Philips AEA2000/05 User manual

AEA2000
www.philips.com/support
Always there to help you
User Manual
Question?
Contact
Philips
Question?
Contact
Philips
Register your product and get support at

2EN
Contents
1 Important 3
2 Your Bluetooth Adapter 3
Introduction 3
What's in the box 3
3 Play 4
Connect audio cables 4
Connect power 4
Enter pairing mode 4
Play from Bluetooth-enabled devices 5
4 Product information 6
Specications 6
5 Troubleshooting 6
AboutBluetoothdevice 6
6 Notice 7
Recycling 7

3EN
1 Important
• Read these instructions.
• Follow all instructions.
• Do not use this apparatus near water.
• Do not place near any heat sources such
as radiators, heat registers, stoves, or
otherapparatus(includingampliers)that
produce heat.
• Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
• Onlyuseattachments/accessoriesspecied
by the manufacturer.
• Unplug this apparatus during lightning
storms or when unused for long periods
of time.
• Referallservicingtoqualiedservice
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
• Apparatus shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
apparatus(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
• Never remove the casing of this apparatus.
• Never place this apparatus on other electrical
equipment.
• Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the apparatus from
the power.
2 Your Bluetooth
Adapter
Introduction
By connecting the Bluetooth adapter to your
Hi-Fi speaker system, you can enjoy audio from
your Bluetooth-enabled device on your Hi-Fi
system through Bluetooth wireless connection.
What's in the box
Check and identify the contents of your
package:
• Main unit
• AC power adaptor
• RCA audio cable
• User manual

4EN
3 Play
Always follow the instructions in this chapter in
sequence.
Connect audio cables
There are two ways to connect the Bluetooth
adaptortoyourHi-Fisystem.Selectonetfor
the Hi-Fi system.
Option 1 (Fig.A)
Option 2 (Fig. B)
AUDIO IN
LR
L
LINE OUT R
Connect power
Caution
• Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the unit.
• Risk of electric shock! Hold the plug securely when
unplugging the device.
Note
• The type plate is located on the bottom of the
Bluetooth adaptor.
Connect the power adaptor to:
• the DC IN socket at the back of the
Bluetooth adapter.
• the wall outlet.
Enter pairing mode
When connected to power, the Bluetooth
adaptor goes to Bluetooth pairing mode
automatically.
• If your Bluetooth device has not been
paired with the Bluetooth adapter before,
you need pair with the Bluetooth adapter
rst,thenplayaudioonthedevice(See
the section “Play from Bluetooth-enabled
devices”).
DC IN

5EN
• If your Bluetooth device has been paired
with the Bluetooth adapter before, press .
» The Bluetooth adapter attempts to connect
the previously connected Bluetooth device.
If it fails, the adapter returns to the pairing
mode.
Tip
• If the Bluetooth adapter fails to pair with a Bluetooth
device, the Bluetooth adapter exits the pairing mode
in 2 minutes, and the LED light becomes dim.You can
press to return to pairing mode.
LED
indications
Description
Solid blue The Bluetooth adapter and your
Bluetooth-enabled device are
connected.
Flashing
blue
The Bluetooth adapter is waiting
to be paired with a Bluetooth-
enabled device.
Dim light The Bluetooth adapter is neither
in connection with a Bluetooth
device nor in the pairing mode.
Play from Bluetooth-enabled
devices
Note
• The effective operating range between the Bluetooth
adapter and the paired device is approximately 10
meters(30feet).
• Keep this Bluetooth adapter away from other electronic
devices that may cause interference.
• Compatibility with all Bluetooth devices is not
guaranteed.
• Make sure that the Bluetooth adapter is connected to
the powered Hi-Fi system correctly.
• Make sure that your Hi-Fi system is in Audio-in or
line-in mode.
1 On your Bluetooth device, turn on
Bluetooth function and search for
Bluetooth devices (refer to the device's
usermanual).
2 When [PhilipsBT] (Philips Bluetooth
adapter)isdisplayedonyourdevice,
select it to start pairing and connection. If
necessary, enter default password “0000”.
» If connection is successful, the
Bluetooth indicator becomes solid
blue.
3 Play audio on your device.
» Audio streams from your device to
your Hi-Fi system.
Note
• If your Bluetooth device has been paired with AEA2000
before,youjustneedtondout[PhilipsBT] on your
Bluetooth menu, then start the connection.
• This Bluetooth adaptor can memorize up to 8
previously paired devices.
To disconnect the Bluetooth-enabled device:
• Press again;
• Tap [PhilipsBT] on the Bluetooth menu
again;
• Deactivate Bluetooth function on your
device; or
• Move the device beyond the
communication range.
To connect another Bluetooth device:
1 Disconnect the previously connected
device.
2 Pair with your selected Bluetooth device.
To clear pairing history in the Bluetooth
adapter:
Press and hold for 7 seconds.
» The Bluetooth indicator stays in solid blue
for 2 seconds, then returns to the previous
status.

6EN
4 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Output Voltage 1000 mV RMS
Signal to Noise Ratio >62dBA
Total Harmonic Distortion < 2 %
Bluetooth
Standard Bluetooth Standard Version
2.1+EDR
Frequency Band 2.402~2.480 GHzISM Band
Range 10m(freespace)
General information
AC Power Model: AS030-090-
EI033(Philips);
Input: 100-240 V ~,
50/60Hz,0.15A;
Output: 9 V 0.33 A
Operation Power
Consumption < 3 W
Dimensions - Main Unit
(WxHxD) 74 x 28 x 72 mm
Weight - Main Unit 0.04 kg
5 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support).Whenyoucontact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•Make sure that the AC power adapter is
connected properly.
•Make sure that there is power at the AC
outlet.
No sound from your Hi-Fi system
•Check if the Hi-Fi system is connected to
power.
•Make sure that the system is connected
with the Bluetooth adapter properly.
•Make sure that the Bluetooth wireless
connection is successful.
•Adjust the volume of your system and
Bluetooth device.
•Make sure that the Hi-Fi system is in
Audio-in or line-in mode.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the
device closer to the Bluetooth adaptor or
remove any obstacle between the device
and the adaptor.

7EN
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•The adapter is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
•The Bluetooth-enabled device might be
cleared from pairing history. Follow steps
below to re-pair:
1)Unplugthepowerfortheproduct
(AEA200)andthenre-connect.
2)Select‘ignorethisdevice’onyour
Bluetooth-enableddevice’ssetupmenu,
then select [PhilipsBT] for pairing again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to the Bluetooth adapter or
remove any obstacle between the device
and the adapter.
•For some devices, the Bluetooth
connection may be deactivated
automatically as a power-saving feature.
This does not indicate any malfunction of
the system.
6 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
GibsonInnovationsmayvoidtheuser’s
authority to operate the equipment.
Hereby, Gibson Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions of
Directive1999/5/EC.YoucanndtheDeclaration
of Conformity on www.philips.com/support.
Recycling
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When you see the crossed-out wheel bin
symbol attached to a product, it means the
product is covered by the European Directive
2002/96/EC:
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products.The correct
disposal of your old product helps prevent
potentially negative consequences on the
environment and human health.

8EN
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separateintothreematerials:cardboard(box),
polystyrenefoam(buffer)andpolyethylene
(bags,protectivefoamsheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
The Bluetooth®word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Philips is
under license.

2016 © Gibson Innovations Limited.All rights reserved.
This product has been manufactured by, and is sold under the
responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd.
is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used under license from Koninklijke
Philips N.V.
AEA2000_05_UM_V4.0