Philips NORELCO AT895 User manual

AT895
AT875
AT830
Rechargeable Cordless
Tripleheader Razor
Always here to help you Question?
Contact
Philips
Norelco
Question?
Contact
Philips
Norelco
Register your product and get support at
www.norelco.com/register

2

ENGLISH 4
AT895/AT875/AT830
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that Philips
Norelco offers, register your product at
www.norelco.com/register

IMPORTANT SAFETY
INSTRUCTIONS
When using an electric appliance, basic precautions should always
be followed, including the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
1. Do not reach for a corded charging stand that has fallen into
water. Unplug immediately.
2. Power plug and the accessories connected to it are not for
immersion or for use in shower.
3. Do not use an extension cord with this appliance.
4. Always unplug this charging stand or razor from the electrical
outlet immediately after use, except when razor is (re)charging.
5. Unplug and remove power supply cord from charging stand or
razor before cleaning.
6. The batteries used in this device may present a fire or chemical
burn hazard if mistreated. Do not disassemble, heat above
100ºC (212ºF) or incinerate.
WARNING
To reduce the risk of burns, fire, electric shock, or injury
to persons:
1. Close supervision is necessary when this razor is used by, on,
or near children or invalids.
2. Use this razor for its intended household use as described in
this manual. Do not use attachments not recommended by
Philips Electronics North America Corporation.
3. Never operate this razor/charging stand if it has a damaged
cord or charging plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water while plugged in.
For assistance call 1-800-243-3050.
ENGLISH
4

4. Keep the razor, cord, charging stand and charging plug away
from heated surfaces.
5. Never drop or insert any object into any opening.
6. Do not charge or plug in razor/charging stand outdoors or
operate where aerosol (spray) products are being used or
where oxygen is being administered.
7. Do not use this razor with a damaged or broken comb, as
facial injury may occur.
8. Always put razor in charging stand first, attach cord to charging
stand, then plug into outlet. Be certain plug is inserted firmly
into
charging stand or razor up to mark indicated on plug. To
disconnect, remove charging plug from outlet.
9. Never put the razor/charging stand in direct sunlight or store
at a temperature above 140°F (60ºC).
10.Keep the cord/charging stand dry at all times. Do not handle
with wet hands. Do not store in a damp environment.
11.To prevent possible damage to the cord, do not wrap cord
around the razor or charging stand.
12.Only use the power plug and other accessories supplied with
the razor.
SAVE THESE
INSTRUCTIONS
IMPORTANT: The power plug contains a transformer. Do not
cut off the power plug to replace it with another plug, as this will
cause a hazardous condition.
ENGLISH 5

ENGLISH
6
45 - DAY MONEY-BACK GUARANTEE
To enjoy the closest and most comfortable shave from your new Philips Norelco
Men’s Razor, the razor should be used exclusively for 3 weeks.This allows your
hair and skin enough time to adapt to the Philips Norelco Shaving System. If, after
that period of time, you are not fully satisfied with your Philips Norelco Men’s
Razor, send the product back along with dated sales receipt and we’ll refund you
the full purchase price. The razor must be shipped prepaid by insured mail,
insurance prepaid, have the original sales receipt, indicating purchase
price, the date of purchase, and the money-back guarantee return
authorization form enclosed.We cannot be responsible for lost mail. The
razor must be postmarked no later than 45 days from the date of purchase. Philips
Norelco reserves the right to verify the purchase price of the razor and limit
refunds not to exceed suggested retail price.
To obtain money-back guarantee return authorization form,
call 1-800-243-3050 for assistance. Delivery of refund check will
occur 6–8 weeks AFTER receipt of refund product.

7
Table of Contents
Features........................................................ 8-9
LED Multi-Purpose Display .................10-11
Before First Use ...........................................11
Charging ...................................................11-13
Recharging .....................................................14
Quick Charge ...............................................14
Put It To The Test & Shaving Tips........14-15
How to Shave
With An Electric Razor........................15-17
Trimming ........................................................17
Cleaning....................................................18-22
Replacing the Razor Heads .................23-24
Storage............................................................25
Assistance ......................................................25
Battery Removal ....................................26-27
Accessories ...................................................28
Warranty........................................................29
ENGLISH

8ENGLISH
Features
Pivoting Shaving Unit
Lift & Cut System
Razor Head
Assembly
Protective Cap
Individually
Floating Heads
Razor Head
Release Button
• Hair Chamber
captures shaven hair
Electronic
On/Off Button
Razor Head
Replacement Indicator
LED Charge
Indicators
• Battery Charge,
Full & Low Indicators
• Quick Charge Indicator

