Philips PHILISHAVE COOL SKIN User manual

HQ6730, HQ6725, HQ6710, HQ6707
ENGLISH 4
DEUTSCH 18
ESPAÑOL 34
FRANÇAIS 49
ITALIANO 64
NEDERLANDS 79
PORTUGUÊS 94
TÜRKÇE 109

4
Introduction
The shaver comes with two different kinds of
NIVEA FOR MEN cartridges: Extra Fresh Shaving
Gel for a fresh sensation during and after shaving
and Moisturising Shaving Lotion for sensitive skin.
This gives you the opportunity to try them out and
discover which one suits your skin type best.
Extra Fresh Shaving Gel
NIVEA FOR MEN Extra Fresh Shaving Gel refreshes
the skin during shaving. It softens the beard hairs
and lets the shaver glide gently over the skin while
ensuring proper skin contact, resulting in a closer
shave. It leaves the skin feeling soft, supple and
revitalised.
The Extra Fresh Shaving Gel with advanced
moisturising agents helps protect the skin against
shaving burn, skin irritation and moisture loss. It
effectively improves the condition of the skin.
Moisturising Shaving Lotion
NIVEA FOR MEN Moisturising Shaving Lotion has
been specially formulated to meet the needs of
easily irritated and sensitive skin. It softens the beard
hairs and lets the shaver glide gently over the skin
while ensuring proper skin contact, resulting in a
closer and gentler shave. It leaves the skin feeling soft,
supple and healthy.
The Moisturising Shaving Lotion with advanced
moisturising agents helps protect sensitive skin
against shaving burn and moisture loss. It effectively
improves the condition of the skin by actively
moisturising the skin during shaving.
Important
Read these instructions for use carefully before using
the appliance and save them for future reference.
,
,
ENGLISH

Only use the powerplug and the charging stand
supplied.
The powerplug transforms 100-240 volts to a
safe low voltage of less than 24 volts.
The powerplug contains a transformer. Do not
cut off the powerplug to replace it with another
plug, as this will cause a hazardous situation.
Do not use a damaged powerplug or charging
stand.
If the powerplug or charging stand is damaged,
always have it replaced by one of the original
type in order to avoid a hazard.
Charge, store and use the appliance at a
temperature between 5 cC and 35 cC.
Make sure the powerplug does not get wet.
Never immerse the charging stand in water nor
rinse it under the tap.
Do not leave the shaver in the plugged-in
charging stand for more than 24 hours.
The appliance is watertight and can be cleaned
under the tap.
Be careful with hot water.Always check if the water
is not too hot, to prevent your hands from getting
burnt.
The appliance complies with the internationally
approved IEC safety regulations and can be safely
used in the bath or shower.
For the best shaving results, shaving gel/lotion
should be pumped up frequently.
Check if the gel and lotion supplied with the
appliance contain ingredients (see back of
cartridge) to which you are allergic before you
start using the appliance. Do not use the gel
and/or lotion if you are allergic to one or more
ingredients.
,
,
,
,
,
,
,
,
,
,
,
,
,
ENGLISH 5

Electromagnetic elds (EMF)
This Philips appliance complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and in accordance with the instructions
in this user manual, the appliance is safe to use
according to scientic evidence available today.
Charging
Charging takes approx. 8 hours.
Do not leave the shaver in the plugged-in charging
stand for more than 24 hours.
Charge indications
Charging
As soon as you start charging the empty shaver,
the green pilot light goes on.
Charging the appliance
Charge the appliance when the motor stops or
starts running slower.
1 Insert the small plug into the charging stand
and put the powerplug in the wall socket.
2 Place the shaver in the charging stand.
3 Press until you hear a click.
The shaver automatically switches off when it is
placed in the charging stand.
4 Remove the powerplug from the wall socket
and pull the small plug out of the charging
stand when the batteries have been fully
,
ENGLISH6

charged.You can then leave the appliance in the
charging stand.
Cordless shaving time
HQ6730 and HQ6710:
A fully charged shaver has a cordless shaving time of
up to 45 minutes.
HQ6725 and HQ6707:
A fully charged shaver has a cordless shaving time of
up to 40 minutes.
Cartridges
Cartridges with NIVEA FOR MEN shaving gel/lotion
are available in boxes containing ve cartridges and
one small plastic pump.
The NIVEA FOR MEN shaving gel/lotion in the
cartridges will keep for 32 months when stored at
temperatures between 0 cC and +40 cC.
Only use Philips NIVEA FOR MEN Cool Skin
(HQ170 and HQ171) cartridges.
One Philips NIVEA FOR MEN Cool Skin cartridge
contains enough gel/lotion for approx. 10 shaves.
Do not throw the pump away when you replace
an empty cartridge. You will need it for all ve
cartridges.
For hygienic reasons, we advise you to insert a
new pump when you start using a new set of ve
cartridges.
Remove the shaving gel/lotion cartridge from the
appliance when you are not going to use the shaver
for more than one week.
When you have run out of shaving gel/lotion
cartridges and you do not know where to buy them,
contact the Customer Care Centre in your country
(see ‘Guarantee & service’).
ENGLISH 7

