Philips Norelco SW6700/91 User manual

SW6700
BC
Tripleheader shaver
© & ™ Lucaslm Ltd.
© Disney

English 4

IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
DANGER
To reduce the risk of electric shock:
-Do not reach for a corded product that has
fallen into water. Unplug immediately.
-The power plug and the accessories
connected to it are not for immersion or for
use in shower.
-Do not use an extension cord with this
product.
-Always unplug this product from the
electrical outlet immediately after use,
except when product is (re)charging.
-Unplug and remove power cord from the
product before cleaning.
-The batteries used in this product may
present a re or chemical burn hazard if
mistreated. Do not disassemble, heat above
100°C (212°F) or incinerate.
4English

WARNING
To reduce the risk of burns, re, electric
shock, or injury to persons:
-Close supervision is required when this
product is used by, on, or near children,
or persons with limited physical, sensory,
or mental capabilities or invalids.
-Use this product for its intended household
use as described in this manual. Do not use
attachments not recommended by Philips
North America LLC.
-Never operate this product if it has a
damaged power cord or charging plug,
if it is not working properly, if it has been
dropped or damaged, or dropped into
water while plugged in. For assistance call
1-800-243-3050.
-Keep the product, cord and charging plug
and any attachments away from heated
surfaces.
-Never drop or insert any object into any
opening.
-Do not use the adapter in or near a power
outlet that contains an electric air freshener
to prevent damage to the adapter.
-Do not charge, clean or plug in product
outdoors or operate where aerosol (spray)
products are being used or where oxygen is
being administered.
5
English

-Always check cutters and combs before
using the product. Do not use the product
if cutters or combs are damaged, as injury
may occur.
-Always attach plug to product rst, then
to outlet. Be certain plug is inserted rmly
into shaver up to mark indicated on plug.
To disconnect, turn shaver o then remove
power cord from outlet.
-Keep the power cord dry at all times. Do not
handle with wet hands.
-Never put the product in direct sunlight or
store at a temperature above 140°F (60°C).
-To prevent possible damage to the power
cord, do not wrap power cord around the
product.
-Do not attempt to open the product to
remove or replace the built-in rechargeable
battery.
-Only use the power cord and other
accessories supplied with the product.
SAVE THESE
INSTRUCTIONS
IMPORTANT: The power plug contains a
transformer. Do not cut o the power plug to
replace it with another plug as this will cause a
hazardous condition.
6English

Contents
Important safety instructions _________ 4
General description (Fig. 1)___________ 9
Introduction_______________________ 9
The display________________________ 10
Charging__________________________ 13
Using the shaver___________________ 15
Using the click-on attachment________ 19
Travel lock________________________ 20
Cleaning and maintenance___________ 21
Replacement______________________ 24
Storage___________________________ 26
Accessories_______________________ 27
Assistance________________________ 27
Disposal__________________________ 27
Full Two-Year Warranty_____________ 29
45-Day money-back guarantee _____ 30
7
English

8English
1
2
3
4
5
6
7
8
9
10
11
13
12
1

General description (Fig. 1)
1 SmartClick precision trimmer attachment
2 Shaving unit with hair chamber
3 On/o button
4 Turbo+ button
5 Replacement reminder
6 Cleaning reminder
7 Travel lock symbol
8 'Unplug for use' symbol
9 Battery charge indicator
10 Socket for small plug
11 Power plug
12 Small plug
13 Travel case
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benet from the support that Philips
Norelco oers, register your product at
www.norelco.com/register.
9
English

The display
Start-up sequence
When you press the on/o button for the very
rst time, all display indications light up in
sequence.
Charge the shaver before use.
Charging
Quick charge: When the battery is empty and
you connect the shaver to an electrical outlet,
the lights of the battery charge indicator light
up white one after the other repeatedly.
When the battery contains enough energy
for one shave, the bottom light of the battery
charge indicator starts ashing white slowly.
While the shaver continues to charge, rst the
bottom light of the battery charge indicator
ashes white and then lights up white
continuously. Then the second light ashes
and lights up continuously, and so on until the
shaver is fully charged.
10 English

Battery fully charged
Note: This shaver can only be used without
a cord.
When the battery is fully charged, all lights
of the battery charge indicator light up white
continuously.
Note: When you press the on/o button during
or after charging, the 'unplug for use' symbol
lights up to indicate that the shaver is still
connected to the power outlet.
Note: When the battery is full, the display
switches o automatically after 30 minutes.
Battery low
When the battery is almost empty, the bottom
light of the battery charge indicator ashes red.
Remaining battery charge
The remaining battery charge is shown by the
lights of the battery charge indicator that light
up continuously.
11
English

’Unplug for use’ reminder
The ‘unplug for use’ symbol ashes to remind
you to disconnect the shaver from the power
outlet before you can switch it on.
Cleaning reminder
Clean the shaver after every shave for
optimal performance (see 'Cleaning and
maintenance'). When you switch o the
shaver, the cleaning reminder ashes to
remind you to clean the shaver.
Travel lock
You can lock the shaver when you are going
to travel. The travel lock prevents the shaver
from being switched on by accident
(see 'Activating the travel lock').
12 English

