Philips AVENT SCF301 User manual

Specications are subject to change without notice
© 2017 Koninklijke Philips N.V.
All rights reserved.
4241 354 02841 100% recycled paper
EN User manual 5
BG Ръководство за потребителя 20
CS Příručka pro uživatele 36
ET Kasutusjuhend 52
HR Korisnički priručnik 68
HU Felhasználói kézikönyv 84
LT Vartotojo vadovas 101
LV Lietotāja rokasgrāmata 117
MK Упатство за користење 133
PL Instrukcja obsługi 149
RO Manual de utilizare 166
SK Príručka užívateľa 183
SL Uporabniški priročnik 200
SR Korisnički priručnik 216
UK Посібник користувача 233
SCF301

b a
p
e df
h
i
g
o
c
j
k
lm n
A
B
C
D
E
F
M
L
K
J
I
H
G
1
2
3
7
11
15
19
4
8
12
16
20
5
9
13
17
21
6
10
14
18
22

5
English
9 Compatibility 16
10 Replacement 17
Batteries 17
11 Ordering accessories 17
12 Recycling 17
13 Guarantee and service 17
14 Troubleshooting 18
Table of Contents
1 Important 6
Electromagnetic Fields (EMF) 9
2 Introduction 9
Overview (Fig. 1) 9
Control panel (Fig. 2) 10
3 Cleaning and sterilising 10
4 Assembling the electric
breast pump 11
5 Using the electric breast pump 12
Before using the pump 12
To begin pumping 12
To pause pumping 14
Storing your breast milk 14
Feeding your baby with
expressed breast milk 15
Keeping your electric breast
pump sterile for travel 15
6 Hints to help you succeed 15
7 When to express milk 16
Right times of the day to
express your milk 16
8 Storage 16

6
English
• Before each use, check
the breast pump,
including the power
adapter for signs of
damage. Never operate
the breast pump if it
has a damaged plug,
not working properly,
has been dropped or
damaged, or has been
submerged in water.
• The power cord is
irreplaceable. Discard it
if is damaged, including
the power adapter.
• Only use accessories
recommended by Philips
Avent.
• Only use the power
adapter supplied with
the product.
• Make sure the breast
pump, including the
power adapter, is not
exposed to extreme
heat or placed in direct
sunlight.
• Do not use the breast
pump outdoors.
• There are no user
serviceable parts inside
the pump. Do not
attempt to open, service,
1 Important
Read this user manual carefully
before using your Philips Avent
single electric breast pump, and
save the user manual for future
reference. You can also nd this
user manual at Philips website:
www.philips.com/support.
Warning
• Always unplug from
the power socket
immediately after use.
• Do not use the breast
pump while bathing.
• Do not place or store the
breast pump where it
can fall or be pulled into
a bath or sink.
• Do not place or drop the
pump motor, silicone
tube, and power adapter
into water or other
liquids.
• Do not reach for a
product that has fallen
into water. Unplug
from the power socket
immediately.
• Children should be
supervised to ensure that
they do not play with
the appliance. Place the
appliance out of reach
from children and pets.

7
English
knowledge if they have
been given supervision
or instruction concerning
use of the appliance in
a safe way and if they
understand the hazards
involved.
• This appliance shall not
be used by children.
• If expressing becomes
painful, stop and consult
your breastfeeding
advisor or healthcare
professional.
• Do not use the breast
pump in the presence of
ammable anaesthetic
mixtures with air, with
oxygen, or with nitrous
oxide.
• Although the breast
pump is compliant
with applicable EMC
directives, it may still be
susceptible to excessive
emissions and/or may
interfere with more
sensitive equipment.
• Make sure not put any
products on the pump
motor, like pillow, blanket
etc. Please make sure
pump motor work in
or repair the breast
pump yourself.
• The parts of the pump
which come directly into
contact with milk are
personal care items, and
should not be shared
between mothers.
• Do not attempt to
remove the pump body
from the breast while
under vacuum. Switch
the breast pump o, and
break the seal between
your breast and the
pump funnel with your
nger, then remove the
pump from your breast.
You can also pull o
the silicone tube from
the motor or the cap to
release the vacuum.
• Never use while pregnant
as pumping can induce
labor.
• Never use when sleepy
or drowsy.
• This appliances can
be used by persons
with reduced physical,
sensory or mental
capabilities or lack
of experience and