9
ENGLISH
How the Unique Philips Norelco Lift and Cut
Shaving System Makes Close Comfortable:
Groove channels
beard closer to
cutting system
Lifter raises hair Slots to cut long
hairs Holes to cut short
hairs even closer
Pop-up Trimmer
Automatic
Worldwide Voltage
100V to 240V AC
Cleaning Brush
Travel Pouch
(AT895/AT875)
Charging Stand
(AT895/AT875)
Rechargeable -
1-hour Full Charge
for up to 50 minutes
cordless use
Cordless - To shave
without a cord
Full 2-Year Warranty
45-Day Money-Back
Guarantee

10 ENGLISH
LED Multi-Purpose Display
The display provides the following information:
◗Charging Indicator
C-When the razor is charging, the white battery
symbol blinks.
◗Full Charge Indicator
C-When the battery is fully charged, the white
battery symbol lights up continuously. After
approximately 30 minutes the battery symbol
goes off to save energy.
◗Low Battery Indicator
C -When the battery is almost empty (5 or less
shaving minutes left), the orange battery symbol
blinks.When you turn the razor OFF the orange
battery symbol continues to blink for a few
seconds.
CwQuick Charge Indicator
-When you charge the empty battery, the
battery symbol and blinks white and orange.
After approximately 3 minutes, the battery
symbol continues to blink white.
- The razor now contains enough energy for a
5-minute shave.
CwRazor Head Replacement Indicator
-Once a year, depending on your shaving behavior,
the razor head replacement symbol will light up
orange continuously, as a reminder to replace the
razor heads.

11
ENGLISH
Before First Use
wCharge the razor before you start using
it (see ‘Charging’). Make sure the razor is
switched off before you start charging it.
Important
wOnly use the power cord provided to charge
the razor.
wThe power plug transforms 100-240V AC to
less than 24V DC.
Charging
wCharging or recharging at temperatures below
40ºF or higher than 95ºF adversely affects
lifetime of batteries.
wIf the razor is subjected to a major change
in temperature, pressure or humidity, let it
acclimatize for 30 minutes before using.
wCharging or recharging requires one full hour.
wA fully charged razor has a cordless shaving
time of up to 50 minutes.
wWhen charging razor for the first time or
after a long period of non-use, charge until the
white battery symbol lights up continuously.
wDo not charge razor in a pouch.

12 ENGLISH
Charging with a Cord
C1Connect cord directly to razor and
connect the charging plug into any 100V to
240V AC outlet. Use only the power cord
provided.
w An adaptor plug may be necessary for
charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
The charging plug will automatically convert to
work on 100V to 240V AC systems.
C w The display on the razor will indicate razor is
charging.
2Charging and recharging requires a full 1
hour. A fully charged razor has a cordless
shaving time of up to 50 minutes.
C wWhen the battery is fully charged, the white
battery symbol lights up continuously.
After approximately 30 minutes, the battery
symbol goes out to save energy.

13
ENGLISH
Charging in Charging Stand
(AT895/AT875)
C wAlways place razor in stand in an upright
position making sure charging contacts in
bottom of stand fit into recess in bottom of
razor.
wAlways remove razor from stand by lifting
straight up. Do not tilt razor.
1Place razor in charging stand and connect
the small plug of cord to charging stand.
Connect the charging plug into any 100V
to 240V AC outlet. Use only the power
cord provided.
w An adaptor plug may be necessary for
charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
The charging plug will automatically convert to
work on 100V to 240V AC systems.
C w The display on the razor will indicate razor is
charging.
2Charging and recharging requires one full
hour. A fully charged razor has a cordless
shaving time of up to 50 minutes.
CwWhen the battery is fully charged, the white
battery symbol lights up continuously.
After approximately 30 minutes, the battery
symbol goes out to save energy.

14 ENGLISH
Recharging
1Recharging requires 1 hour.
Recharge when the battery symbol blinks orange.
Quick Charge
When you charge the empty battery, the
battery symbol blinks white and orange. After
approximately 3 minutes, the battery symbol
continues to blink white.The razor now contains
enough energy for a 5-minute shave.
Put It To The Test & Shaving Tips
w21 Day Trial and Conversion Process.It is a fact
that your skin and beard need time to adjust to
a new shaving system.
wUse your new razor exclusively for 3 weeks to
fully enjoy the closeness of a Philips Norelco
shave.
wAt first you may not get as close a shave as you
expect,or your face may even become slightly
irritated.This is normal since your beard and
skin will need time to adjust.Invest 3 weeks and
you’ll soon experience the full joy of your new
razor.
wStick with it! If you alternate shaving methods
during the adjustment period,it may make it
more difficult to adapt to the Philips Norelco
shaving system.