Replacing shaving heads
For maximum shaving performance, replace
the shaving heads every year. The shaver is
equipped with a replacement reminder which
reminds you to replace the shaving heads.
The replacement reminder ashes to indicate
that you have to replace the shaving heads.
(see ‘Replacing the shaving heads’)
Note: After replacing the shaving heads,
you need to reset the replacement reminder
by pressing the on/o button for 7 seconds.
Turbo+ setting
This setting allows quicker and more powerful
shaving for easier removal of dense hair.
The Turbo+ button ashes irregularly to
indicate that Turbo+ setting is activated.
(see ‘Shaving with Turbo+ setting’)
Charging
-Charging, recharging, or using the product at
temperatures below 40°F (4.5°C) or higher
than 95°F (35°C) adversely aects lifespan
of the battery.
-Do not charge the shaver in a pouch or
travel case.
-The power plug transforms 100-240V AC to
less than 24V DC.
13
English

Charge the shaver before you use it for the rst
time and when the display indicates that the
battery is almost empty.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.
Note: You cannot use the shaver while it is
charging.
Charging with the power cord
1 Make sure the shaver is switched o.
2 Put the small plug in the shaver and
connect the power plug to any 100V to
240V AC outlet. Use only the power cord
provided.
The display of the shaver indicates the product
is charging.
3 After charging, remove the power plug from
the wall outlet and pull the small plug out of
the shaver.
Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use
an attachment plug adapter of the proper
conguration for power outlet.
14 English

Using the shaver
Always check the shaver and all accessories
before using. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with
one of the original type.
This symbol indicates that the shaver can be
used in the bath or shower.
-Use this shaver for its intended household
use as described in this manual.
-For hygienic reasons, the shaver should
only be used by one person.
-Trimming is easier when the skin and hair
are dry.
Note: This shaver can only be used without
a cord.
Put it to the test
-21 Day Trial and Conversion Process. It is a
fact that your skin and beard need time to
adjust to a new grooming system.
-Use your new shaver exclusively for 3 weeks
to fully enjoy the closeness of a Philips
Norelco shave.
-At rst you may not get as close a shave as
you expect, or your face may even become
slightly irritated. This is normal since your
beard and skin will need time to adjust.
Invest 3 weeks and you'll soon experience
the full joy of your new shaver.
15
English

-Stick with it! If you alternate shaving
methods during the adjustment period,
it may make it more dicult to adapt to
the Philips Norelco shaving system.
-If you are still not convinced after 21 days,
Philips Norelco will refund you the full
purchase price as long as the request is
received within 45 days of purchase.
Switching the shaver on and o
1 To switch the shaver on or o, press the
on/o button once.
2Then the replacement symbol lights up
continuously to indicate that the shaver is
ready for use.
Shaving
For the best results on skin comfort, pre-trim
your beard if you have not shaved for 3 days
or longer.
16 English

Dry shaving
1 Switch the shaver on.
2 Stretch your skin with your free hand so
blades can lift and cut whiskers. Gently
press shaver to skin so the oating heads
can follow the contours of your face
Note: Do not press too hard. Too much
pressure can pinch the skin into the combs.
3 Switch o and clean the shaver after each
use.The display lights up for a few seconds
to show the battery status.
Wet shaving
For a more comfortable shave, you can also
use this shaver on a wet face with shaving
foam or shaving gel.
1 Apply some water to your skin.
17
English

2 Apply shaving foam or shaving gel to
your skin.
3 Rinse the shaving unit under the tap to
ensure that the shaving unit glides smoothly
over your skin.
4 Switch the shaver on.
5 Move the shaving heads over your skin
in circular movements to catch all hairs
growing in dierent directions. Exert gentle
pressure for a close, comfortable shave.
Note: Do not press too hard, this can cause
skin irritation.
Note: Rinse the shaving unit regularly to
ensure that it continues to glide smoothly
over your skin.
6 Dry your face.
7 Switch o the shaver and clean it after
each use.
Note: Make sure that you rinse all foam or
shaving gel o the shaver.
18 English

Shaving with Turbo+ setting
1 Switch on the shaver.
2 Press the Turbo+ button once if you want to
shave areas with dense hair more quickly.
Note: The Turbo+ button ashes irregularly
to indicate that Turbo+ setting is activated.
3 Stretch your skin with your free hand so
blades can lift and cut whiskers. Gently
press shaver to skin so the oating heads
can follow the contours of your face.
Note: Do not press too hard. Too much
pressure can pinch the skin into the combs.
4 Turn o the Turbo+ mode by pressing the
Turbo+ button once.
Using the click-on attachment
Removing or attaching the click-on attachment
1 Make sure the shaver is switched o.
2 Pull the attachment straight o the shaver
Note: Do not twist the attachment while you
pull it o the shaver.
3 Insert the lug of the attachment into the slot
in the top of the shaver. Then press down
the attachment to attach it to the shaver
(‘click’).
19
English

Using the precision trimmer attachment
You can use the precision trimmer to groom
your beard, sideburns and moustache.
1 Attach the trimmer to the shaver ('click').
2 Switch on the shaver.
3 Hold the trimmer perpendicular to the skin
and move it downwards while exerting
gentle pressure.
4 Switch o and clean the trimmer after use.
Travel lock
You can lock the shaver when you are going to
travel. The travel lock prevents the shaver from
being switched on by accident.
Activating the travel lock
1 Press the on/o button for 3 seconds to
enter the travel lock mode.
2 While you activate the travel lock, the
indications on the display light up briey.
When the travel lock is activated, the travel
lock symbol ashes.
3 sec.
20 English