8
English
• If the vacuum generated
is uncomfortable or
cause pain, switch o the
breast pump, break the
seal between the breast
and the pump funnel
with your nger, and then
remove the pump from
your breast. You can
also pull o the silicone
tube from the motor or
the cap to release the
vacuum.
• Do not continue
pumping for more than
ve minutes at a time if
no result is achieved.
• Never use any
accessories or parts from
other manufacturers
or that Philips Avent
does not specically
recommend. If you use
such accessories or
parts, your guarantee
becomes invalid.
• Do not use the breast
pump if the silicone
diaphragm appears to
be damaged or broken.
Replace the silicone
diaphragm. See chapter
“Guarantee and service”
well ventilation and heat
dissipation condition.
Caution
• The product should not
be left unattended when
plugged into a power
socket.
• Never drop or insert any
foreign object into any
opening or the silicone
tube.
• Do not shorten the
silicone tube.
• Before you connect
the breast pump to
the power, make sure
that the voltage of the
product corresponds to
the local power voltage.
• Wash, rinse, and sterilise
the appropriate pump
parts before each use.
• Do not use antibacterial,
abrasive cleaners,
or detergents when
cleaning breast pump
parts.
• Never put the breast
pump motor in water
or steriliser, as you
can cause permanent
damage to the pump.

9
English
2 Introduction
Congratulations on your purchase
and welcome to Philips Avent! To fully
benet from the support that Philips
Avent oers, register your product at
www.philips.com/welcome.
The Philips Avent breast pump
provides comfort, convenience
for eective expression. Rhythmic
Wave Technology, which is designed
to mimic baby suckling rhythm. It
also has a soft massage cushion,
an intuitive design to make whole
expression more comfortable and
convenient. Healthcare professional
says that breast milk is the best
nutrition for babies during the rst
year, combined with solid food
after the rst six months, Your milk
is specially adapted to your baby’s
needs and contains antibodies
which help protect your baby against
infection and allergies. Your single
electric breast pump will help you
breast-feed longer. You can express
and store your milk so that - whether
you are out for a few hours, taking a
well deserved rest, or back at work -
your baby can still enjoy the benets
of your breast milk, even if you
cannot be there to give it yourself.
The pump is easy to assemble.
You can take it with you anywhere,
allowing you to express milk at your
own convenience and maintain your
milk supply.
Overview (Fig. 1)
a Silicone tube
b Cap
c Silicone diaphragm (x2)
(one for back up)
d Pump body
for information on how
to obtain replacement
parts.
• Never use feeding teats
as dummies, paciers,
or soothers. Make sure
that the teething baby
does not bite the teat
too long. The continuous
and prolonged bite will
damage the teat. For
hygiene reasons, replace
teats after three months
of use. Use only Philips
Avent teats and bottles
together.
• Cleaning and user
maintenance shall not
be made by children
without supervision.
Electromagnetic Fields
(EMF)
This Philips appliance complies
with all applicable standards and
regulations regarding exposure to
electromagnetic elds.

10
English
3 Cleaning and
sterilising
Before you use your breast pump for
the rst time and for every time, you
must disassemble, wash, and sterilise
all the breast pump parts that come
into contact with your breast milk.
(see c, d, e, f, g, lin Overview
chapter)
Before you use the bottle and its
parts for the rst time and for every
time,you must also disassemble,
wash and sterilise. (see h, i, j, k
in Overview chapter)
Caution
•Never wash or sterilise the pump
motor, the silicone tube, the cap,
and the power adapter. These
components do not come into
contact with your breast milk. You
can wipe those parts clean with a
soft cloth.
You can also use the dishwasher
(top rack only) or hand wash in
warm, soapy water, and then rinse
thoroughly. We recommend you to
sterilise all the parts contacting with
breast milk in our Philips Avent steam
steriliser, or by boiling for 5 minutes.
Caution
•Take care when cleaning the
valve and the silicone diaphragm.
If it gets damaged, your breast
pump will not function properly.
•To clean the valve, rub it gently
between your ngers in warm
soapy water. Do not insert objects
as this may cause damage.
e Let-down Massage Cushion
f Pump cover
g Valve (x2) (one for back up)
h Dormal cap
i Screw ring
j Teat (0m+)
k Sealing disc
l Bottle (125ml)
m Travel cover
n Pump motor
o Sling
p Power adapter
Control panel (Fig. 2)
A Timer
B Stimulation indicator
C Level 2 indicator
D Level 1 indicator
E Mode selection button (selecting
the stimulation and expression
mode)
F Level down button
G Power button
H Level up button
I Pause/play button
J Level 4 indicator
K Level 3 indicator
L Expression indicator
M Battery indicator
Note
•The battery indicator ashes
only when in low battery. We
recomend you to change the
battery as soon as possible.

