Philips HD7630/01 User manual

ServiceManual
Philips Domestic Appliances and Personal Care
Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification
Coffee maker Essence II
HD7630/01
4322 277 00950
03/08
This product meets the requirements regard-
ing interference suppression on radio and TV.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as officially laid down at this
moment.
SAP coding HD7630/01
PRODUCT INFORMATION
Voltage : 100 V, 120 V, 220 - 240 V
Frequency : 50 - 60 Hz
Power consumption : 1400 W
Coloursetting : White / vapour dusk
Contents : 1200 cc
Colour code identification:
To determine which service manual is suitable for the
appliance that has to repaired please check the following.
Look at the type plate identification from the appliance on
the second row.
The first sledge number is the colour code for that
appliance. ( /99 )
(for example below the colour code is /01)
Example of a type plate:
TYPE HD7624
/01 /A
…
…
At the service manual heading, the type and colour code
are also mentioned for example HD7624/01
/01 is the colour code.
Descaling:
Regular de-scaling will prolong the life of your appliance and
will guarantee optimal brewing results.
Follow below steps to de-scale the appliance.
1. Fill the water tank with white vinegar.
2. Let the appliance complete two runs.
3. Let the appliance complete two more flushing cycles
with clean water to rinse away all vinegar.
If the above procedure does not restore the function, then
switch off the coffee maker when the acid passed through
during appr. 3 min.
Keep the appliance in this condition overnight and continue
the steps see above procedure.
Element
1400 W
Thermostat
Thermal
fuse
Power
Module
Clock
Timer
Module
L
N

Repair instruction for replacing clock timer panel- or power module:
If the clock timer panel has to be replaced please follow the next steps:
1. Remove bottom base plate.
2. Pull the complete pump unit (including hose pieces) downwards until the
hose pieces are loosened from the two water tank pipes. (hose pieces and
wires must stay connected to the pump).
3. Remove the Foot (item 18), now you can get to the power module.
4. Disconnect the clock timer cable by pulling the 4 pins connector from the
power module.
5. Remove the complete top cover including the water tank. (see picture 1)
6. Now it is possible to get to the clock timer panel.
7. Replace the clock timer panel.
8. Connect the clock timer cable on the power module again.
9. Place the Foot (item 18) back.
10. Insert the complete top cover assy including plastic tank gently back into the housing.
11. Take the pump unit and attach the hose pieces to the water tank pipes of the previously inserted
tank. (be sure that the hose pieces are well attached to the water tank pipes, otherwise leakage problems can occur)
12. Assemble the base plate again.
To replace only the power module follow the above steps 1, 2, 3, 4 and replace the power module and the connected wires (8).
After replacing the power module follow the above steps 9, 11 and 12 to complete the operation.
Transportation lock:
To prevent damaging the dosing/weighting system in case the appliance has to
be shipped/transported, It is possible to order a special transportation lock.
For the position of the transportation lock see picture 2.
The code number transportation lock: 4222 247 59510
Commercial trade number jug + lid: HD7965/01 (vapour dusk)
picture 1
4222 247 59510
picture 2

1
2
3
4
5
10
9
6
7
8
12
11
13
14
Pos Description Service code
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Tank lid assy vapour dusk
Strenght select button
Spoutpipe
Tare-adjuster
Frame ADS printed
ADS spring
Spring support
Sealing ring tank
Permanent filter
Filterholder
Dripstop ring
Dripstop assy
Lid vapour dusk
Jug vapour dusk
4222 259 03710
4222 247 36500
4222 247 35580
4222 247 35620
4222 259 02330
4222 240 06350
4222 247 35660
4222 247 06880
4222 247 36680
4222 247 35700
4222 247 06630
4222 259 05070
4222 247 35440
8827 965 01010
HD7630/01

28
27
18
17
21
20
22
23
25
26
24
19
15
16
Pos Description Service code
15
16
17
18
19
20
21
22
23
24
25
26
27
28
ADS window
Clock timer panel module
Cap vapour dusk
Foot white
Power PCB 230 V 50 Hz
Power PCB 120 V 60 Hz
Power PCB 100 V 50/60 Hz
Valve + hose piece assy
Hose piece
Hotplate
Hotplate ring
Pump assy 230 V
Pump assy 100 V
Pump assy 120 V
Wire spring thin
Wirespring
Baseplate vapour dusk
Foot, rubber
4222 259 03890
4222 259 03620
4222 247 35930
4222 247 35940
4222 259 03630
4222 259 04120
4222 259 04090
4222 247 20470
4222 247 06440
4222 240 06260
4222 247 50300
4222 259 13760
4222 259 13740
4222 259 13730
4222 245 71650
4222 245 71470
4222 259 05240
4213 247 05250
= changed