington 6002
new zealand
affix
stamp
here

!
warnings
Please follow these instructions.
Injury may result if you do not follow
these safety precautions. Injury may
result from improper use.
WARNING: Before each use, make sure
your cot is correctly assembled. Incorrect
assembly may affect your child’s safety.
WARNING: Do not use your T2if any
part is broken, torn or missing.
WARNING: Make sure children are
clear of the immediate area before
erecting or adjusting the T2.
WARNING: Do not use the T2near a
heater, cooking device or exposed flame.
WARNING: Ensure your T2is placed
a safe distance from curtains, blinds,
heaters and power points. Take special
care that medication, string, elastic and
small toys or items such as coins are out
of reach from any position in the T2.
WARNING: Ensure your child doesn't
climb out of the cot; injury may result
from your child falling from the cot.
WARNING: Do not leave anything in
the cot which could provide a foothold,
or present a danger of suffocation
or strangulation.
WARNING: Do not modify the T2or
use accessories not designed for it.
WARNING:The mattress for your T2
should be 500mm wide, 1200mm long
and no more than 30mm thick. Using
the wrong size, thickness or an extra
mattress may create hazardous gaps
that could result in suffocation or reduce
the height of your T2, which may result
in your child falling from your T2.
WARNING: When outdoors always
use the pegs supplied to secure the
cot to the ground.

adapt survive!
TM
head office [phone]
fax [phone]
address 102-112 daniell street
wellington new zealand
visit www.philandteds.com
Phil & teds most excellent buggy company ltd. (phil & teds), the
phil & teds logo, the shapes and designs of the products and the
adapt & survive logo are global trademarks of Phil & Teds New
Zealand Limited. Phil & Teds New Zealand Limited is the owner of
all past, present and future intellectual property used and developed
in relation to its business and reserves all rights in relation to its
intellectual property and the presentation of it. c Phil & teds most
excellent buggy company ltd.