11
English
4 Assembling the
electric breast
pump
To assemble the pump, follow the
steps below.
Note
•Make sure that you clean and
sterilise the pump as instructed in
this user manual.
•Make sure that you assemble the
pump correctly as instructed in
this user manual.
•To avoid leakage, remove the
residue around the rim before
assembling. Put the bottle onto
the pump body, and do not over-
tighten.
•Wash your hand thoroughly
before you take sterilised
components.
1 Insert the valve into the pump
body from underneath. (Fig. 3)
2 Put the bottle onto the pump
body and turn it anticlockwise to
x it. Do not over-tighten when
assembling the bottle to the
pump body. (Fig. 4)
3 Insert the Let-down Massage
Cushion into the pump funnel
and press the rim to ensure a
perfect seal. (Fig. 5)
4 Put the silicone diaphragm onto
the pump body and press the
rim to make sure a perfect seal.
(Fig. 6&7)
Tip
•You may nd it easier to
assemble while it is wet.
5 Firmly push the cap onto the
silicone diaphragm, so that it
sites securely on top of the
silicone diaphragm. (Fig. 8)
6 Connect the silicone tube to the
cap and the motor rmly. (Fig. 9)
7 Connect the power adapter to
the pump motor, and then insert
the power plug to the power
socket. (Fig. 10)
Note
•Only use the adapter provided
with this product. Do not use
other adapter.
Tip
•For battery operation, open the
rear cover of the motor unit in the
direction indicated by the marks.
Insert four new 1.5V AA alkaline
batteries into the battery housing.
Reattach the rear cover to the
motor unit. We recommend you
to use rechargeable batteries for
long time use. (Fig. 11)
Note
•If you have inserted batteries in
the battery housing of the pump
motor and plug in the adapter,
the breast pump will run from the
main power supply. The batteries
cannot be charged in the unit.

12
English
expression in your latest
usage.
» You begin to feel the suction
on your breast.
Note
•The timer starts when the
appliance is power on. The timer
indicator displays 01 after the
appliance has been power on for
1 minute. The unit is minute.
•The timer will show total breast
pumping time, pause time does
not count in.
•If the timer displays over 99
minutes (when it comes to 100
minutes), the machine will shut
down automatically.
3 You can choose your desired
stimulation level to stimulate
milk by pressing the level up ( )
and level down ( ) buttons. You
can press the level up button to
deeper the suction. Press the
level down button to lower the
suction.There are altogether 4
stimulation levels. (Fig. 14)
4 Once your milk starts owing,
you can press the mode
selection button ( ) to switch to
the expression mode. (Fig. 15)
5 After switching to the expression
mode, you can choose your
desired expression level by
pressing the level up ( ) and
level down ( ) buttons. You
can press the level up button to
deeper the suction. Press the
level down button to lower the
suction.There are altogether 4
expression levels. (Fig. 16)
5 Using the electric
breast pump
Before using the pump
•Wash your hands thoroughly, and
make sure your breasts are clean.
Gently squeeze a little milk from
each nipple to make sure that milk
ducts are not blocked.
•Make sure you follow the steps
in “Cleaning and sterilising” and
“Assembling” chapters to clean,
sterilise, and assemble the breast
pump.
•Relax in a comfortable chair,
leaning slightly forward (use
cushions to support your back).
Make sure that you have a glass
of water nearby.
To begin pumping
1 Press the assembled pump
bodies against your breasts.
Make sure that your nipples are
centered, so that the massage
cushion creates an airtight seal.
Make sure that no air escapes;
otherwise there is no suction.
(Fig. 12)
2 Press the power button ( ) to
switch on your pump. (Fig. 13)
» The display panel lights up
for 1 second. The breast
pump automatically starts up
in stimulation level 1 mode
in the rst time usage, and
the stimulation indicator
lights up. The appliance
has the memory function
to remember the levels for
your both stimulation and