Philips AZ1066/93 User manual

Register your product and get support at
www.philips.com/welcome
AZ1066
EN User manual

3
English
EN
Contents
1 Important 5
2 Your CD Soundmachine 6
Introduction 6
What’s in the box 6
Overview of the main unit 7
3 Get started 10
Install batteries 10
Connect AC power 11
4 Play a CD 12
Select a track 13
Find a passage within a track 13
Program play sequence 13
Repeat play 14
Shuffle play 15
5 Play cassette recorder 16
Find a passage within a tape 16
Record from CD 16
Record from radio 17
6 Use Learning function 18
Listen to the recorded content repeatedly 18
Record your voice 19
Compare your voice with the original recording 19
Exit Learning mode 19

4EN
7 Listen to radio 20
8 Troubleshooting 21
9 Product information 23
10 Notice 24
Recycling 25

5
English
1 Important
Read and understand all instructions before you use the•
apparatus. If damage is caused by failure to follow instructions,
the warranty does not apply.
Never remove the casing of this apparatus.•
Never look into the laser beam inside this apparatus.•
Use of controls or adjustments or performance of procedures•
other than herein may result in hazardous radiation exposure
or other unsafe operation.
Never place any objects other than discs into the disc tray/•
slot.
To avoid short circuit, do not expose the apparatus, remote•
control or remote control batteries to rain or water.
Ensure that you always have easy access to the power cord,•
plug or adaptor to disconnect this apparatus from the power.
The apparatus shall not be exposed to dripping or splashing.•
Do not place any sources of danger on the apparatus (e.g. liquid•
filled objects, lighted candles).
Battery usage CAUTION – To prevent battery leakage which•
may result in bodily injury, property damage, or damage to
the unit:
Install all batteries correctly, + and - as marked on the•
unit.
Do not mix batteries (old and new or carbon and•
alkaline, etc.).
Remove batteries when the unit is not used for a long time.•
EN

6
2 Your CD Soundmachine
Congratulations on your purchase, and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
Introduction
With the CD Soundmachine you can
play audio disc•
play cassette tape•
listen to FM/MW radio•
recording music/voice to tape.•
You can also enhance the sound with the Dynamic Bass Boost•
feature.
What’s in the box
Check and identify the contents of the package:
CD Soundmachine•
AC power cord•
User Manual•
EN

7
English
Overview of the main unit
aSource selector: CD, TUNER, MP3 LINK,TAPE/OFF
Select source: CD, radio, MP3 or Tape•
Switch to standby mode•
bVOLUME
㓪⿟ ῵ᓣ
abc d fegh
i
j
k
EN

8
Adjust volume level•
cDBB
Turn the bass enhancement on/off•
dCassette recorder buttons
•
Pause play or record
• /
Stop cassette play or record
Open the cassette holder
•
Fast forward
•
Fast rewind
•
Start cassette play
•
Start cassette record
eLIFT TO OPEN
Open/Close the CD compartment•
fMP3 LINK
Socket for audio input•
gTUNING +/-
Tune to radio stations•
hFM/MW/
Select radio band: FM or MW•
Switch to Repeat mode.•
iCD buttons
•
EN

9
English
Stop CD play
Erase a CD program
• /
Select the previous/next track
Fast search backward/forward within the current track
•
Start or pause CD play
•
Select a play mode: REPEAT or SHUFFLE
•
Program tracks and browse the program
jRepeat function buttons
•
Repeat the previous 120 seconds’ CD or tape content
•
Record voice
•
Play the recorded voice
Play both the recorded voice and repeat content for
comparison
•
Cancel repeat and start playing CD or tape
kBuilt-in microphone
EN

10
3 Get started
Caution
Use the controls only as stated in this user manual.•
Always follow the instructions in this chapter in sequence.•
If you contact Philips, you will be asked for the model and serial
number of your player.The model number and serial number are on
the bottom of your player.Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Install batteries
1Open the battery compartment.
2Insert 6 x 1.5V R14/UM-2/C-cell batteries with correct
polarity (+/-) as indicated.
3Close the battery compartment.
Tip
If you want to save battery life, use the supplied power cord.•
6 x 1.5V R-14/UM-2/C-cell
EN

11
English
Connect AC power
Warning
Risk of product damage! Ensure that the power supply voltage•
corresponds to the voltage printed on the back or the underside of
the product.
Risk of electric shock! When you unplug the AC adaptor, always pull
•
the plug from the socket. Never pull the cord.
Note
Install the unit near the power supply socket and where the AC•
power plug can be easily reached.
1Connect the power cord to the AC MAINS~ socket on the
CD Soundmachine and to the power supply socket.
To switch the CD Soundmachine off completely,•
disconnect the power cord from the power supply
socket.
Tip
To save energy: After use, set the source selector to• OFF. To turn
off the CD Soundmachine completely, disconnect the plug from the
power supply socket.
EN

12
4 Play a CD
Note
You cannot play CDs encoded with copyright protection•
technologies.
You can play commercially available audio:
CDs•
CD-Recordables (CD-R)•
CD-Rewritables (CD-RW)•
1Switch the source selector to CD.
2Lift the lid of the CD compartment.
3Insert a CD with the printed side facing up.
4Close the CD lid gently.
The total number of tracks is displayed.»
5Press to start play.
[»] is displayed.
To pause CD play, press• .
To resume CD play, press• again.
To stop CD play, press• .
EN