Inserting cartridges
1 When you start using a new set of cartridges,
take the pump out of its bag and push it into
a cartridge until it locks into position with a
click.
2 Move the release slide downwards and open
the cover of the cartridge compartment.
3 Slide the cartridge with the pump into the
shaver. It only ts properly if the white side of
the pump is pointing upwards.
4 Close the cover (you will hear a click).
5 Press the yellow pump button a few times
until the NIVEA FOR MEN shaving gel/lotion
appears.The shaver is now ready for use.
Replacing cartridges
Do not throw the pump away when you replace
an empty cartridge.You will need it for the other
cartridges.
1 Move the release slide downwards and open
the cover of the cartridge compartment.
2 Remove the empty cartridge and pull out the
pump.
12 12
12 12
ENGLISH8

3 Push the pump into a new cartridge until it
locks into position with a click.
4 Slide the cartridge with the pump into the
shaver. It only ts properly if the white side of
the pump is pointing upwards. Close the cover.
Using the appliance
Shaving
1 Switch the shaver on by pressing the on/off
button once.
2 Press the yellow pump button to apply NIVEA
FOR MEN shaving gel/lotion to your skin. Move
the shaver over your skin, making both straight
and circular movements.
3 While shaving, press the pump button
frequently to apply more NIVEA FOR MEN
shaving gel/lotion so that the shaver keeps
gliding smoothly over your face.
When you have run out of shaving gel/lotion, you
can also use the shaver without it on a dry face.
Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
4 Switch the shaver off by pressing the on/off
button once.
,
,
ENGLISH 9

5 Clean the shaver (see chapter ‘Cleaning and
maintenance’).
Rinse the shaver after each shave. Remove the
cartridge if you are not going to use the appliance
for more than one week.
6 Put the protection cap on the shaver every
time you have used it, to prevent damage.
Trimming (HQ6730 and HQ6725 only)
For grooming sideburns and moustache.
1 Switch the shaver off.
Clean the shaver before you attach the trimmer (see
chapter ‘Cleaning and maintenance’).
2 Press the release button (1) and pull the
shaving unit off the shaver (2).
3 Tilt the trimmer slightly backwards and t it
onto the shaver.
4 Remove the trimmer by pressing the release
button again and pulling the trimmer off the
shaver.
5 Put the shaving unit back onto the shaver.
Cleaning and maintenance
Regular cleaning guarantees better shaving
performance.
To maintain optimal shaving performance and to
keep the shaver clean, you have to thoroughly rinse
the shaving unit and hair chamber with hot water
after every shave.
Be careful with hot water.Always check if the
water is not too hot, to prevent your hands from
getting burnt.
2
1
2
1
ENGLISH10

Shaving unit and hair chamber
1 Switch the shaver off.
2 Press the release button (1) and open the
shaving unit (2).
3 Clean the shaving unit and the hair chamber by
rinsing them under a hot tap for some time.
4 Rinse the outside of the shaving unit.
5 Make sure the inside of the shaving unit and
the hair chamber have been cleaned properly.
6 Close the shaving unit and shake off excess
water.
Never dry the shaving unit with a towel or tissue,
as this may damage the shaving heads.
7 Open the shaving unit again and leave it open
to let the appliance dry completely.
Charging stand
1 Unplug the charging stand.
2 Clean the charging stand with a moist cloth.
Trimmer (HQ6730 and HQ6725 only)
1 Clean the outside of the trimmer with the
brush supplied after every use.
2
1
2
1
22
ENGLISH 11

2 Open the trimmer to clean it on the inside.
3 Lubricate the trimmer teeth with a drop of
sewing machine oil every six months.
Storage
There are three ways to store the shaver:
1 you can store the shaver in the charging stand,
even when it is wet.
Always unplug the charging stand before storing
the wet or dry shaver in it.
2 you can store the shaver in the pouch supplied.
3 you can store the shaver by hanging it from
the hanging cord, which can be attached to the
appliance by means of the clip.This is the best
way to let the appliance dry.
Replacement
Replace the shaving heads every two years for
optimal shaving results.
Replace damaged or worn shaving heads with
HQ167 Philips Cool Skin shaving heads only.
1 Switch the shaver off.
OILOIL
ENGLISH12