15
ENGLISH
wIf you are still not convinced after 21 days,
Philips Norelco will refund you the full
purchase price as long as the request is
received within 45 days of purchase.
HowTo Shave With An Electric Razor
C wThis symbol on the razor indicates that
the razor can be used in both the bath and
shower.
wThe razor will not operate while power cord
is connected to an electrical outlet.
wUse this razor for its intended household use
as described in this manual.
wShaving with a clean face gives the best results.
Shaving
C1Turn razor ON by pressing the on/off
button once. Shave against the direction of
beard growth using circular movements.
2Stretch your skin with your free hand so
blades can lift and cut whiskers. Gently
press razor to skin so the floating heads
can follow the contours of your face.
DO NOT press too hard.Too much
pressure can pinch the skin into the combs.
3Turn razor OFF by pressing the on/off
button once.

16 ENGLISH
4Clean the razor after each use (see
chapter ‘Cleaning’).
C5Put the Protective Cap on the razor to
protect razor heads.
Wet Shaving
You can also use the razor on a wet face with
shaving foam or gel.
C1Apply some water to your skin.
C2Apply shaving foam or gel to your skin.
3Rinse the shaving unit under the tap
to ensure that the shaving unit glides
smoothly over your skin.
4Press the on/off button once to switch on
the razor.
C5Move the shaving heads in circular
movements over your skin.
NOTE: Rinse the razor under the tap regularly to
ensure that it continues to glide smoothly over
your skin.

17
ENGLISH
6Turn razor OFF, dry your face and
thoroughly clean the razor after each use
(see chapter ‘Cleaning’).
NOTE: Make sure you rinse all foam or gel off the
razor.
C7When the razor is thoroughly dry, put the
Protective Cap on the razor to protect
heads.
Trimming
To groom sideburns and moustache:
1Turn razor ON.
C2Push down spring-release trimmer switch.
The trimmer can be activated while the razor is
running.
C 3Hold trimmer as shown and move in
downward strokes with gentle pressure.
C4Close trimmer by pressing trimmer down.
5Turn razor OFF.

ENGLISH
Cleaning
wAlways clean your razor after each use.
wAlways switch razor OFF, unplug and remove
power cord before cleaning.
wNever clean, remove or replace head
assembly while motor is on.
wDo not apply pressure to combs. Do not
touch razor heads with hard objects as this
may dent or damage precision-made slotted
combs.
wDo not use razor if combs are damaged or
broken. Facial injury may occur.
wDo not use compressed air, abrasives,
scourers or aggressive liquids such as gasoline
or acetone to clean the razor.
Cleaning the Shaving Unit
The razor heads may be quickly cleaned after
each use by rinsing with hot water: Water from
the tap should be on a hot setting, BUT BE
CAREFUL TO TEST WATER FIRST SO AS NOT
TO BURN OR SCALD HANDS.
wRegular cleaning guarantees better shaving
results.
wDo not immerse razor in water.
wWhile rinsing razor heads, water may drip
out of the base of razor.This is a normal
occurrence.
18

ENGLISH
1Always turn razor OFF, unplug from outlet
and remove power cord from razor.
C 2Press the Razor Head Release Button to
open the Razor Head Assembly.
C3Clean inside razor heads and hair chamber
by running under hot water.
C 4Clean outside of Razor Head Assembly by
running under hot water.
5Close the Razor Head Assembly and shake
off excess water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
6Open Razor Head Assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.
wIf you used foam or gel to shave, make sure to
rinse all of it off to prevent residue build-up
from clogging razor heads.
19

ENGLISH
wIf the shaving unit becomes detached from the
razor, you can easily reattach it.
wYou may also clean the hair chamber without
water by using the supplied brush.
Extra-thorough Cleaning Method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1Turn razor OFF, remove the charging plug
from the outlet and power cord from the
razor.
C2Press the Razor Head Release Button to
open the Razor Head Assembly.
C3Pull the shaving unit off the razor.
C4Turn the lock counterclockwise to unlock
(A) and remove the retaining frame (B).
20
A
B