13
English
Select a track
1During play, press /to select a track.
Find a passage within a track
1During play, press and hold /.
The CD is played at high speed and with reduced volume.»
2Release /to resume normal play.
Tip
When search reaches the end of the last track, the CD stops.•
Program play sequence
You can store up to 20 tracks in the desired sequence.
1In stop mode, press to start to program play sequence.
[PROG] and [00] are displayed.»
2Press /to select a track.
3Press to store the track.
4Repeat steps 2 to 3 to select and store all tracks.
When all 20 tracks are stored, no more tracks can be»
selected and the display
shows [---].
PROG
EN

14
5To play program, press .
In stop mode, press• repeatedly to browse stored
tracks.
To cancel program, press• twice.
Tip
When program play stops, the CD Soundmachine returns to normal•
play. To play program again, repeat steps 1 to 5.
Repeat play
You can repeat a track, a disc, or a program.
• [] – plays the current track continuously
• [ALL] – repeats the entire CD/program
1During play, press repeatedly until the display shows
the repeat icon.
Repeat one track.•
Repeat the entire CD.•
To stop repeat play, press• repeatedly until the repeat
icon is no longer displayed.
ALL
EN

15
English
Shuffle play
You can play all tracks in random order.
1During play, press repeatedly until the display shows
the shuffle icon.
To stop shuffle play, press• again.
EN

16
5 Play cassette recorder
1Switch the source selector to TAPE/OFF.
2Press to open the cassette holder.
3Insert a cassette tape with the full reel on right side, and then
close the cassette holder.
4Press to start play.
To pause play, press• .
To stop the play, press• .
Find a passage within a tape
1During stop, press /to search for a desired passage in a tape.
2To stop fast search, press .
Record from CD
1Switch the source selector to CD.
2Insert a CD with the printed side facing up.
3If you want to record tracks in the desired sequence, program
the desired tracks. (See ‘Program play sequence’ section)
4Press to open the cassette holder.
5Insert a blank cassette, and close the holder.
6Press to start to record.
To pause, press• .
To resume, press• again.
To stop, press• .
EN

17
English
Record from radio
1Switch the source selector to TUNER.
2Tune to a radio station.
3Press to open the cassette holder.
4Insert a blank cassette with the full reel on the right side, then
close the holder.
5Press to start to record.
To pause, press• .
To resume, press• again.
To stop, press• .
EN

18
6 Use Learning function
When you are listening to CD or tape, you can let the CD
soundmachine to play repeatedly the last played 120 seconds’
content.You can also record down your own voice for comparison.
This is especially useful for language learning or whatever.
1Switch the source selector to CD or TAPE/OFF.
2Set FM/MW/switch to mode.
3Press or to start play.
The red light under the»button illuminates.
The CD soundmachine starts recording what is played»
onto its built-in memory. Maximum recording length is 120
seconds.
Listen to the recorded content repeatedly
1Press .
The red light under»button illuminates.
CD or Tape stop playing. It plays the recorded content»
repeatedly.
2To pause, press .
To resume, press• again.
Tip
if you want the CD soundmachine to start record on other position,•
play the source at the position you want and then press to start
the recording again and replace the previous recording.
EN

19
English
Record your voice
Note
To ensure recording quality, keep the distance between you and the•
microphone within 30cm.
The maximum recording length is also 120 seconds.
•
1Press .
The red light under the»button illuminates.
2Speak/sing to the built-in microphone which is located on the
top side of the left speaker.
To erase what’s recorded, press• again.
Speak/sing to the microphone to record new content.
Compare your voice with the original recording
1Press briefly.
The red light under the»button illuminates. It plays the
record of your voice repeatedly.
To pause, press». Press again to resume repeatedly
playing.
2Press for more than 3 seconds.
It plays both the recorded voice and the original recording»
repeatedly.
Exit Learning mode
To stop Repeat, recording or comparing, press .
CD or Tape resume playing.»
To exit Learning mode
1Switch FM/MW / to FM or MW position.
EN

20
7 Listen to radio
1Switch the source selector to TUNER.
2Switch BAND to FM or MW.
3Turn TUNING +/- to find a station.
Tip
To improve FM reception, you can extend, incline or turn the telescopic antenna for best•
reception.
To improve MW reception, turn the CD Soundmachine to face a different direction.•
EN

21
English
8 Troubleshooting
Warning
Never remove the casing of this apparatus.•
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the <brand> web site (www.<brand>.com/
support), or contact <brand> (see Contact information).When you
contact <brand>, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
Ensure that the power cord is connected securely.•
Ensure that there is power at the power supply socket.•
Ensure that the batteries are installed correctly.•
No sound
Adjust the volume.•
Check if it’s in Repeat mode.•
Ensure that the track played is of a compatible format.•
Display does not function properly./No reaction to operation of
any of the controls.
1Disconnect the AC power cord.
2Connect the AC power cord after a few seconds.
Cannot play disc
Ensure that the disc label is inserted with the printed side facing up.•
Wipe the disc with fibre cleaning cloth from the centre to the edge in a•
straight line.
This disc may be defective. Play another disc.•
Ensure that the CD is a finalised CD/CD-R/CD-RW.•
Ensure that the laser lens is clean.•
Ensure that the CD is not encoded with copyright protection technologies.•
EN