Philips SE4301S/69 User manual

3%?)&5?%.BOOK0AGE&RIDAY$ECEMBER0-
5SERMANUAL
%.

ΣΕ435_ΙΦΥ_ΕΝ.βοοκ Παγε 3 Φριδαψ, ∆εχεµβερ 16, 2005 1:15 ΠΜ

3
EN
4 Important Information
4 For your safety
4 Installation requirements
4 Need Help?
5 What’s in the box?
6YourSE430
6 Overview of the handset
9 Overview of the base station
9 Main features of your SE430
11 Connect
12 Install
17 Call
21 Phonebook
25 Call log
27 SMS
34 Clock & Alarm
35 Personal Settings
39 Advanced Settings
45 Network Services
48 Troubleshooting
50 Information
51 Index
Contents
SE430_IFU_EN.book Page 3 Wednesday, September 20, 2006 2:14 PM

4
EN Important Information
For your safety
This equipment is not designed to make emergency calls in the event of a power failure. Alternative
arrangements should be made for access to emergency calls.
To avoid damage or malfunction:
- Do not allow the product to come into contact with liquid.
- Do not open it as you could be exposed to high voltages.
- Never use any battery type other than the one supplied.
- Do not expose the phone to excessive heat caused by heating equipment or direct sunlight.
- Do not drop your phone or allow objects to fall on your phone.
- Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the set.
- Active mobile phones in the vicinity may cause interference.
About operating and storage temperatures
- Operate in a place where temperature is always between 0 and 35º C (32 to 95º F).
- Store in a place where temperature is always between -20 and 45º C (-4 to 113º F).
- Battery life may be shortened in low temperature conditions.
Installation requirements
This product requires an electrical supply of 220-240 volts, alternating monophased power, excluding IT
installations defined in standard EN 60-950. In case of power failure, the communication can be lost.
The electrical network is classified as hazardous according to criteria in the standard EN 60-950. The only way
to power down this product is to unplug the power supply unit from the electrical outlet. Ensure the electrical
outlet is located close to the apparatus and is always easily accessible.
The voltage on the network is classified as TNV-3 (Telecommunication Network Voltages), as defined in the
standard EN 60-950.
Need Help?
For more information on troubleshooting and FAQs:
Troubleshooting:page 48
Online Help
www.p4c.philips.com
SE430_IFU_EN.book Page 4 Wednesday, September 20, 2006 2:14 PM

5
EN
What’s in the box?
The following accessories are included with your SE430:
Power supply for
base station
Battery door
Line cord
User Guide Warranty card
The line adaptor may not be attached to the line cord. In this case, you have to connect the line
adaptor to the line cord first before plugging the line cord to the line socket.
In multihandset packs, you will find one or more additional handsets, chargers with power supply units
and additional rechargeable batteries.
Handset Base station
Quick Start
Guide
2 AAA
rechargeable
batteries
SE430_IFU_EN.book Page 5 Wednesday, September 20, 2006 2:14 PM

6
EN Your SE430
Overview of the handset
LCD Screen
Menu key/Left Soft key
Talk key
Keypad lock key
.
Up/Down Navigation keys
Earpiece
Right soft key/ Redial list
key/ Mute key
Hang-up key
Alphanumeric keypad
Case key/ Pause key/
Ringer off key
Intercom key
Loudspeaker key
Microphone
Event LED
SE430_IFU_EN.book Page 6 Wednesday, September 20, 2006 2:14 PM

7
EN
Your SE430
Handset keys
Soft keys
Press To
mEnter the main menu from stand-by mode.
Select the function displayed on the handset screen directly above it.
>Go to redial list from stand-by mode.
Select the function displayed on the handset screen directly above it.
Activate mute function during a call.
rAnswer an incoming external or internal call.
Insert R for operator services when on the line.
e
Hang up a call.
Long press from menu browsing to return to stand-by mode, short press to return to
previous menu.
Long press in stand-by mode to switch off the handset, short press to switch on the handset
again.
u
Access call log from stand-by mode.
Scroll up a menu list or go to the previous phonebook or call log record.
Increase earpiece volume during a call.
Go to the previous character in editing mode.
d
Access phonebook from stand-by mode.
Scroll down a menu list or go to the next phonebook or call log record.
Decrease earpiece volume during a call.
Go to the next character in editing mode.
cInitiate an internal call.
vAnswer an incoming call in handsfree mode.
Activate and deactivate the loudspeaker* during a call.
#
Dial # in stand-by mode.
Long press to mute the ringer in stand-by mode.
Insert a pause in dialling mode.
Switch between upper and lower case in editing mode.
*Dial * in stand-by mode.
Long press to activate and deactivate keypad lock.
OK Short press to confirm your selection.
BACK Short press from menu browsing to return to the previous menu.
*WARNING Handsfree activation can suddenly increase the volume in the earpiece to a very high
level. Make sure the handset is not too close to your ear.
SE430_IFU_EN.book Page 7 Wednesday, September 20, 2006 2:14 PM

8
EN Your SE430
Display icons & symbols
In stand-by mode, several icons & symbols may be displayed on the handset.
The handset is registered and within range of the base station. It blinks when the handset is
out of range or is searching for a base.
Battery symbol indicating 3 different battery levels.
The ringer volume is set to zero.
There is an external or internal incoming call, a call is connected or a call is held.
When browsing phonebook list.
The loudspeaker is ON.
There is a missed call or missed call records are being reviewed.
Alarm clock is activated.
Blinks when new SMS or voicemail messages are received and not read yet. Steady when
there are received SMS messages in the SMS box.
SE430_IFU_EN.book Page 8 Wednesday, September 20, 2006 2:14 PM

9
EN
Your SE430
Overview of the base station
Main features of your SE430
The following is an overview of the menu options that are available in your SE430. For detailed explanation of
the menu options, please refer to the corresponding sections in this User Guide.
Menu To Page
SMS Setup, write/read SMS, etc. 27
CLOCK & ALARM Set Date and time, Alarm and Alarm tone. 34
PHONEBOOK Add, edit and manage phonebook entries. 21
PERSONAL SET Set Handset tone, Handset name, Auto Pick-up/Hang-up,
Languages, Babysit mode and Backlight.
35
ADVANCED SET Set Recall time, Dial mode, Call barring, Baby call, Register/
Unregister handset, Change PIN, Reset phone, Auto prefix,
Country setting and Conference mode.
39
NET. SERVICE Set Call forwarding, Voice Mail, Call back and Caller ID. 45
Paging key
SIM card tray
SE430_IFU_EN.book Page 9 Wednesday, September 20, 2006 2:14 PM

10
EN Your SE430
Menu navigation
The basic steps of navigating through the menus and options are as follows:
Task Action Illustration
• Enter main menu/menu
options
Press mkey
• Go to a specific menu/option
• Confirm your selection
1) Press :key to scroll to your
desired menu/option
2) Select OK by pressing the key
directly below it (left soft key m)
In this example, the alarm is Off.
• To change your selection.
• To confirm your selection.
• Return to previous menu
level or stand-by screen
1) Press :to scroll to your desired
option
2) Select OK by pressing the key
directly below it (left soft key m )
3) Select BACK by pressing the key
directly below it (right soft key >)
PHILIPS

1
08-08 18:00
m>
:
Main Menu
Clock & Alarm

m>
:
1
2
Alarm

Off
m>
:
213
SE430_IFU_EN.book Page 10 Wednesday, September 20, 2006 2:14 PM